The diagnosis and identification of the crack length for the disk parts is attached importance to.
所以圆盘类零件裂纹长度的诊断识别问题越来越受到重视。
The smaller the curvature and the larger the crack length the smaller will be the fracture stress.
曲线半径越小，裂纹长度越大，断裂应力也就越低。
For fracture rock, the fracture stress will be reduced and the crack length will increase under the chemical corrosion.
对于裂隙岩体来说，化学溶液的腐蚀则主要体现在断裂应力的减小和裂隙的增大。
For a given specimen and notch configuration, maximum load is always dependent on the crack length and independent of the material.
对于特定的试样和裂口几何形状，最大荷载与裂纹长度有关，而与材料无关。
The crack-tip dynamic stress intensity factors decrease with the decrease of the crack length and the increase of the functionally gradient parameter.
无论在什么时刻，裂尖处动态应力强度因子随裂纹的长度减小而减小，随板材料的功能梯度参数增大而减小。
The numerical examples are provided to show the influences of the material properties, the wedge Angle, dislocation position and the crack length on the interaction.
最后通过数值算例，针对不同问题讨论了材料常数、楔口角度、裂纹长度对相互作用的影响。
Meanwhile, the influences of pipeline internal pressure, wall thickness, crack arrest length and initial crack velocity on the crack driving force (crack propagation) are further studied.
进而分析了管道内压、壁厚、裂纹止裂长度和初始裂纹速度对裂纹驱动力(也即裂纹扩展)的影响。
The preventive maintenance sections are divided by using dynamic cluster method and three indexes including rutting depth, transverse crack length and skidding resistance.
采用车辙深度、横向裂缝长度和路面抗滑性能指数三指标，使用动态聚类法，划分预防性养护路段。
The initial crack length of engineering components usually be defined subjectively but not objectively.
工程构件的初始裂纹长度是人为规定的，不具有客观性。
This paper provides reliability analysis based on different stability analysis theory and calculates the critical crack length of an engineering example as a reverse problem to stability analysis.
基于上述分析，将对各种稳定性研究技术通过实例进行深层对比，并对作为稳定性分析反问题的临界裂纹长度计算进行了工程实例的验证。
Statistic data were obtained by tests and dissections and the relationships between crack length, width and depth were given as a reference for crack depth evaluation.
通过大量检测试验和解剖，得出统计规律数据，从而得到裂纹长度、宽度与深度之间的对照表，对裂纹深度的评估有一定的参考价值。
The simulating results have indicated that: the crack closure effect is obviously influenced by the fatigue crack length.
在建立裂纹扩展模型的时候，要考虑到裂纹长度对裂纹闭合效应的影响。
An automatic compliance crack length measurement system for fatigue crack propagation test was used in the experiments.
研究中应用了一种柔度法疲劳裂纹自动测量系统进行裂纹长度测量。
Short cracks propagation research: the degree of Microscopic structure influence to the fatigue crack propagation depends on crack length.
短裂纹扩展研究：微观组织结构对疲劳短裂纹扩展的影响程度取决于裂纹的长度。
The distribution function of crack length at given time can be calculated by integration of the initial crack length distribution and the transition function of Markoff process.
文中导出了用初始裂纹长度的分布及马尔可夫转移概率密度函数计算给定时刻裂纹长度分布的积分公式。
Reconstructed model technique is successfully applied to measure short fatigue crack length in the testing work.
将复型技术应用于疲劳小裂纹扩展试验中的裂纹长度测量。
The polypropylene fiber can effectively control the length, width and number of the drying shrinkage crack of early-age concrete.
聚丙烯纤维可有效控制混凝土早期干缩裂缝的长度、宽度和数量。
Experiments on the air infiltration by tracer gas method and obtains the range of air infiltration rate per unit length of the crack.
采用示踪气体法对塑钢窗冷风渗透量进行了实验，得出了塑钢窗单位长度渗风量的范围。
The specimen with larger crack length has larger volume fraction of the martensite and larger transformation zone.
马氏体的体积分数以及相变区域随着裂纹长度的增加而显著增大。
The direction, length, average and maximum width of crack can be found out in any concrete crack image.
对于混凝土裂纹图像，算法能够找出裂纹的走向、长度、平均宽度和最大宽度。
The crack limit length of gantry crane metal structures under the work conditions is found through a large number of experiments and theory analyses.
通过大量的实验和理论分析，找出了龙门起重机在工作状态下金属结构的裂纹限制长度。
It is shown that in general cases, the field intensity factors increase as the ratio of crack length to hole-size become large.
结果表明：应力强度因子随着裂纹和孔的相对尺寸的增加而增加。
On the basis of this, an automatic measurement technique of fatigue crack length in fatigue crack growth rate test under corrosive circumstance is established.
在此基础上，建立了腐蚀环境下疲劳裂纹扩展速率试验中裂纹长度的自动检测技术。
Form displacement, strain, length of crack and so on, we can see timber frame meeting the challenge of anti-seismic, the results show that the frame has good anti-seismic performance.
从试验中得到的位移、应变、裂缝开展等数据，可以看出木构架房屋满足抗震设防要求，具有很好的抗震性能。
The width and depth of the widest crack increase with the increase of the length of the wall.
最大裂缝宽度和深度随着墙体长度的增大而增大。
The crack growth rate without the influence of crack surface contact was determined by extrapolating the relationship between the crack growth rate and the crack extension to the zero crack length.
通过外插裂纹扩展速率与裂纹长度之间的关系， 可近似得到裂纹长度为零时无裂纹面滑移接触影响的裂纹扩展速率。
The crack control methods of analysis and design in the super-length reinforced structure have been tested in the project, and reached the effect to be hoped.
对钢筋混凝土结构的裂缝控制实现超长设计的分析和设计对策，经过工程验证，达到了预期的效果。
The structure integrity of HK40 reformer tube is studied in respect of the controlling parameter of creep crack growth, the critical crack length and the residual life.
分别从蠕变裂纹扩展的控制参数，临界裂纹长度及剩余寿命三方面对HK40转化管进行了结构完整性研究。
The structure integrity of HK40 reformer tube is studied in respect of the controlling parameter of creep crack growth, the critical crack length and the residual life.
分别从蠕变裂纹扩展的控制参数，临界裂纹长度及剩余寿命三方面对HK40转化管进行了结构完整性研究。
应用推荐