Results: All the luting cements had different extent curing shrinkage.
结果：所有标本都有不同程度的凝固收缩。
Based on two kinds of silver powder with different morphology and three matrixes with different curing shrinkage, six electrical conductive adhesives were prepared.
选用三种不同固化收缩率的基体树脂和两种银粉，分别配制了六种导电胶。
The curing characteristics such as gel time, heat Peak and curing shrinkage rate of MFE epoxy vinyl ester resin (MFE type and AFE type) are discussed in this paper.
本文对MFE环氧乙烯基酯(含mfe型和afe型二种型号)树脂的固化性能(凝胶时间、放热峰和固化收缩率)作了报道并进行讨论。
It shows good adhesion, small curing shrinkage, non toxicity and simple application process. The coatings thereof can be used in high temperature and moisture circumstances for long term.
该涂料具有对基材附着力好、固化收缩小、无毒环保、使用方便、可长期在高温和高湿环境下使用等优点。
It has high mechanical strength, toughness, good heat resistance and high thermal intensity, low shrinkage, good curing characteristics.
它具有机械强度高、韧性好、耐热性好及高的热强度、低收缩性、固化性好等特点。
Both the sealed curing and the fog curing can reduce early age shrinkage of concrete, but the initial curing age must be emphasized.
密封养护和喷雾养护均能减小混凝土的早期收缩，但必须要强调养护的“及时性”。
The large shrinkage stress and thermal stress induced by ineffective measures for concrete curing and temperature insulation are the main causes at middle and later stages.
由于后期养护和保温措施不力产生较大的收缩应力和温度应力是引发中后期裂缝的主要原因。
Because of the rapid curing rate and big volume shrinkage, UV-curable coiling coatings are generally of bad adhesion to metal substrate.
紫外光固化涂料由于固化速度快、体积收缩大，故通常存在与金属基材附着力差的问题。
The decomposition and delayed formation of ettringite were studied under the temperature match curing (TMC)condition in shrinkage compensating massive concrete.
在模拟大体积补偿收缩混凝土内部温度变化条件下，研究了钙矾石的分解与二次生成。
The main reason of shrinkage stress during curing period is the change from distance between monomer molecules to covalent distance .
树脂固化时收缩应力的主要原因是单体之间的分子间距离缩短变为共价距离。
The effect of active monomers, oligomers and couple agent on shear strength and volume shrinkage of UV-curing adhesive was investigated.
考察了活性单体、预聚体及偶联剂对紫外光固化胶粘剂的粘接强度、体积收缩的影响。
HCH-6993 for a curing exothermic peak at the low shrinkage rate of new small unsaturated polyester resin.
6993为固化时放热峰低、收缩率小的新型不饱和聚酯树脂。
Extend rest period and thermostatic period, increase thermostatic temperature also could reduce the dry shrinkage rate of standard curing concrete sand mortar, evidently improve its volume stability.
延长预养时间和恒温时间、提高恒温温度可以降低蒸养纯水泥砂浆的干缩率，使其体积稳定性得到明显改善。
The early water curing of concrete is longer and then the rate of late drying shrinkage of concrete is faster.
延长混凝土的早期水养时间，并不会减少混凝土的干燥收缩值，反而会使干缩速率加快；
SC-1067 for curing exothermic peak at the low shrinkage rate of new small unsaturated polyester resin.
SC-1067为固化时放热峰低、收缩率小的新型不饱和聚酯树脂。
The dry shrinkage rate of standard curing concrete sand mortar evidently exceeded the steam curing simples at the same age.
标养水泥砂浆的干缩率明显大于同龄期蒸养水泥砂浆试件。
The dry shrinkage rate of standard curing concrete sand mortar evidently exceeded the steam curing simples at the same age.
标养水泥砂浆的干缩率明显大于同龄期蒸养水泥砂浆试件。
应用推荐