The fan operates at a set speed until the inlet air temperature exceeds the lower set point (see Table 1).
如果环境空气温度不超过最低设置温度，风扇一直以设定温度转动(见表1)。
Result: the damp proof effect enhanced with the increase of inlet air temperature and the decrease of flow rate and air pressure.
结果：微囊防潮效果随着进风温度的提高、供液速度的降低、雾化气流速的降低而增强；反之则减弱。
While the effect of engine speed on the required inlet air temperature for autoignition is different for different octane Numbers.
而发动机转速对自燃所需进气温度的影响则随所用燃料辛烷值的大小而异。
Via testing, the effect of condensing inlet air temperature on the refrigerating capacity of the self contained air conditioning set is researched.
通过试验，研究了冷凝进风温度对单元式空调机组制冷量的影响。
The experimental study was focused on the effects of inlet air temperature, inlet air flow rate and accelerating pipe length on ISCs volumetric evaporative coefficient.
实验主要研究了空气进口温度、空气进口流量、液滴加速管的长度对ISC容积蒸发系数的影响。
With the increase of inlet air temperature of the condenser, evaporation pressure, condensation pressure increase, but supercooling and superheat degree, refrigerating capacity and COP decrease.
随着冷凝器进口空气温度的升高，蒸发压力、冷凝压力升高，而过冷度、过热度、制冷量和COP均线性下降；
This paper calculates the temperature of inlet air, and analyzes precedence of gas turbine inlet air-cooling by water spray evaporative cooling in Xinjiang area.
对进气空气的温度进行分析计算，并通过计算的结果分析在我国新疆地区燃气轮机采用喷雾蒸发冷却方式冷却进气空气的优越性。
Several calculating methods for determining the air-flow rate, the exhaust temperature, the compressor outlet pressure and the turbine inlet pressure are compared.
对四冲程柴油机增压系统的空气流量，排气温度、压气机出口压力和涡轮进口压力的若干种计算方法进行了分析。
Through experiments of changing the inlet air flow rate, we can adjust the hot air outlet temperature as high as possible, which helps to reduce the heat loss and improve the collector efficiency.
通过改变集热管进口空气流量来获得尽可能高出口温度的热空气，从而降低热损系数，提高集热效率。
In this article, the main influencing factors on condensation heat transfer include air flow rate, coolant flow rate, coolant inlet temperature and mixed gas velocity.
在本课题中，影响传热过程的因素主要有空气含量、冷却水流量、冷却水温度及混合气气速。
A more general evaluation can be done by testing the temperature of the air entering the fan inlet.
通过测试进入风扇入口的空气温度可以提供更多一般的评估。
The direction of third inlet air has been changed in order to reduce the temperature of the furnace, decrease the damage of the furnace lining, and increase the productive capacity of the furnace.
通过对热风炉三次风的改向，降低炉膛温度，减少对炉衬损伤，提高热风炉的生产能力。
Presents the four main factors affecting human thermal comfort for the system, including type of air supply inlet, distance between air supply inlet and occupancy, air supply velocity and temperature.
介绍了下送风气流组织中影响人体热舒适的四个主要因素：送风口型式，送风口到人体的距离，送风速度，送风温度。
Poor sealing effects of temperature probe of scroll of bearing box at air inlet side of the air compressor results in oil contamination of following pipeline of air compressor.
由于空压机进气侧轴承箱蜗壳温度探头密封效果不好，使空压机及其后续管道受到油污染。
Based on the heat exchange theory between air and rock, the feasibility of decreasing air inlet temperature by temperature regulating action of shallow ground is discussed.
根据空气与岩体的热交换原理，探讨了利用浅部地层调温作用来降低深井入风温度的可行性。
In practical application, inlet water temperature should be higher than critical inlet water temperature and be lower than dew-point temperature of indoor air.
