With the change of the grain size, the dielectric properties changed.
随着粒径的变化，介电性质也随之变化。
The dielectric constant decreased significantly under large DC bias level.
在较大的直流偏压场下，介电常数大幅度降低。
It is rather complicated to evaluate the dielectric tensor of composite media.
而复合介质的电介质张量的计算相当复杂。
In this thesis, we report the dielectric constants of different semiconductors.
在本文中，我们报告了不同的半导体的介电常数。
This parameter is the current flowing through the sample subjected to the dielectric.
此参数受电流所通过的样品中的电介质的影响。
The effect of the dielectric coatings on semiconductor laser performance is presented.
简要叙述了介质镀膜对半导体激光器性能的影响。
The method and principle of falling the dielectric constant of polymer were introduced.
本文介绍了降低聚合物介电常数的方法，原理。
Use ceramic materials as the dielectric, silver as electrode, and metal plate as shell.
用陶瓷材料做电介质，金属银做电极，金属极板做外壳。
So it has become a hot domain in the electrical research to measure the dielectric loss .
因此对电气设备绝缘介质损耗的测量已逐渐成为国内外电气研究中的一个较热门的领域。
The dielectric voltage-withstand test apparatus shall be in accordance with Clause 16.20.
绝缘体的耐压性能测试设备要能达到第16.20条中所列标准。
The secondary electron emission from the dielectric layer makes the discharge current increase.
绝缘介质层的二次电子发射，使放电电流增大。
The Dielectric Withstand test is the third test required by the electrical safety testing standards.
电气强度试验是电气安全性能测试标准所要求的第三项测试。
The square root and the cubic root of the dielectric constants are linearly related to the volume ratios.
介电常量的二次及三次方根与密度成线性关系。
The dielectric, optical and optic damage properties of KTP crystal are analyzed in this dissertation.
分析了KTP晶体的介电特性、光学特性和光损伤特性等主要性质。
The equivalent circuit of the coupling between the dielectric resonator and microstrip is proved then.
接下来详细推证了介质谐振器与微带线间耦合的等效电路。
Dielectric ceramic, method for manufacturing the dielectric ceramic, and monolithic ceramic capacitor.
介电陶瓷，制造该介电陶瓷的方法，以及单片陶瓷电容器。
The dielectric constant and dielectric loss of the composites rise with increasing the content of PANI.
复合材料的介电常数和介电损耗随pani含量的增加而上升。
The phenomenon of fingerprint discharge along the dielectric film surface is observed by dynamic method.
利用动态指纹提取方法观察到了手指在介质层表面产生的沿面放电现象。
Also the result shows that, as sintered in reducing atmosphere, the dielectric loss of the material increase.
研究的结果还表明，由于在还原气氛中烧结，材料的介电损耗上升。
The metal particles removed from the die block are washed away with the dielectric fluid which is circulated.
从模块上去除地金属屑被循环流动地电火花加工液冲走。
And the charge density of oil streaming electrification is related to the dielectric loss factor and conductivity.
而且油流带电电荷密度与介质损耗因数和电导率有一定的相关性。
Research on the dielectric barrier discharge nitrogen nitriding at atmospheric pressure have consumedly progressed.
利用介质阻挡放电进行常压氮气渗氮研究取得突破性进展。
For microwave diffraction imaging, we use the WKB approximation to estimate the total field in the dielectric object.
对于介质目标微波衍射成象，本文引入了WKB近似来模拟目标内部总场。
It was found that the dielectric constant and dielectric loss of unpoled samples is higher that those of poled samples.
结果表明：极化后的介电常数和介电损耗低于极化前。
The dielectric and interface characteristics of STO with a metal insulator semiconductor (MIS) structure were investigated.
研究了STO薄膜金属绝缘体半导体(MIS)结构的介电和界面特性。
According to the dielectric barrier discharge photography, a one dimension model of dielectric barrier discharge is developed.
以介质阻挡放电照相技术为背景，建立了介质阻挡放电的一维模型。
A design method of the dielectric-covered slots arrays in the narrow face of a rectangular wave-guide is presented in this paper.
本文提供了带共形罩矩形波导窄边缝隙天线阵的一种设计方法。
As shown in FIG. 1, the feed conductor 106, and the grounding conductor 108 are carried on a portion of the dielectric support 110.
如图1所示，在电介质支撑件110的一部分上承载该馈送导体106及接地导体108。
Study indicated that oxygen deposition pressure exerts a strong impact on the microstructure and the dielectric properties of the films.
采用不同的沉积氧气压，分析了其对薄膜微观结构和介电性能的影响。
Study indicated that oxygen deposition pressure exerts a strong impact on the microstructure and the dielectric properties of the films.
采用不同的沉积氧气压，分析了其对薄膜微观结构和介电性能的影响。
应用推荐