Yulongling ground electrode; West-East Gas Pipeline 2; Stray Current; Underground pipeline;
鱼龙岭接地极；西气东输二线；杂散电流；埋地管道；
It shakes the currently used grounding design method based on the ground electrode equipotential.
基于矩量法和场路结合的思想，提出了一种新的大型地网工频接地参数计算方法。
In the long range mode, the target Max is also a directional locator with a ground electrode transmitter to determine direction to the target.
在远程模式，目标也是最大的地面发射电极定向定位，确定方向，目标。
A spark is produced by applying a high voltage (from approximately 6 KV to 40 KV) between the center electrode and ground.
火花由在中心电极和旁电极之间的高电压(大约6千伏到40千伏)产生。
Do not touch electronic control units or electric cables with the ground connection or the welding electrode.
不要用接地连接或电焊条接触电子控制单元或电线。
The formulation of the capacitance vs ground of the capacitance proximity fuze can be set up by the equivalent spheroid electrode.
通过理论分析和有限元计算可以看出，电容近炸引信对地电容方程可以用等效球电极的电容方程来建立。
The resistance-reducing rate for the small ground grid or electrode is less than 56.6%, even under large permeability.
即使考虑强大的渗透作用，集中接地体或小型地网的降阻率也不会超出56.6%。
The impulse test equipment shall be calibrated by means of a peak detecting electronic voltmeter connected directly between the electrode head and ground.
脉冲火花机的校准是把数位电压表直接接在测试电极和地之间。
It comments emphatically on three advanced geophysical exploration methods of multi-electrode geoelectric measurement, ground penetrating radar and SNMR.
着重评述多电极地电探测、地面穿透雷达、地面核磁共振三种先进的地球物理探测方法。
Before striking an arc, the welder frequently taps the end of the electrode on the ground to break away flux at the tip.
在引人注目的一个弧形，水龙头的焊工经常年底电极地面上打破通量的小费。
Each sensor region has electric field confined by the electrode and ground wire around the electrode.
每一传感器区域均具有由电极和电极周围的地线所限定的电场。
In further steps, the second electrode (113) is disconnected from the load potential, and the ground potential (120) is applied to the second electrode.
在其他步骤中把该第二电极(113)与该工作电位断开并且把该地电位(120)施加到该第二电极上。
In further steps, the second electrode (113) is disconnected from the load potential, and the ground potential (120) is applied to the second electrode.
在其他步骤中把该第二电极(113)与该工作电位断开并且把该地电位(120)施加到该第二电极上。
应用推荐