在实际应用中，干式盘管的实际进水温度应高于临界进水温度，但低于室内空气的露点温度。
The model is based on the easy measurable parameters, such as the inlet and outlet temperature of flue gas, the wall temperature of air preheater, and the pressure difference of the air preheater.
该模型只利用进出口烟气温度、空气预热器管壁温度和烟气压降等易测参数来监测积灰情况。
The calculation results show the characteristics of temperature distribution and fluid flow inside the air-conditioned room with variors air inlet parameters.
并对计算结果进行分析，总结出送风参数对空调房间的气流流动与温度分布的影响规律。
The experimental results show: firstly, the concentration of the concentrated sulfuric acid increases with increased inlet air flux, increased intet air temperature and decreased inlet liquid flux;
实验研究表明：硫酸浓缩液浓度随空气进口温度的升高、空气进口流量的增大以及稀硫酸进口流量的减小而增大；
It can be seen that if the engine air inlet temperature is higher and the ambient pressure is lower than the standard conditions, the power output of the effects will be lower.
可以看出，如果在发动机的进气温度较高，环境压力低于标准的条件下，输出功率的影响将降低。
Based on the research on the heat exchange regularity between air and rock in air-inlet temperature-regulating system, a new method for improving mine ventilation is presented.
通过研究矿井入风调温系统的空气与岩体热交换规律，提出了改善矿井通风的一种新方法。
The air inlet can be switched on off with facility. Air-circulation system is made of low-noise import motor, suitable wind direction. The temperature in the working chamber is even.
进风口开关自如，热风循环系统由低噪声进口风机和适合风道组成，工作室内温度均匀。
Some parameters, such as the inlet air humidity and temperature, the regeneration temperature, the air mass flow rate, which may affect the performance of the desiccant wheels, were also analyzed.
实验研究发现在相同工况下，氯化锂转轮的显热效率、潜热效率均高于硅胶转轮。运行参数中再生温度、处理空气进口湿度对转轮除湿性能影响比较大。
When the air separation device is reformed, the temperature measuring point is added to the inlet and outlet pipeline of each plate unit of the main heat exchanger.
在空分装置改造时，卧螺离心机在主换热器的每个板式单元的各个通道的进出口管线上增设了温度测量点。
Table 1 contains the recommended temperature that the heatsink base test point or the air inlet temperature should remain below during the thermal evaluation of a system.
表1含有进行系统热量测量时散热器基座测试点或空气入口温度应该低于的推荐温度值。
Using the "dry" temperature of air-fuel mixture before inlet valve as a criterion to ch...
证实了可用进气门前混合气的“干”温度作为评价进气预热效果的参数。
Meanwhile, the influence of the area ratio of regeneration to dehumidification to the MRC and inlet process air temperature and humidity to the DCOP is investigated.
同时，对于再生区与除湿区面积比率对性能指标MRC以及处理空气进口温湿度对性能指标DCOP的影响，本文给出了结论。
The relations of thrust and specific impulse to inlet air flow and temperature are derived from theoretical analysis of solid fuel ramjet (SFRJ) performance.
在固体燃料冲压发动机性能分析基础上，推导了某发动机的推力和比冲与入口流量和温度之间的关系式。
The results show that when the velocity of cooling air and the width of inlet-cirque are changed, the effects on wall cooling and high temperature region of drying-tower must be considered.
分析了冷却风速度大小、进口圆环宽度对干燥塔内干燥介质温度场的影响。 模拟结果表明：在确定冷却风速度大小和进口圆环宽度时，应考虑它们对塔壁的冷却效果及对干燥塔内高温区域的影响。
The results show that when the velocity of cooling air and the width of inlet-cirque are changed, the effects on wall cooling and high temperature region of drying-tower must be considered.
分析了冷却风速度大小、进口圆环宽度对干燥塔内干燥介质温度场的影响。 模拟结果表明：在确定冷却风速度大小和进口圆环宽度时，应考虑它们对塔壁的冷却效果及对干燥塔内高温区域的影响。
应用推荐