When welding is required, all welds are subject to leak test to ensure the washer is water tight.
当需要焊接时，所有的焊接需进行泄漏测试，以确保清洗机没有任何漏水处。
I pneumatic leak test at a pressure of not less than 6 bar after assembly of all tank valves and fittings.
气阀及配件装配后不少于6巴压力的气压测漏报告。
So please do your leak test and connect your sample line to sample inlet only after all leak tests are done.
因此，请检漏并在检漏工作全部结束后再连接样品管与样品进口。
Where possible, the closed position should be determined by leak test using water or air, under low pressure.
如果可能的话，可以用水或空气，在低压状态下，对关闭状态进行测试，看看有没有泄漏。
These low operating cost systems can leak test, performance test, or run test your systems and your products.
运转成本低，用于进行泄露测试、性能测试或检测系统和产品。
As a seal test, sensitivity of helium leak test is higher than other test methods as gas seal and NH_3 leak test.
氦泄漏试验作为一种致密性试验，它的检漏灵敏度远远超过了气密性试验和氨渗漏等试验方法。
The paper describes in detail the hardware network of the vacuum leak test system and the data acquisition software.
文章详细介绍了真空检漏设备数据采集系统硬件网络的构建以及软件的开发。
The air leak tester of GST-4000 is successfully designed according as the characteristics of Fuel Gas Stopcock and test demands.
的基础上，根据燃气具旋塞阀的具体特点及检测要求而开发的一款产品。
If appropriate helium leak test plan is selected, it will be of benefit to improving detectability and effectively secure titanium vessel safety and reliability.
选择合理的氦泄漏试验方案，可做到既能检漏又能及时发现漏点，有效地保证钛制容器安全性和可靠性。
When an initial service leak test is permitted by the original code of construction, such testing may also be used to verify the leak tightness integrity of repair.
当设备一项初始试漏测试被原始建造规范允许，这项测试也可以用于核实设备的气密性泄漏的修理结果。
Based on the relationship between the designing pressure parameters of pressure vessel and that of safety devices, the feasible method and pressure of gas leak test were discussed.
根据压力容器与安全泄放装置压力参数的配置关系，对可行的气密性试验方法和试验压力进行了讨论。
This paper introduces the principle of waveguide microwave leak test system, illustrates the formation and the realization of amplitude measurement unit and display-control unit in detail.
介绍了波导微波泄漏检测系统的原理，并对其中的幅度测量单元、显控单元的组成和实现作了详细的阐述。
The air leak tester of AL-1000A belongs to differential pressure type. It is a high precision detecting transducers. It is much economical and widely applied to seal test of product parts.
1000A系列检漏仪采用差压法检测原理，是一款高精度的检测仪器，广泛应用于多种产品的密封性检测。
Administrators are able to run lightweight memory leak detection in test and production environments and receive early notification of memory leaks.
管理员能够在测试或生产环境中运行轻量级内存泄漏检测，并可以在早期接收内存泄漏的通知。
Also, the test completion details included the results of memory leak analysis following each run.
同样，测试完成的详情包括每次运行后的内存泄漏分析的结果。
A simple test for memory leaks is to leave the system running after the last test of the day; if the system has recovered to the original state by the next day, then you can often rule out a leak.
对于内存泄漏的一个简单测试是，在某天的最后一次测试之后让系统继续运行；如果到第二天，该系统恢复到了原始状态，那么您通常可以排除泄漏。
Success with code stability, and therefore ability to do longevity test runs, resulted in the addition of memory leak analysis at the completion of an iteration starting with the third.
伴随代码稳定性，及进行寿命期测试运行的能力的成功导致了以第三个迭代开始的迭代完成时，增加内存泄漏分析。
Various automation techniques were employed to enable stress/load testing, memory leak analysis, data integrity testing, and regression testing throughout the test effort.
在测试过程中，使用各种自动化的技术来启用压力/负载测试、内存泄漏分析、数据完整性测试，和回归测试。
During the development iterations, a subset of stress-related and memory leak defects were removed before the formal system test entry time due to the early testing by the system test core team.
在开发迭代中，由于系统测试核心团队早期的测试，与压力相关的及内存泄漏缺陷的子集在正式的系统测试开始之前就被除掉了。
The lack of scalable and low overhead memory leak analysis tools make it hard to deal with memory leak issues in production or stress test environments.
可扩展、低开销的内存泄漏分析工具的匮乏导致不能很好地在生产环境和压力测试环境中处理内存泄漏问题。
Prior to each test, the system testers configured several product parameters to allow the memory leak analysis information to be collected during testing.
在每个测试之前，系统测试人员配置许多产品参数来允许在测试过程中收集内存泄漏分析信息。
Once the final run completed without problems, testers included information in the completion records of the test tracking tool, indicating the results of the final memory leak analysis.
一旦最终的执行在无问题的情况下完成，那么测试人员就会在测试追踪工具的完成记录中加入信息，指示最终的内存泄漏分析的结果。
The Dielectric Withstand test consists in measuring the current leak of a device under test, while phase and neutral are short circuited together.
电气强度试验包括在测试过程火线和地线同时短路的情况下测量被测设备的漏电量。
Lightweight memory leak detection in WebSphere Application Server is designed to provide early detection of memory problems in test and production environments.
WebSphereApplicationServer中的轻量级内存泄漏检测是为了在测试和生产环境中提供内存问题的早期检测而设计的。
Once the leak was fixed, I wanted to make sure the problem wasn't reintroduced in later code changes, so I built a unit test to help prevent this. It's a resource usage unit test, shown in Listing 1.
下面是一个例子：在邮件应用程序中发现一个内存泄漏，当该泄漏被处理后，我希望确定在以后的代码改变中不会再发生该问题，于是为此构建了一个单元测试。
And to start off on your crusade for memory-leak finding, you'll create a test MySQL database, shown in Listing 4.
并且为了开始进行内存泄露查找的征战，您将创建一个测试MySQL数据库，如清单4所示。
The calibrated leak device USES compressed copper material to present a leak at a certain test pressure.
该校准泄露设备使用压缩的铜质材料，在一定的压力测试下显示泄露值。
In the following test cycle the standard leak will be connected through the chamber at that moment where the test sample will be filled with test pressure.
在测试中，标准泄漏此时将接到气室，而气室内的试件就充满了测试压力。测试结束时，结果就显示在屏幕上。
The FCO750 is a pressure decay leak detector that is suited to applications requiring either multiple test configurations or flexible control of associated tooling.
FCO 750检漏器是一款压力逐渐减弱的检漏器，适用于多检测结构和辅助工具控制应用领域。
By actual test data, the leak detection system can rule out the stations affected by changes in working conditions can be accurately presented on the pipeline leak alarm and location information.
通过数据测试，该系统能够有效的排除站内工况调整影响，并能够准确的对管道泄漏给出报警和定位信息。
应用推荐