This fact will be used by the modification shown below to create a simple count of the number of deviations between the current waveform and all of the stored voice prints from the *.vertex files.
因此下面的修改将利用这个事实，创建当前波形与所有存储在 *.vertex文件中的声波纹之间的偏差数量的简单计数。
Experiment results prove such method can effectively improve output current waveform of inverter.
实验证明了该方法能有效地改善逆变器的输出电流波形。
In a drive system of power transistor inverter-motor, not only can it be used in fine control of motor current waveform, phase, amplitude and frequency, but can also be used to sense, fault current.
在大功率晶体管逆变器——电动机驱动系统中，它不但可用来对电动机电流的波形、相位、幅值和频率进行精细控制，而且能快速地检测出故障电流。
The compensation method can effectively improve motor current waveform, the inverter's output performance can be greatly enhanced.
该补偿方法能有效改善电机导流波形，提高了逆变器的输出性能。
Computation of spark discharge radius, impulse grounding potential distribution, current waveform and impulse grounding resistance is conducted by using this model.
应用该模型进行了火花半径、接地体冲击地电位分布、电流波形及冲击接地电阻的计算。
As in case of drain-source voltage this method allows to associate the elements of the drain current waveform with its contribution to the whole spectrum.
就象漏源极电压的例子那样，用这种方法也可以找出漏极电流的哪一部分对电磁干扰频谱产生影响。
Based on index number of power quality this system can supply foundation for the whole system action and improve current waveform.
该系统可以根据电能质量指数，为整体系统动作提供依据，改善电流波形。
Through simulation and measuring, a corresponding state locus diagram and a voltage and current waveform and output characteristics are thus made, from which a useful conclusion is reached.
作出对应的状态轨迹图，通过仿真和实测，求出相应的电压、电流波形及输出特性，从中得出有益的结论。
The results indicate that the dead time effect distorts inverter output voltage and current waveform and increases torque ripples of the motor.
结果表明，死区效应引起了逆变器输出电压波形畸变，引起了电机电流波形畸变和转矩脉动。
A novel current regulator was used in the control system to improve the rotor current waveform.
该系统使用了一种新的电流控制器，以改善电机转子电流波形。
According to the current waveform and actual condition of the motor at two sides of the terminal, it is pointed out that the transformer saturation is the direct reason of causing this fault.
根据电动机首末端两侧电流波形及现场的实际情况，指出电流互感器饱和是导致这次事故的直接原因。
The correctness of the model is verified by the comparison of simulating and testing results of the current waveform, the output torque, the ripple torque and some other performance indexes.
设计和优化等问题提供了基础，对电流波形和机械特性等进行仿真计算和实验校核，验证了该模型的正确性。
The armature current waveform of BLDCM were analyzed.
着重分析无刷直流电动机(BLDCM)电枢电流波形。
This welding technology is constituted by the combination of welding wire composition, the diameter of a wire, and current waveform.
本焊接技术由焊丝成分、焊丝直径和电流波形的组合构成。
On the other hand, it made use of the function of date measure to realize the data collection, display and print of current waveform in order to improve the information level of whole system.
另一方面，利用数据检测功能实现对焊接电流波形的采集、显示和打印，以提高整机的信息水平。
It is proved by the compensated current waveform and speed waveform that the method is effective.
补偿后的电流波形和转速波形证明了该技术的有效性。
Through the experiments of the different current waveform, the results show that the current waveform control is an effective method to improve the quality of the weld formation.
通过对不同电流波形的实验研究，结果表明采用电流波形控制可以有效地改善焊缝成形。
The basic features of the coil current waveform of the circuit breaker are also obtained by theoretical analysis.
并通过理论分析得出了断路器分合闸线圈电流波形的基本特征。
Through probing into the current waveform control of CO2 welding, one method of short transition is put forward.
通过对CO_2焊的电流波形控制方法探讨，提出了适合于CO_2焊接过程的短路阶段和燃弧阶段的控制策略。
The parameters of heating rate, energy, current waveform and time should be controlled precisely in order to insure the quality of minisize piece spot welding.
为了确保微型件点焊质量，往往需要对点焊过程的加热速度、能量、电流波形、时间等参数进行精密控制。
The main characteristics of minisize piece spot welding is analyzed. The basic principle, output current waveform and properties of various minisize piece spot welding machine is expatiated.
分析了微型件点焊的主要特点，阐述了各种微型件精密点焊机的基本工作原理、输出电流波形和性能特点。
In this paper, a control system with restraining negative sequence current is adopted simulation results of which demonstrate that output current waveform can meet sinusoidal and balanced demand.
为了解决上述问题，本文采用了抑制网侧负序电流分量的控制方案，仿真结果表明采用该方案后输出电流波形满足了正弦化及平衡化的要求。
Based on the analysis method of the simple intrinsically safe inductive circuit and its discharge current waveform, studied on the intrinsically safe performance of communication and signal cable.
基于简单电感性本质安全电路的分析方法及其放电电流波形，对通信与信号电缆的本质安全性能进行了研究。
Spot welding is greatly affected by the current, so the real-time display of current waveform in the welding is very necessary.
焊接电流对电阻点焊有着重要的影响，因此在点焊过程中实时显示焊接电流波形是十分必要的。
The operation condition of motor microcomputer-based protection was analyzed in this fault, and the current waveform in the course of starting was simulated using EMTP simulation tool.
分析了微机电动机保护装置在此次事故中的动作情况，并使用emtp仿真工具仿真电动机在自起动过程中的电流波形。
The status of realization of variable polarity current waveform, arc stability, cathodic cleaning mechanism and keyhole detection is introduced in this paper.
介绍了国内外在实现变极性电流波形、电弧稳定性、阴极清理机理、小孔信号检测等方面的研究现状。
The digital comparator designed with FPGA generates several PWM current waveform synchronously, to realize the step angles even division control for four-phase stepping motor.
并通过FPGA设计的数字比较器，同步产生多路PWM电流波形，实现对四相步进电动机转角进行均匀细分控制。
The digital comparator designed with FPGA generates several PWM current waveform synchronously, to realize the step angles even division control for four-phase stepping motor.
并通过FPGA设计的数字比较器，同步产生多路PWM电流波形，实现对四相步进电动机转角进行均匀细分控制。
应用推荐