According to it thermodynamic temperature scale can be realized.
根据它可以用理想气体实现热力学温标。
The sI UNIT of absolute thermodynamic temperature, honoring BARON WILLIAM THOMSON KELVIN.
绝对热力学温度的国际单位，以此纪念威廉姆·汤姆森·开尔文爵士。
Such as kilogram of mass unit , Kelvin of thermodynamic temperature , Joule of energy unit , Ampere of electric current intensity and Newton of force unit and so on?
比如，质量单位千克，热力学温度开尔文，能量单位焦耳，电流强度单位安培，力单位牛顿等。
Kelvin of thermodynamic temperature unit is consists of 4 dimensional space, minus 4 dimensional time and an coefficient of 22.77, its physical expression has upgraded into.
热力学温度单位开尔文是由4维空间，负4维时间和系数22.77构成的，其物理学表述升级为。
Thermal energy: Internal energy of a system in thermodynamic equilibrium by virtue of its temperature.
热能：处于热力学平衡状态的系统由于它的温度而具有的内能。
How does the time taken to establish thermodynamic equilibrium depend on the temperature in the experimental cell?
怎么花费的时间建立热力学平衡取决于在实验性细胞的温度？
Simulates the thermodynamic characteristic of the air side heat exchanger of an air source heat pump under different air temperature and relative humidity.
用计算机模拟空气源热泵风侧换热器在不同环境温度和相对湿度条件下运行的热力特性。
Ideal gas offers a simple example of application and a simple thermometer for thermodynamic scale of temperature.
理想气体为热力学理论提供了一个简单的实例，为测量热力学温度提供了一种简单的温度计。
The results indicate that the optimal reaction temperature for SE-SMR was affected by the reaction thermodynamic and kinetics.
结果表明，吸收增强式制氢反应过程最佳反应温度受热力学和动力学两方面因素影响；
A method of calculating hydraulic and thermodynamic parameters such as flow, ratio of water in oil, pressure, temperature, specific heat for oil, gas, water pipe net is presented.
文中给出了油、气、水管网系统的水力、热力参数，包括流量、含水率、压力、温度、比热等的计算方法。
The dimensional regularization at finite temperature is applied to calculate accurately the thermodynamic potential of two-loop QED and the overlapping divergences at arbitrary gauge.
采用有限温度下维数正规化的方法在任意协变规范下精确地计算了双圈QED的热力学势及其交叉发散。
Thermodynamic principle of heat recovery system for low temperature waste heat with a given initial temperature and flow and for non-cycling operation is proposed in the article.
本文针对初温、流量一定且不循环使用的低温余热，提出确定其动力回收系统参数的热力学原则。
By introducing the law of thermodynamic and the concepts of temperature, intrinsic energy and entropy.
从热力学定律出发，引入温度、内能，熵的概念。
Evaluating exactly and fast heat economy of unit caused by heater terminal temperature difference is significant meaning for the design, operation and repair of thermodynamic system.
准确而快速地评价各级加热器端差的运行热经济性，对热力系统的设计、运行和检修具有十分重要的意义。
According to the thermodynamic equations, the laws of ladle lining temperature distribution and the real-time temperature of molten steel in ladle during tapping are calculated.
根据传热学方程，计算了电炉出钢过程钢包炉衬温度分布及钢水温度随时间变化的规律。
Taking the thermodynamic system of radiator testing stand as a controlled object, studies the fuzzy control process of rule self-tuning for supply air temperature in air circulation systems.
提出了一种模糊控制规则实时校正算法，并以散热器实验台热工系统为被控对象，研究了风循环系统送风温度的规则自校正模糊控制过程。
The preliminary explanation for the effects of ionic strength and temperature on the adsorption process were discussed based on those kinetic and thermodynamic data.
结合这些动力学与热力学参数，初步解释了离子强度与温度对吸附过程的影响。
So, a thermodynamic representation of the cosmic censor conjecture is proposed by us, as that it is forbidden that the temperature of an event horizon approaches zero or goes infinity.
由此，提出宇宙监督原理的一种热力学表述：在视界上， 绝对温度为零或趋于无穷大均是不允许的。
The maximum temperature of ideal gas in thermodynamic processes are calculated.
给出理想气体任意过程最高和最低温度的三种计算方法。
According to the thermodynamic calculation theory and practical operating experience, this thesis analyzed and searched for the reasons of high Exit gas temperature.
本文根据锅炉运行经验和热力计算理论，分析查找排烟温度高的原因。
The thermodynamic properties also calculated for different phase and low temperature properties at quarter filling are studied in details.
还计算了不同相的热力学性质并详细研究了四分之一填充的低温性质。
The calculating results below the room temperature can be integrating to the thermodynamic database.
室温以下的计算结果可以用来补充了热力学数据库信息。
Adiabatic combustion temperature at various oxidizer mass flow rates and grain length is obtained by thermodynamic calculation and has a maximum as oxidizer mass flow rate increases.
利用热力计算得到了绝热燃烧温度与氧化剂流率和药柱长度的变化规律，绝热燃烧温度随氧化剂流率的增加存在一最大值。
The formation of soil moisture inversion is related with the state of soil temperature and moisture, the intensity of atmospheric humidity inversion, and the atmospheric thermodynamic stability.
土壤逆湿的形成与土壤温度状态、大气逆湿强度和大气稳定度都有关。
The thermodynamic model was established for analyzing the temperature and the thermal stress in laser medium.
为模拟激光介质的温度、热应力的分布和变化，建立了激光介质热力学计算模型。
According to the characteristic of glass molding, such as metallography and thermodynamic, paper analyzes the conglutination between metal and glass at high temperature.
依据玻璃成型的特点，从金属学和热力学角度，分析了金属与玻璃之间的粘结及金属在高温下氧化对玻璃模具选材的制约。
It is necessary to determine chemical equilibrium compositions for the calculation of combustion and thermodynamic processes of high temperature gases in various devices.
燃烧过程和高温气体热力过程的计算需要求解燃气的化学平衡成分。
The electronic density of states (DOS) of the system as well as low temperature thermodynamic quantities are obtained under the saddle point approximation.
在鞍点近似下，求得了系统的电子态密度和一些低温热力学量。
The electronic density of states (DOS) of the system as well as low temperature thermodynamic quantities are obtained under the saddle point approximation.
在鞍点近似下，求得了系统的电子态密度和一些低温热力学量。
应用推荐