That rate of heating is far greater than during the last glacial retreat some 12,000 years ago.
这一升温速度远高于约1.2万年前的最后一次冰川消退。
The impacts of clouds on the radiative heating rate depend on the height and thickness of clouds.
云对沙尘层辐射加热(冷却)率的影响与云的高度和厚度有关。
Effects of coal rank, coal maceral, temperature, heating rate, coal particle size, residence time, atmosphere, and pressure on the phenols production in coal conversion were discussed in this paper.
本文探讨了煤化度、煤岩组成、温度、加热速度、煤颗粒大小、停留时间、反应气氛和压力对煤转化过程中酚类产生的影响。
The thermal decomposition process of the oxalate precursor was optimized through varying heating rate in different temperature ranges.
通过改变不同温度范围的加热速度来优化草酸盐前驱体热分解工艺。
In this article, a thorough investigation has been conducted into heating rate, holding time and cooling speed in an effort to work out an optimum ingot annealing process.
本文对铸件退火时如何控制加热速度、保温时间、冷却速度进行了充分的研究和探讨，为合理制定铸件退火工艺指出了方向。
Radiative effects of dust aerosol impacted the solar radiation flux arrived the floor, solar heating rate, temperature, wind, and the physic quantity of boundary layer.
沙尘辐射效应影响到达地面短波辐射量、短波辐射加热率、温度、风及边界层特征量等的变化。
The effect of heating rate on the development of cube texture in silicon-iron alloy was investigated.
研究了加热速率对铁硅合金中立方织构形成的影响。
A preliminary discussion was given on the basic situation of the influences of the pulse heating parameters on heating rate, stress relief, annealed embrittlement and soft magnetic properties.
初步探讨了电脉冲加热对加热速率和该合金内应力释放、退火脆化以及最终软磁性影响的基本规律。
The result showed that the electrical conductivity of soybean milk increased with temperature and solid content, and the heating rate increased with solid content and applied voltage.
加热速率随施加电压和固形物含量增大而加快，豆浆的温度与时间为指数关系。
The effects of egg white, yolk content and applied voltage on ohmic heating rate of egg white and yolk solution were also investigated.
研究了蛋清、蛋黄浓度和电压对蛋清溶液、蛋黄溶液加热速率的影响。
The electric conductivity and the heating rate increased with voltage increasing.
随着电压的增大，淀粉悬浮液的电导率和加热速率也随之增大。
There will be a conspicuous rise in semi-char ignition temperature when the heating rate is increased.
随着加热速率的增加，半焦的着火温度明显上升。
Solar radiation is the foremost source of energy for Earth climate, so a minor error in calculation of the heating rate about short wave radiation may cause a prodigious mistake in climate modeling.
太阳辐射是地球气候最终的能量源，在短波辐射加热率计算中的一个小的误差就可能引起气候模拟中很大的误差。
With the help of the results, the solar heating rate and the infrared cooling rate were investigated, and some features of them were analyzed.
分析了青藏高原北部及其邻近地区的加热率和冷却率的一些特点。
The parameters of heating rate, energy, current waveform and time should be controlled precisely in order to insure the quality of minisize piece spot welding.
为了确保微型件点焊质量，往往需要对点焊过程的加热速度、能量、电流波形、时间等参数进行精密控制。
The effects of some factors, such as time, temperature, pressure and heating rate on the pyrolysis of some chinese coals were investigated.
讨论了加热时间、温度和加热速率对煤裂解行为的影响。
The processing parameters, the effect of the mixing, the pressing parameter, the foaming temperature, heating rate and heat preservation time were studied.
分析讨论了试验工艺条件及工艺参数如混料条件、铝坯压缩条件和发泡中的加热温度、加热速度和保温时间对形成泡沫铝的影响。
With the rise of heating rate, the maximum decompose rate and its corresponding temperatures of biomass increases, but the final agravic quotient decreases.
随升温速率的提高，生物质的最大热解速度提高，对应的峰值温度升高，最终失重率呈下降趋势。
When the heating rate increases, all pyrolysis characteristic temperatures of King grass rise.
随着温升速率的上升，王草各热解特征温度都有所升高。
The combustion process and combustion characteristics can be significantly improved by changing the operating condition, such as heating rate and oxygen concentration, etc.
改变加热升温速率和氧气浓度等操作条件，可以明显改变燃烧过程和燃烧特性。
Pyrolysis pressure and heating rate showed little effect on the yield of volatile matter of macerals.
热解升温速率和压力对镜质组和丝质组的挥发分收率略有影响。
Explanation was given on improvement effect of heating rate to caking property from essence of chemical reaction using pyrolysis kinetics.
并用热解动力学从化学反应的本质解释了升温速率对煤的粘结性的改善作用。
The characteristic temperatures are gradually tended to high temperature zones with DSC heating rate increase, where the dynamic effect of crystallization is much higher that of glass transition.
这些特征温度随dsc升温速率的增大，不断向高温区偏移，其中晶化行为的这种动力学效应比其玻璃转变的更为显著。
The TG curve moves toward the direction of higher temperature as the heating rate increases, because of the increase in thermal lag.
试验发现随着升温速率的增加，热滞后现象的加重致使纤维素热裂解各个阶段向高温侧移动；
It points out that the relation between optimal heating rate and coefficient of performance of a Carnot heat pump is useless.
指出了卡诺热泵的最佳泵热率与致热系数间的关系是没有实际意义的。
Higher heating rate results in smaller grain size.
高的升温速率可获得较小的晶粒。
The structure change is presumed in liquid PbSn alloys, and depends on the heating rate, thermal history and components and so on.
研究中发现在连续升温过程中合金液发生了结构转变，其转变程度与升温速率、热历史和合金组成等因素有关。
The temperatures of peak on the DSC curves increase with the increase of heating rate.
DSC曲线的峰值温度也随升温速率的增加而增加。
The influences of heating rate and soaking time on piezoelectric and dielectric properties were also studied.
并研究升温速度，保温时间对介电、压电性能的影响。
The influences of heating rate and soaking time on piezoelectric and dielectric properties were also studied.
并研究升温速度，保温时间对介电、压电性能的影响。
应用推荐