It can measure the oil film thickness, oil temperature, crank Angle, speed, journal center locus and minimum oil film thickness of main bearing in diesel engine.
该系统可测量内燃机主轴承的油膜厚度、油膜温度、曲轴转角、转速、轴心轨迹和最小油膜厚度。
Similarly, in the crankshaft journal and crankshaft bearing clearance measurements, they can draw on such skills.
同样，在进行曲轴轴颈和曲轴轴承配合间隙的测量时，也可以借鉴这种操作技巧。
The present concept can be used not only to design a more outstanding journal bearing but also to design a thrust bearing or a slider bearing with an outstanding performance.
本文提出的设计理念不但可用于设计出具有更优异特性的径向滑动轴承，而且可以设计出具有复合表面的轴向滑动轴承或滑块轴承。
The results shown that, with the effect of nonlinear components, the symmetry of rotation trajectory of the bearing center was broken, and the motion of the journal center presented a steady state.
计算结果表明，在非线性因素作用下，轴承中心的轴心轨迹不再具有对称性，而轴颈中心却表现为一种稳定的运动状态。
The crankshafts shown in Fig 1-4 is actually made up of various parts such as main bearing journals, rod journal, crank arm, bearing, counter balanced weight and flywheel end.
在图1-4中，曲轴实际上由以下不同的部分组成，它们分别是：主轴承轴颈、连杆轴颈、曲轴臂、轴承、平衡配量（？）以及飞轮端。
Rotor bearing system is the heart of large-scale rotating machinery, as a major way to support, the dynamic problem of tilting pad journal bearing (TPJB) growing concern by the people.
转子—轴承系统是大型旋转机械的核心部件，作为主要支承方式的可倾瓦滑动轴承支承，它的动力学特性日益被人们所关注。
It is necessary to consider the influence of the nonlinearity of fluid forces in tilting pad journal bearings when the dynamics performance of the rotor-tilting pad bearing system is analyzed.
可见在进行转子-可倾瓦轴承系统的非线性动力学分析时有必要计入可倾瓦滑动轴承油膜非线性的影响。
In this paper, the oil film force of finite journal bearing is obtained using averaging natural value method.
利用平均本征值法求得有限宽轴承的油膜力。
A method of determining the load on journal bearing of three-cone bit is described in this paper.
本文阐述了三牙轮钻头滑动轴承载荷的测试方法。
Stability and coupling dynamic behaviors of a journal active electromagnetic bearing rotor system are analyzed.
研究径向主动电磁轴承支承的不对称转子系统的动力行为及稳定性。
The effect of the couple stress on the thermo hydrodynamic performance of a finite journal bearing is studied in this paper.
研究了应力偶对有限长滑动轴承热流体动力特性的影响。
By analyzing reasons for break of engine crankshaft journal and bearing, this paper describes mainly some countermeasures they are break in use and maintenance.
通过对发动机曲轴轴颈与轴承损坏原因的分析，重点阐述了发动机在使用与维修中预防损坏的措施和方法。
Using this method, the static characteristics of spiral grooved gas journal bearing are calculated and analyzed, and some conclusions are made as well.
文中还用这种方法计算分析了气体螺旋槽径向轴承的静态性能，获得了一些有益的结论。
This paper studies in detail the effect of magnitude and distribution of rotor unbalance on the stability of rotor-journal bearing system.
本文详细考察了滑动轴承支承的转子不平衡质量的大小及分布对系统稳定性的影响。
Discriminating methods were analyzed of dynamics stabilization of speed of rotor - journal bearing system with combining engineering practices and adopting theory of system dynamics.
结合工程实例，采用系统动力学的设计思想，详细分析滑动轴承转子系统动态失稳转速的判别方法。
Dynamic behaviors of a rotor system with nonlinear journal bearing supports were analyzed.
研究了非线性径向轴承支承的转子系统的动力行为。
The nonlinear gear mesh force and nonlinear oil film force were considered synchronously, the dynamic model of geared rotor-oil journal bearing system was proposed.
同时考虑非线性齿轮啮合力和非线性油膜力的影响，建立齿轮-转子-滑动轴承系统的动力学模型。
With reference to a symmetrical unbalanced rotor treated as a continuous elastic shaft suPPorted at its end by lubricated journal bearings, the short bearing model is adoPted.
研究了非线性弹性转子-轴承系统的轴心轨迹，认为对称不平衡转子是连续弹性轴，它两端支撑在滑动轴承上，油膜反力采用非线性短轴承模型。
The calculation speed and accuracy as using this method is discussed. The result shows that this method appear to be fast accurate and wide suitable method for journal bearing calculation.
对这种方法所涉及的计算精度及计算速度作了探讨，结果表明，这种方法是一种非常快速、精确、适用面广的轴承性能计算方法。
Based on CCD sensor and its correlative technology, a sort of on-line inspection system for the coaxality error of journal bearing accessory is developed.
开发了一种基于CCD传感器及其相关技术、可应用于工业实时在线检测的滑动轴承套类零件同轴度误差检测系统。
This paper deals mainly with the formulation, processes and microstructure of the diffusion Vanadium-coating with powder on the journal bearing steel of cone bits.
本文着重研究了牙轮钻头轴承用钢的粉末渗钒配方、工艺和渗层的组织结构。
A mathematical model is presented to study the linear stability of tilting-pad journal bearing system.
提出可倾瓦轴承系统解析模型并对其进行线性稳定性分析。
This method is valuable to the step-by-step optimization in all-course recurrence in the design of the journal bearing with hydrodynamic lubrication.
此法在流体动压轴承优化设计时，在逐步寻优进行全过程大循环的迭代中特别有效。
The result shows that compared with slenderness ratio of bearing and the eccentricity of rotor, the journal clearance is the main factor influencing the trajectory and domain characteristics.
数值结果表明，同轴承长径比及转子质量偏心相比，轴颈间隙是影响系统轴心轨迹和频域特性的主要因素。
The dynamic performance and stability of a externally pressurized hybrid journal-thrust floating ring bearing were studied considering the cavitations in deep pockets.
研究了计入气穴影响的径推联合动静压浮环轴承的动态性能和稳定性。
The paper derives the unit discharge formula of a journal sliding bearing according to the theory of Couette flow between two concentric cylinders.
根据环隙科特流理论导出了滑动轴承偏心环隙的单位宽循环流量公式。
So far there has been no simple and correct calculation approach available for computing the stress distribution in the key slot on the integral cross pin type journal bearing rest.
目前对于十字头万向接轴整体式轴承座键槽的受力计算尚无简便确切的方法。
Described are the structure and the function of hardware and software of the measuring and allocating system for roller bearing and journal of the freight car.
介绍了铁路货车段修专用的滚动轴承、轴颈测量与选配系统的软硬件结构与功能。
This paper describes the investigation into the static and dynamic performance of a tilting pad lightly loaded journal bearing.
本文阐述对轻载荷可倾瓦径向轴承的静态与动态性能的调查研究。
This paper describes the investigation into the static and dynamic performance of a tilting pad lightly loaded journal bearing.
本文阐述对轻载荷可倾瓦径向轴承的静态与动态性能的调查研究。
应用推荐