The effect of high silicon low iron material on softening temperature, balling index, quality and output of sintering ore was investigated.
分析了高硅低铁物料对铅锌矿软化温度、成球性指数、烧结矿质量与产量的影响。
Cryogenic grinding has been the development trend for ultrafine grinding of plastics, especially for plastics with low softening temperature.
低温粉碎是塑料，特别是低软化温度塑料超细粉碎的发展趋势。
This paper systematically studies the effect of low softening temperature transparent glass frits composition on phosphorescence properties of photoluminescence glaze;
本文系统地研究了低温软化透明釉料组成对光致发光釉发光性能的影响；
Through the use of a radial-based function neural network(RBFNN) an intelligent forecasting model for the blended-coal softening temperature was set up under MATLAB environment.
采用径向基神经网络（RBFNN）在MATLAB环境下建立了混煤软化温度的智能预测模型。
The result showed that the tensile strength property and Vicat softening temperature was increased and notched impact property of PVC/ABS composite was decreased with the glass fiber added.
研究结果表明：随着玻璃纤维添加份数的增加，PVC/ABS合金的拉伸性能和维卡软化温度有不同程度的提高，缺口冲击强度有所下降。
Fumaric acid has a lower softening temperature and saponification value but a higher acid value, which was beneficial to improving the quality of modified rosin size and dispersed rosin size.
在加成量相同的情况下：富马松香与马来松香相比具有较低的软化点和皂化值，却有较高的酸值，有利于改善强化松香胶和分散松香胶的质量。
The best peak firing temperature was existed, which was between the softening temperature and the peak crystallization temperature, and near the incipient crystallization temperature of the glass.
电阻浆料存在最佳峰值烧成温度。理论分析表明，最佳峰值烧成温度应在软化点与峰值析晶温度之间，靠近起始析晶温度。
Samples of blended coal ash were taken from the boiler of a power plant 700mw unit. Their softening temperature was measured by a pyramid method on an intelligent ash-melting point measuring device.
从某电厂700MW机组锅炉取混煤灰样，在智能灰熔点测定仪上采用角锥法对其进行软化温度测定。
The wear of friction wafers in main clutch features uneven radical distribution. In the operation of friction wafers, high local temperature and material softening are important reasons causing wear.
分析了主离合器摩擦片的磨损具有沿径向非均分布的特点，指出摩擦片在使用过程中，局部高温和材料软化是产生磨损的重要原因。
The experimental results show that the softening effect of antihydrogen steel is evident and the temperature sensitivity varies at different temperature ranges.
结果表明，该抗氢钢的温度软化效应十分明显，且温度敏感性随温度区间而变化。
Thermal transitions. The softening point (glass transition temperature) and the melting point of a polymer will determine which it will be suitable for applications.
热转换性：聚合物的软化点(玻璃状转化温度)和熔化点决定了它是否适合应用。
The concept of "softening rate at sustained load" was suggested in accordance with the fact that the the hardness at high temperature decreases with the increase in holding time.
根据高温硬度随保载时间延长而变小这一事实，提出了“保载软化率”的概念。
At lower annealing temperature obtain high strength and high yield ratio showed cyclic softening feature easily. That is detrimental to the using life of coiled tubing.
较低退火温度获得高强度、高屈强比易表现出循环软化特征，不利于提高连续油管的疲劳寿命。
And softening point, viscosity and solidifying point of the bond decide the optimal temperature according to the mechanism of warm compaction.
通过对温压机理的分析，发现最佳温压温度由粘结剂的软化点、粘度和固化点三个因素共同决定。
The rod material is then heated to a temperature equal to or greater than the softening point of the matrix material.
杆的材料，然后加热到温度等于或大于基体材料的软化点。
Based on the results of cyclic softening and cyclic creeping tests at room temperature, the resilient relaxation tendency of the most commonly used spring steels were discussed in the paper.
本文从循环软化和循环蠕变两个不同侧面对常用弹簧钢的弹性松弛趋势进行了对比试验研究并对它们的弹性松弛趋势大小进行了初步评价。
Mechanism of damage of clay pot for utensil glass melting, such as softening deformation at high temperature, corrosion by molten glass, crack by thermal shock, etc was studied.
对熔化器皿玻璃等的粘土质坩埚使用中的高温软化变形、玻璃液侵蚀、热震开裂等损毁机制进行了分析研究。
The factors influencing the high temperature softening properties of quartz glass are discussed in detail. The Suggestions for improving the quality of china-made quartz glass tubes are proposed.
文中还详细讨论了影响石英玻璃软化性能的因素，提出了改进国产石英玻璃管质量的建议。
The lower limit of temperature at which this occurs is known as the softening point or critical temperature.
呈现这一性质的温度下限称为软化点或临界温度。
The results show that the softening ratio increases with the increase of deformation temperature and interval time.
结果表明，其静态软化率随变形温度的升高和道次间隔时间的延长而不断增加。
The results showed that the progress of softening and senescence is faster in room temperature than that in cool temperature, and can be delayed but not be inhibited.
结果表明：常温下果实软化衰老速度加快，低温显著延缓果实的软化衰老速度，但并不能阻止其进程。
Softening and flowing of bitumen at high temperature can be improved after the anti-flowing property is enhanced.
改善沥青的高温抗流动性能可减轻沥青在高温下的软化流淌。
When the abnormal temperature reaches to the softening point of special resin, its special resin changes to liquid condition.
如果异常温度达到特殊化合物的熔点，那么，保险内部的化合物呈现出液态状态。
The results showed that the glass transition temperature and vicat softening point increased obviously with the increase of the content of the terpolymer.
结果表明：随共聚物用量的增加，共混物的玻璃化温度和维卡软化点明显提高；
It studies the orderliness of chemical modification to asphalt's performances that include softening point, penetration and low temperature ductility.
详细研究了化学改性对SBR改性乳化沥青主要性能包括软化点、针入度和低温延度的影响规律。
The polyester resin synthesized by the said invented method is high in glass state temperature, high in softening point, good in storage stability and its weatherability is raised.
本发明所述方法合成的聚酯树脂玻璃化温度高，软化点高，贮存稳定性好，耐候性提高。
The modifier is used to improve the road performance, as improving softening point, low temperature ductility and the like. At the same time, the invention is good glue material.
改性剂用于改善路用性能，如提高软化点、低温延度等，同时也是很好的胶粘材料。
When the ambient temperature is higher than room temperature, the material becomes softening and its strength weakens, vice verse, the material hardens and the intensity of it increases.
三种焊料合金的温度效应也是明显的，环境温度高于室温时，材料软化，强度减弱，反之则材料变硬，强度增大。
When the ambient temperature is higher than room temperature, the material becomes softening and its strength weakens, vice verse, the material hardens and the intensity of it increases.
三种焊料合金的温度效应也是明显的，环境温度高于室温时，材料软化，强度减弱，反之则材料变硬，强度增大。
应用推荐