A few intermittent control circuits of wipers are introduced here.
本文介绍一些刮水器间歇控制应用电路。
Finally, control circuits and PLC programs were designed in details.
对分钢系统的控制电路和PLC程序做了详细设计。
It described the control circuits of single chip AT89C2051 used in step motor.
介绍了一种采用AT 89 C 2051单片机控制步进电机的实用电路。
Control of the hardware design part of the main controller, sensors and motor control circuits.
控制部分的硬件设计主要有控制器，传感器和电机控制电路。
The structure of main circuit and the control circuits and the relative calculations are also given.
同时给出了主电路、控制电路、主要参数的计算方法及相关波形。
Ashby was an engineer interested in nonlinear control circuits and the virtues of positive feedback loops.
阿什比是一位工程师，他对非线性控制电路和主动反馈回路的优点感兴趣。
It was considered for low consumed power to design the display and control circuits of this heat meter.
热量表的显示和控制电路，也均考虑了低功耗的要求。
All control circuits with contactor shall be provided with control cables connected to site control buttons.
所有带接触器的控制回路均有引至现场控制按钮的控制电缆。
The hardware circuits are made up of USB interface circuits, control circuits and data acquisition circuits.
硬件电路主要由usb接口电路、控制电路、数据采集电路组成。
The control circuits above can compensate the excursion of variety speed of data output signal automatically.
上述双重控制可以自动补偿数据输出信号变化率的偏移。
Due to the particular load characteristic, both the current loop and voltage loop control circuits are devised.
并且针对其独特的负载特性，在设计电流闭环控制电路的同时，还设计了电压环控制电路。
We use the CPLD to realize some control circuits, such as address decoder circuits and generate the sample impulses.
这里CPLD主要实现逻辑控制部分的作用，主要完成了采样脉冲产生、地址译码等功能。
It also designs and develops the parameters of residual current collection, as well as other show and control circuits.
其次进行了剩余电流等数据信息的采集，以及其它显示、控制电路的设计。
Same shape, structural and electrical characteristics and control circuits as for regular T5, T8, T12 and Circline lamps.
与T 5, T 8,T12和环形光管的形状、结构、电子特性和控制电路相同。
The system with two control circuits separately for tested engine and dynamometer could conduct engine test automatically.
该系统能够对柴油机进行全自动测试，它具有柴油机和测功机两个控制回路。
This article analyzes the control circuits of electric welding machines, also introduces the common failures and solutions.
对焊机控制电路进行了分析，介绍了常见故障及处置办法。
Combined with 3 typical fuel pump control circuits, this paper introduces their working principles and maintenance methods.
结合3种典型的燃油泵控制电路，分别介绍了燃油泵控制电路的工作原理和检修方法。
Standard switch entirely suitable for millivolt service on self-energized control circuits of gas fired heating installations.
在燃气加热安装系统的自激控制电路中，整个标准开关适用于毫伏电压。
Some new types of control circuits of high speed electromagnetic clutch used in electrical machine are designed in this paper.
提出了电机高速电磁离合器的几种控制电路，并进行试验分析。
Buffer register, circular allotter, control logic, positive run and back run control circuits are replaced by computer software.
由缓冲寄存器、环形分配器、控制逻辑及正反转控制门组成的步进电机控制器则用计算机软件替代。
This paper discusses and studies its working principle and control method and presents a feasible design of the control circuits.
本文研究讨论了电源的工作原理和控制方法，并对其电路进行了合理设计。
The design factor for temperature field of instruments and selection on precision temperature control circuits are introduced in detail.
详细介绍了仪表温度场的设计要素及精密温控线路的选择。
This paper introduces in details the control circuits and working principles of the power window and the electric door lock on CEDRIC car.
详细介绍公爵王轿车电动门窗和电动门锁的控制电路及工作原理，并结合实物绘制出其电路连接图、控制原理图、部件结构图。
The image sensor is switched among the three modes by control signals, which are provided to the image sensor by various control circuits.
各个控制电路提供给图像传感器的控制信号使图像传感器在三种模式下切换。
They integrated miniature antennas, control circuits, an LED and radio chips into the lens using optoelectronic components they built from scratch.
他们使用自己从零开始制造的光电子元器件，将微型天线、控制电路、一块LED和无线芯片集成到隐形眼镜中。
The working principle of interleaving PFC converters is analyzed, small-signal model analysis is conducted, and control circuits are designed.
分析了交错并联功率因数校正电路的工作原理，并进行了建模分析及控制电路的设计。
In this paper, mainly discuss the synthesis method of combined control systems (systems both contain open loop and closed loop control circuits).
本文主要讨论了复合系统(具有开环及闭环控制回路的系统)的综合方法。
The pseudo random coding theory is studied, the control circuits of pseudo random laser modulating and image capturing synchronously are designed.
系统研究了伪随机编码理论，并硬件实现了瞬态激光伪随机编码调制及同步图像捕捉控制电路。
Systemically studied pseudo random coding theory, and designed the control circuits of pseudo random laser emission and image catching synchronously.
系统研究了伪随机编码理论，并硬件实现了瞬态激光伪随机编码调制及同步图像捕捉控制电路。
Systemically studied pseudo random coding theory, and designed the control circuits of pseudo random laser emission and image catching synchronously.
系统研究了伪随机编码理论，并硬件实现了瞬态激光伪随机编码调制及同步图像捕捉控制电路。
应用推荐