No matter it is knot type furnace lining or fabricated furnace lining, when for long time working under the high temperature it is certain to change (mainly is expansion and contraction or oxidation).
不管是打结式炉衬，还是装配式炉衬，长期在高温下工作都会发生变化（主要是热胀冷缩和氧化）。
These will result in local heat accumulation at the outlet of burner, very high temperature of flue gas, uneven distribution of temperature in furnace and damage of nozzles.
这将导致燃烧器出口处热量局部聚集，烟气温度非常高，造成炉内温度分布不均及喷嘴的损坏。
The limestone particles are heated rapidly to high temperature upon entry into the boiler furnace.
当石灰石颗粒一进入锅炉炉膛，就迅速被加热到高温。
The resistance furnace can be heated to very high temperatures, the supplies graphitizing furnace carbon materials, for example, can put the material heated to a temperature of more than 2500.
这种电阻炉可以把物料加热到很高的温度，例如碳素材料石墨化电炉，能把物料加热到超过2500。
The high blast temperature technology by top combustion preheating furnace preheating the intensifying combusted air is used for the hot stoves of New no. 2 and no. 3 BFs in Angang.
鞍钢新2号、新3号高炉热风炉应用了顶燃式预热炉来预热助燃空气的高风温技术。
The connection between separator, furnace and back-end flue adopts stainless steel nonmetal expansion joint which can bear high temperature.
分离器与炉膛及尾部烟道之间的联接采用耐高温非金属膨胀节。
This company endeavors to hardening, normalizing, tempering, high and medium temperature quenching, mesh belt furnace quenching, cementing, time effective freezing and high temperature treatment etc.
本公司是一家致力于从事调质、火、火、中温淬火、带炉淬火、碳、效冰冷及其高温热处理的厂家。
A mathematical model of heat loss of high temperature smoke vented from rotary anode furnace in copper refining based on warm-up burning air was established based on principle of energy balance.
根据能量平衡原理，建立了基于预热燃烧风富氧下铜精炼阳极炉高温烟气热损失数学模型，并根据富氧燃烧风对铜精炼阳极炉氧化期高温烟气热损失数学模型进行计算。
The fluidized bed is better than the grate furnace as a combustor since its diversity of fuel kinds, high efficiency of combustion and lower temperature of operation.
流化床燃烧方式和炉排炉燃烧相比具有燃料适应性广、燃烧效率高、运行温度低等优点。
Three kinds of high temperature resistance furnaces with different heating method are designed, that is, outside-wall heating, inside-wall heating and double heating high temperature furnace.
设计了三种不同加热方式的高温电阻炉，即外壁加热、内芯加热和双重加热高温炉。
The hardware composition, high precision conversion of temperature signal and the trigger control circuit for resistance furnace are introduced.
介绍了电阻炉温度控制系统的硬件组成、温度信号的高精度转换及触发控制电路。
The stainless steel out \ | gassing rates can be reduced greatly by high temperature degassing technology in a vacuum furnace.
真空炉高温除气工艺可以大大降低不锈钢出气率。
High temperature performance of acid lining of the induction crucible furnace mainly depends on the physical and chemical properties and mineral composition of used refractory.
坩埚式感应炉酸性炉衬的高温性能，主要取决于所用耐火材料的物理、化学性能及矿物组成。
The furnace unit is consisted of a hydrogen supply source, a high temperature pit furnace, a furnace pot, a slow-cooling furnace, and a quench tank.
采用该方案制作的氢气退火炉由气源部分、井式高温炉、炉罐、缓冷炉和急冷槽组成。
Complex patterns of flue gas and non-uniform temperature distribution along furnace height were taken place due to high jet velocity of bottom burners in the ethylene cracking furnace.
乙烯裂解炉底部燃烧器的燃气射流，使炉内烟气流动复杂，烟气温度分布的均匀性较差。
It introduces the technology of producing clean high-silicon silicomanganese. Fine materials, higher furnace temperature, suitable slag basicity and correct operation are all needed in the technology.
介绍了纯净高硅锰硅合金的生产工艺，即要有优质的原料、较高的炉温、合适的炉渣碱度和正确的冶炼操作方法。
During the simulation of the dynamic properties of regenerative high temperature air combustion system in coupled case, an industrial heating furnace model is selected as the physics model.
在对耦合工况下蓄热式燃烧系统的动力特性分析中，以一个工业用蓄热式加热炉为参考计算模型。
The blast furnace gas as fuel of high temperature reheating furnace is an important technology for energy-saving and environmental protection.
高炉煤气作为高温加热炉单一燃料是节约能源和改善环保的重要技术措施。
By adding silver phosphate as antibacterial into the batch of borosilicate glass, we can get the anti-bacterial glass in high temperature melting furnace.
采用高温熔融法，在硼酸盐玻璃的配合料中引入抗菌剂磷酸银，一次烧制而成制得抗菌玻璃材料。
This paper introduces that it can resolve the problem of pollution that using high temperature low oxygen combustion so it can be used in some kinds of furnace.
采用高温低氧燃烧方法可解决污染问题，并且还可以用燃料不换向技术来进一步简化燃烧系统。
Based on the detail about the Characteristics of regenerative combustion, by the coal of the high temperature gasifying furnace, the regenerative reheating furnace is designed.
本文在详细分析蓄热式燃烧技术的基础上，利用高温气化炉产生的煤气，对蓄热式高温炉进行了设计。
This paper introduces the application of the flame temperature adjustable high velocity burner and the pulse type system of temperature adjustable in aluminum ingot heating furnace.
介绍了高速调温烧嘴及脉冲式控温系统在铝锭加热炉上的应用情况，采用了炉顶垂直安装高速烧嘴的形式，取得了满意的加热效。
This paper analyzes the properties of temperature control system of heat treatment electric furnace, showing that a normal controller does not meet the needs of high control accuracy.
分析了热处理电阻炉温度控制的对象特性，说明了常规控制器不能满足高精度控制的原因。
Blast furnace is a high temperature reactor which includes complex physical chemistry reaction and transportation process.
高炉是一个包括复杂物理化学变化和传输过程的高温反应器。
The large amount of vanadium in Orimulsion may cause unexpected problems in the prevention of high-temperature corrosion of furnace.
奥里油中含钒量较多，是锅炉预防高温腐蚀设计中的大难题。
This article analyzes the causes and damages of the accident on high temperature and pressure boiler furnace explosion in detail.
炉膛爆炸是电厂及自备电站高温高压锅炉运行中一种危害及其严重的事故。
The material selection and service condition for high temperature hydrogen exposure piping and furnace pipe was analyzed for one chemical plant imported from Japan.
本文分析了某化工公司从日本引进的苯加氢装置高温高压临氢管道及加热炉炉管的选材以及运行情况。
The smelting high temperature liquid slag discharged from blast furnace, without water quenched, but with additive, can directly vitrified and be used to produce decorative material.
冶炼高炉排放的高温液态渣不经水淬，添加外加剂直接进行玻化处理，可制得饰面材料。
The high temperature combustion desulfurization possibility by fly ash remelting is study in vertical experiment cyclone furnace.
通过立式旋风炉实验台研究以飞灰重溶的方法解决高温燃烧固硫问题的可行性。
The high temperature combustion desulfurization possibility by fly ash remelting is study in vertical experiment cyclone furnace.
通过立式旋风炉实验台研究以飞灰重溶的方法解决高温燃烧固硫问题的可行性。
应用推荐