Based on electric contrd design of mew mode reduction furnace, this paper explained PCLbasic program programing method and step by step programming method.
本文通过对新型燃气还原炉电气控制设计，阐述了PCL基本顺序指令编程方法和步进状态编程方法，证明了微机应用于能耗设备上的节能可能性及必要性。
Electric furnace is major equipment of zinc powder reduction smelting.
电炉是锌粉工艺进行还原熔炼的承载设备。
The electric arc furnace (EAF) dust pellets were reduced in isothermal condition in order to make the reduction similar to the EAF production, and the kinetics of the reduction process is researched.
为使还原条件与实际电弧炉生产相接近，在等温条件下对电弧炉粉尘球团的还原过程动力学进行了研究。
The electric furnace was used to heat the pellets, and the electrical balance was used to check the weight change of the pellets in the reduction process.
金属还原率的计算中，考虑了球团的失重、铅和锌在高温下挥发。
To thinking of the quality of DRI two parts, namely direct reduction and steelmaking on electric furnace must be considered.
直接还原铁质量，必须兼顾直接还原生产和电炉炼钢两个生产环节。
The latter with lower Fe content, higher Si content and higher Mg content, which is subjected to electric furnace reduction smelting.
后者特点为低铁、高硅和高镁，电炉还原熔炼是其主流工艺。
The latter with lower Fe content, higher Si content and higher Mg content, which is subjected to electric furnace reduction smelting.
后者特点为低铁、高硅和高镁，电炉还原熔炼是其主流工艺。
应用推荐