The effect of shear deformation and rotary inertia are considered in the paper.
文中考虑了剪切变形和转动惯量的影响。
Servo motor has a long overload ability, have smaller rotary inertia and big plugging around moment.
伺服电机有较长的过载能力，有较小的转动惯量和大的堵转转矩。
Notes:Weight and rotary inertia are approximate value calculated by the greatest shaft-hole dia. of Y type hole.
注：重量、转动惯量是按最大轴孔直径Y型孔计算的近似值。
It is also shown that the influence of the rotary inertia of the mass block on the shear failure is not negligible.
质量块的转动惯量对于剪切失效具有不可忽略的影响。
The result also denotes rotary inertia and the shear formation of the beam have significant effect on the high frequencies.
考虑梁的剪切变形和转动惯量时，对梁的高阶频率影响较大。
The result also denotes the shearing deformation and rotary inertia of the beam have significant effect on the high frequency.
当考虑梁的剪切变形和转动惯量时，则对梁的高阶频率影响较大。
To study the influence of rotary inertia on gear flowmeter natural frequency, keep damping and leakage coefficient as constant.
结果表明：与增大泄漏系数、阻尼系数相比，减小转动惯量可以明显的提高流量计的频率响应。
But when the rotary inertia of the hub is close to that of the beam, the zeroth-order approximation model may lead to wrong result.
但当中心刚体的转动惯量接近柔性悬臂梁的转动惯量时，零次近似模型将导致错误的结果。
The natural frequencies of the intelligent beam with the rotary inertia and shear deformation of the beam are lower than that without those.
考虑梁的转动惯量和剪切变形时，智能阶梯梁的频率比没有考虑时的要低。
The vibration and noise of the pump. 7 because the rotary inertia force component inside the pump is low, can work under high rotation speed.
⑥泵的振动和噪声极小。 ⑦因为泵内的回转部件惯性力较低，可在高转速下工作。
The torsional vibration method is an effective method to measure bullet rotary inertia, the key of which is the cor-responding error analysis.
扭振法是测量弹体转动惯量的有效方法，其误差分析是关键。
The effects of bending-torsion coupling, warping stiffness, shear deformation and rotary inertia are taken into account in the present formulations.
在本文研究中考虑了弯扭耦合、翘曲刚度、转动惯量和剪切变形的影响。
The rotary inertia of an ellipsoid rotating around the symmetry axis is calculated by use of the divided calculation and the extensive spherical coordinate transformation.
用分步计算和广义球面坐标变换两种方法对椭球体绕对称轴旋转的转动惯量进行了计算，计算表明，后一种方法简单、实用，在工程实际中有应用价值。
The high natural frequencies of symmetrical section beam with different constraints are calculated in detail, and effects of rotary inertia and shearing deformation are given.
计算了对称截面粱在不同边界条件下的高阶固有频率，讨论了转动惯量及剪切变形效应对各阶固有频率的影响。
The main advantages are the transverse shear deformation and rotary inertia are considered naturally, and there is no restriction on the thickness of plate and height of stiffener.
主要优越性表现为：结构的旋转惯性、剪切变形等都得到了考虑，且不限制结构的板厚度和加强筋的高度。
Based on the principle of compound pendulum, the measurement method and corresponding equipment for the centroidal deviation and the rotary inertia of rocket projectile were described.
基于复摆原理，阐述了箭弹的质偏和转动惯量的测量方法及装置，推导出了质偏和转动惯量的计算公式。
Secondly, the relationship between rotary inertia coefficient, torsional stiffness, transmission gearbox and torsional vibration frequency is analyzed on the basis of the design model.
其次，在双质量飞轮设计模型的基础上，分析了双质量飞轮转动惯量系数、扭转刚度、变速器与系统扭振频率的关系。
According to the conveyance mechanism of pipe belt conveyor, the paper analyzed the equivalent rotary inertia of pipe belt conveyor, which has certain sense for setting the soft start device.
围绕圆管带式输送机的输送机理，分析了圆管带式输送机的等效转动惯量，对于软起动装置的设定有一定意义。
The article presents design equations and techniques for the complete shaking force and shaking moment balancing of eight-bar linkages due to both linear and rotary inertia, except external loads.
本文利用质量分布和附加两种惯性配重相结合的方法，完全平衡了八杆机构的摆动力和摆动力矩。
Further analyses was made on the related rough positioning accuracy of turning accuracy and on the overcoming of rotating inertia of the rotary indexing.
进一步分析了其有关转位精度的粗定位精度与回转分度的转动惯量的克服。
Rotary kiln production process is a complex physical and chemical reaction process, with a large inertia, pure lag and nonlinear characteristics.
回转窑的生产过程是一个复杂的物理化学反应过程，具有大惯性、纯滞后、非线性等 特点。
Results of further analyses to the rough positioning accuracy of turning accuracy concerned and the rotating inertia of rotary indexing to be overcome are also given. Thus this paper is ai…
进一步分析了其有关转位精度的粗定位精度与回转分度的转动惯量的克服。
The characteristics of the radical-thrust hybrid floating-ring bearing considering inertia term were studied as the rotor-bearing is working with high rotary speed.
研究了径推动静压浮环轴承在高速运转时，计入迁移惯性项的轴承特性。
Lower inertia, lower yawp and high precision are the virtues of optical rotary encoders.
光电编码器具有低惯量、低噪声、高精度和高分辨率等优点。
Furthermore, the value of heat inertia in the hearth of copper refining rotary anode furnace in the reduction phase is so big that smoke temperature change can not quickly respond to the disturbance.
且铜精炼氧化过程炉膛具有很大的热惯性，这直接导致炉膛烟气温度动态响应速度很慢、动态过程时间很长的现象出现。
Furthermore, the value of heat inertia in the hearth of copper refining rotary anode furnace in the reduction phase is so big that smoke temperature change can not quickly respond to the disturbance.
且铜精炼氧化过程炉膛具有很大的热惯性，这直接导致炉膛烟气温度动态响应速度很慢、动态过程时间很长的现象出现。
应用推荐