Textile conveyor belts - Full thickness tensile testing - Part 1: determination of tensile strength, elongation at break and elongation at the reference load.
织物传送带。全厚度拉伸试验。第1部分：拉伸强度、断裂伸长率和标准负荷下伸长率的测定。
Factory seized items: density, tensile strength, elongation at break.
本厂可检项目：密度、抗张强度、断裂伸长率。
With the increase of elastomer content, the tensile strength and elastic modulus of the blends decreased, while the elongation at break increased.
随着共混物中弹性体质量分数的增加，共混物的拉伸强度和弹性模量降低，扯断伸长率增大。
Product has outstanding advantages, acid, alkali, oil, cold, high tensile strength and elongation at break, good performance.
产品具有突出优点，耐酸、耐碱、耐油、耐寒、拉伸强度高和断裂伸长率等良好的性能。
The elongation at break, tensile strength and tearing strength of the HVSSBR cured with EV system are the best.
有效硫化体系的断裂伸长率、拉伸强度、撕裂强度、耐磨性、抗热氧老化性能最好。
The hardness gradually increased, while the tensile strength and elongation at break decreased gradually. With the elongation of time, these change gradually flattened.
硬度增大，而拉伸强度和扯断伸长率则逐渐降低，随老化时间延长，变化趋势逐渐平缓。
Their tensile strength and elongation at break were obviously dependent on irradiation dose and blending ratio of the polymers.
该膜的抗张强度和断裂伸长率则明显地依赖于辐射剂量和聚合物的混合比例。
The results showed that the sample by adding the ultrafine powders of silica aerogel increased the tensile strength 54%, the elongation at break 64%, decreased the abrasion loss 20%.
试验结果表明，加入湿法白炭黑超细粉的试样拉伸强度比添加气相法白炭黑者提高了54%，扯断伸长率提高了64%，磨耗量降低了20%。
The relationship of the tensile strength, elongation at break of the collagen film and the contents of each components were studied.
研究了胶原蛋白膜的抗张强度和断裂伸长率与膜中各组成成份含量之间的关系。
The tensile strength for LLDPE/EVA blends increases as ATH content is increased, but elongation at break decreases.
随着ATH含量的增加，LLDPE/EVA共混物的拉伸强度逐步增加，断裂伸长率迅速下降。
The experimental results show that, under vibration force field, tensile strength, tensile stress at 100% and elongation at break of TPE can be enhanced, and hardness(shore A) of TPE can be improved.
实验结果表明，振动力场的作用可以提高TPE的拉伸强度、100%定伸应力和扯断伸长，改善TPE的硬度。
The results indicated that with the increase of the content of the extender oil, the tensile strength decreased, while the elasticity increased and elongation at break improved.
结果表明：随着填充油用量的增加，拉伸强度下降，弹性回复增加，断裂伸长率也增大。
Results showed that the tensile strength decreased with increasing water contents in the film, but at the same time elongation at break was raised.
结果表明，随着PV A吹塑薄膜含水率的增加，其拉伸强度下降，但断裂伸长率增加。
In general, the tensile strength and Shore A hardness of PVC/CPE/black liquor powder composites were increased while the elongation at break was slightly decreased after thermo-oxidative aged.
添加黑液干粉的复合材料，在热氧老化后拉伸强度和邵尔A型硬度增加，断裂伸长率稍有下降。
With the increasing of mass fraction of PEG, membrane porosity and pure water flux become larger, and the maximum tensile strength and elongation at break of the membrane criterion decrease gradually.
随着PEG质量分数的增加，膜孔隙率与水通量变大，最大拉伸强度、断裂伸长率等力学性能逐渐减小。
The tensile strength and elongation at break were greatly increased by adding PPC. The properties of oil resistance and heat stability of PPC/NBR elastomers are as good as pure NBR elastomer.
PPC存在使NBR扯断强力，扯断伸长率大幅度提高，PPC/NBR弹性体具有优良的耐油及耐热氧化老稳定性。
Chemical mechanism of rubber expansion in DME was analysed, and different rubber materials were selected to test the expansion, the tensile strength, the elongation at break, and the hardness.
分析了橡胶在二甲醚中溶胀的化学机理，并选出具有不同极性的橡胶材料进行耐二甲醚溶胀及溶胀前后拉断强度、拉断伸长率、硬度等力学性能的对比试验。
The properties of the PVC envelop material modified by CPE was investigated, and the moisture permeability, tensile strength and elongation at break were also tested.
研究聚氯乙烯/氯化聚乙烯封套材料的性能，测试封套材料的透湿率、拉伸强度和扯断伸长率。
The tensile strength, elongation at break and tear strength of TAIC were higher than those of PDM while the compression set was opposited.
随着硫化助剂用量增加，TAIC共混胶的拉伸强度、拉断伸长率和撕裂强度均大于PDM共混胶，而压缩永久变形的变化率正好相反。
The haze of the LLDPE film modified by YS-1 was less than 11% , and the tensile strength and elongation at break of the modified film were all increased.
用其改性生产的透明LLDPE专用料的雾度降至11%以下；膜的拉伸强度、断裂伸长率亦有所提高。
The results showed that the tensile strength, elongation at break and tear strength increased with the OMMT content increasing.
测试结果表明，随着蒙脱土用量的增加，复合材料的定伸应力、拉伸强度和撕裂强度均大幅度提高。
The specimen by route C ECAE processing was isotropic and its impact strength increased, tensile strength decreased, elongation at break improved and show…
经C路径的二次ECAE加工后试样为各向同性材料，其缺口冲击强度较PP有所提高，拉伸强度下降，断裂伸长率提高，表现出很好的延伸性。
The result reveals that the biaxial oriented PEX pipe can increase the tensile strength by 32.29% at most, while the modulus of elasticity increasing 13.06% and the elongation at break reducing 5.88%.
通过测试环向拉伸强度，双向自增强PEX管材的拉伸强度最高可达到32.29%，弹性模量最大可提高13.06%，断裂伸长率平均减小5.88%。
In addition, photo-set block copolymer and IPN system, with regular microphase domain structure, have higher tensile strength and elongation at break than those of heat-set polymers.
此外，嵌段共聚物和IPN光固化体系形成的相畴结构均一，其抗张强度和伸长率明显高于热固化体系。
The results showed that increasing of glycerol content can decrease the tensile strength and increase the elongation at break;
实验结果表明：甘油含量的增加会降低片材的抗拉强度，但升高其断裂伸长率；
The mechanical experimental results showed that PVA had a little effect on the tensile strength, right Angle tear strength and elongation at break, and...
力学性能测试结果表明，加有pva的PE防雾膜在拉伸强度，直角撕裂强度，断裂伸长率等方面比未加PVA的防雾膜要小，但不影响其使用性能。
The results showed that unmodified nano-CaCO_3 had important effect on the improvement of the elastic modular, elongation at break and impact strength of PTFE. But the tensile strength was decreased.
结果表明：未改性的纳米碳酸钙显著提高了复合材料的弹性模量、断裂伸长率和冲击强度，但复合材料的拉伸强度有所降低。
The plasticizer also reduced the tensile strength, yet to enhance the elongation at break of films.
在机械特性方面，塑化剂之添加会使抗张强度下降及形变率增加。
The plasticizer also reduced the tensile strength, yet to enhance the elongation at break of films.
在机械特性方面，塑化剂之添加会使抗张强度下降及形变率增加。
应用推荐