The load limit margin is adjustable to prevent unintentional stoppage.
载荷极限范围可以调节，以避免发生意外造成的停工现象。
This allows 100% of the slings rated Working Load Limit to be achieved.
这样一来，便可100%地达到吊索的额定工作负荷极限。
Besides, the eccentricity magnifying coefficient and the axial load limit for steel reinforced concrete column were also...
文中还介绍了钢骨混凝土柱偏心距增大系数和轴压力限值的计算。
YF series cylindric thrust meter is used for thrust (pressure) measurement. The measurement range is 10%-100% of the load limit.
本测力计供计量推力(压力)用，测量计的测量范围为10%极限载荷至100%极限载荷。
Besides, the eccentricity magnifying coefficient and the axial load limit for steel reinforced concrete column were also introduced.
文中还介绍了钢骨混凝土柱偏心距增大系数和轴压力限值的计算。
But also provides evidence to modify highway bridge design vehicle load and formulating the existing highway bridge design vehicle load limit.
可以为公路桥梁设计汽车荷载的修编和现行公路桥梁设计汽车荷载限载标准的制定提供依据。
It should be noted that the values provided in the product tables for load and speed ratings as well as for the fatigue load limit are heavily rounded.
注意，产品列表中所提供关于负载、速度级别及疲劳负荷限值数字均已四舍五入。
When hoisting any large or heavy equipment off the catwalk always check the Working Load Limit (WLL) of the air winch, or use the travelling block or crane if available.
当从猫道上提升体积大或较重的设备时，要检查气动绞车的额定工作负荷，或使用游车或吊车(如果有)。
If no maximum limit is set on the maximum number of session objects that can be held in memory, then it is possible to have many session objects during peak user load time.
如果不对内存中可以保持的会话对象的最大数量设置最大限制，那么在用户加载高峰期，可能有许多会话对象。
In a network that may span multiple IP subnets, you may want to limit which servers are responsible for handling queries to a specific subnet to allow for the load to be spread among multiple servers.
在可能跨越多个ip子网的网络中，您可能希望限制哪些服务器负责处理针对特定子网的查询，以允许在多个服务器之间分配负载。
Adjusting the Load Interval (the frequency of SNMP polling) will further limit this impact.
调整LoadInterval (SNMP轮询的频率)将进一步限制这种影响。
Performance analysis conducted at that load indicates that the XPages runtime itself did not limit the scaling of concurrent users on this application.
在此负载水平上的性能分析显示，XPages运行时本身不限制应用程序并发用户的增加。
You may want to consider some other criteria, in order to limit the load on build server. For example, you may.
为了限制在构建服务器上的加载，您可能想要考虑其他一些准则。
The final test occurred Apr. 21 when the wing and trailing edges were subjected to their limit load of around 2.5g, the highest loads expected to be seen in service.
根据4月21最终试验的结果，机翼和后缘的承受的极限负荷为2.5g左右，而实际最高负荷只能在实际服役的时候才能知道。
In the hydraulic system USES the accumulator, may the absorption line shock maximum limit, reduce to the variation of load to the adhesive tape the impact, enhances adhesive tape's service life.
液压系统中采用蓄能器，可以最大限度的吸收液压冲击，减小对负载变化对胶带的冲击，提高胶带的使用寿命。
The limitation of efficiency regarding load and capacity limit is to be decreased, thus improving the overall quality of feeding.
装载效率和生产能力限制的局限性减少，因此喂入质量全面改善。
In the case of constant load, the energy release rate will increase with time until it reaches a higher limit value.
在常载荷的情况下，能量释放率将随时间而增长，直到它达到某一较高的极限值。
The peak shaving parameter limit is important to the choice of heating system capability, and is relate to heat load distributing and economic question.
调峰的参数界限是供暖系统装机容量选择的重要参数，关系到系统运行时的负荷分布与经济性。
The last step is to pass the initial start and limit parameters to your data load.
最后一步是将原始启动和权限参数加入你的数据装载。
The actual load is compared to four limit values, and by achieving the limit value, the relay of the crane controller could be switch.
实际的装载量靠近极限值的同时，又不断与四个极限值相比较。起重机控制电容可以作为开关。
The limit load of a defective cylinder is a very important input in a structural integrity assessment of a pressure vessel or pipe using R6 type procedure.
在使用R 6方法的压力容器和管道结构完整性评估过程中，含缺陷圆筒的极限载荷是一个非常重要的输入参量。
When the applied load exceeds the limit strength of the material as a result of parts breaking overload fracture.
当外加载荷超过材料强度极限而造成零件断裂称为过载断裂。
Analysis and comparison between the finite element analysis and experiment results for stress intensity factor, limit load, and flexibility factor were performed.
从应力系数、极限载荷和柔度系数三个方面对有限元计算结果和试验结果进行对比分析。
The methods used to limit transient effects depend on whether the load is capacitive or inductive.
限制瞬态效应所使用的方法取决于负载是电容性的还是电感性的。
Its efficiency was demonstrated by computing the limit load factor and the collapse state for some plane stress and plain strain problems.
通过计算平面应力和平面应变问题的极限荷载因子和相应的坍塌机构，验证了算法的有效性。
Response speed has been improved by both the state machine, which makes discrete detection on load, and current limit fuzzy control.
通过状态机对负载进行离散侦测以及电流极限模糊控制模式，提高了电源的响应度；
A new method to determine the limit load of reinforced concrete deep beam when sheared was presented by upper-bound method based on reinforced concrete plasticity theory.
本文以钢筋混凝土塑性理论为基础，用上限方法确定了钢筋混凝土深梁剪切破坏时的极限荷载的计算方法。
Based on the deformation theory of linear hardening materials, a simplified finite element analysis method is proposed to calculate the limit load of structures.
基于线性硬化材料形变理论，本文提出了一种计算结构极限载荷的有限元简化算法。
In this thesis, the FEM stress analysis and strength design criteria, multi-axes strength theory and computation, limit load analysis method of arch DAMS are concerned.
本文结合工程实际，在拱坝有限元应力分析方法与强度设计准则、多轴应力强度安全计算、拱坝极限荷载分析理论和方法等方面开展研究。
In this thesis, the FEM stress analysis and strength design criteria, multi-axes strength theory and computation, limit load analysis method of arch DAMS are concerned.
本文结合工程实际，在拱坝有限元应力分析方法与强度设计准则、多轴应力强度安全计算、拱坝极限荷载分析理论和方法等方面开展研究。
应用推荐