The apparent viscosity at the point decreases distinctly with shear rate increasing.
随着剪切速率的增加，转相点的视粘度明显下降。
As the shear rate increased, the apparent viscosity of the solution gradually decreased.
随着剪切速率的增大，溶液的表观粘度逐步下降。
The apparent viscosity at the point decreases distinctly with the increment of shear rate.
随着剪切速率的增加，转相点的视粘度明显下降。
The effect of high substitution on the apparent viscosity was obvious, but PH value is not.
取代度对羟丙基淀粉溶液的表观粘度有较明显的影响；
To measure the apparent viscosity (Bitumen no) of filler aggregates used in bituminous mixtures.
为了衡量在沥青混合料填料的应用总量的表观粘度(沥青否)。
A new measurement system about the apparent viscosity of the blood with microphotography was studied.
本文研制了一种新的血液显微表观粘度测定系统。
Furthermore, the apparent viscosity of HDPE was reduced, which could increase the extrusion efficiency.
同时使体系的粘度也有所降低，提高挤出效率。
It was believed the processability of UHMWPE was improved by the decrease of the apparent viscosity by HBP.
初步认为HBP通过降低混合熔体的表观粘度来改善UHMWPE的加工流动性。
The results showed that the use of PA6 improved the apparent viscosity, mechanical properties and thermostability of IFR-PP.
结果表明：PA6的加入提高了IFR PP的表观粘度、力学性能和热稳定性。
Shear rheological data showed that the apparent viscosity increased with the addition of a certain amount of chain extenders.
剪切流变数据表明：加入一定量扩链剂能够增加熔体的表观粘度。
Capillary flow test showed that, RH100 can reduced the apparent viscosity and improve the flowing ability of rubber compound.
毛细管流变测试表明，RH100使胶料的表观粘度降低，改善加工流动性。
The results show that the dispersant and its dosage not only influence the apparent viscosity but also the rheological behavior of CWS.
结果表明，分散剂的种类和用量不仅影响CWS的表观黏度而且还影响其流变特性。
The surface tension and the apparent viscosity of hydroxyethyl cellulose (HEC) solution are hardly affected by the addition agents and are stable.
羟乙基纤维素（HEC）溶液的表面张力和视粘度很少受添加剂的影响，很稳定。
It has been found that the apparent viscosity of PBR is sensitive to shear rate, shear stress, and to temperature at lower shear rate levels as well.
表观粘度对切变速率和切应力较敏感，并且，在低切变速率下对温度也较敏感。
With the reducing of pore pressure, the apparent viscosity of post-liquefied sand increased with increasing of strain and decreasing of pore pressure ratio.
随着液化后孔压的降低，砂土的表观粘度随应变的增大而增大，随孔压比的减小而增大。
The results show that the apparent viscosity of A356 alloy slurry in steady-state decreases with the shear rate increasing under isothermal shearing condition.
结果表明：等温剪切时，浆料稳态表观粘度随着剪切速率的增大而下降，半固态a 356铝合金具有明显的触变性。
Both temperature and water cut have notable impacts on flowing characteristics of the oil. When the temperature increases, the apparent viscosity will decrease.
温度和含水率对含水超稠油的流动特性均有明显的影响，温度升高，视粘度下降。
The apparent viscosity of the pastes was decreasing as the milled-time was getting longer, resembled Newtonian fluid in shear-thinning nature and low thixotropy.
球磨时间越长的样品，其糊的表观粘度越低，越偏近牛顿流体，触变性和剪切稀化也越低。
The analysis of microstructure can also reflect the regulation of the effect on the apparent viscosity of factors, such as shear rate, temperature and cooling rate.
显微结构分析也可以反映出剪切速率、温度和冷却速度对表观粘度的影响规律。
The result of the apparent viscosity analysis indicated that the polymerization degree of the chitin molecule was maintained well through the normal temperature, process.
表观粘度分析结果表明常温处理可较好地维持甲壳素分子的聚合度。
Based on experiment and data calculation, this viscosity model could sensitively and quantitatively reflect the impact of the processing parameters on the apparent viscosity of the melt.
依靠实验及数据计算，检验此模型能够灵敏地定量反映外部加工条件对熔体表观粘度的影响。
The effect of pressure on the apparent viscosity and plastic viscosity is considerable at ambient temperature. However, this effect is reduced gradually with the increase in temperature.
常温时压力对表观粘度和塑性粘度影响很大，但随着温度升高，压力的作用逐渐减小。
With the concentration of the polymer solution increasing, acoustic velocity of the polymer solution decreases, and the polymer density decreases too, but the apparent viscosity increases.
随着聚合物溶液浓度的增加，其声传播速度减小，其密度值也逐渐减小，但其表观粘度值逐渐增大。
The phenomenon of increasing shear force, and decreasing apparent viscosity, showed that it was a kind of Pseudo plastic Fluid. As the temperature increased, the apparent viscosity decreased.
表观粘度测定显示辛烯基琥珀酸淀粉酯具有剪切变稀现象，属于假塑性流体，表观黏度随着温度升高而下降。
Experiments reveal that the apparent viscosity of the melt flameretardant PP decreases with increasing additive. The breaking strength of flameretardant PP fiber decreases with increasing additive.
结果表明，随阻燃剂的增加熔体的表观粘度下降，并且阻燃纤维的断裂强度也下降。
The calculation results showed that the friction factor and apparent viscosity of hydrate slurries increase with increasing pressure and flow rate.
计算结果表明，压力高和液体流量大的体系，其摩擦阻力系数和表观粘度值均较高。
The calculation results showed that the friction factor and apparent viscosity of hydrate slurries increase with increasing pressure and flow rate.
计算结果表明，压力高和液体流量大的体系，其摩擦阻力系数和表观粘度值均较高。
应用推荐