To avoid sliding that occurs in cylindrical roller thrust bearings, the taper Angle of the rollers is selected so the extended contact lines intersect on the bearing axis.
为了避免推力圆柱滚子轴承发生滑动，滚子的锥度要合适以至于扩大的接触线可以与轴承轴相交。
Particularly with Taper Roller Bearings sufficient support of bearing rings by the adjacent parts is required due to the generated internal thrust force components.
尤其是圆锥滚子轴承的轴承环的邻近部位足够的支持是必需的，由于所产生的内部推力组件。
The cage which retains the cylindrical rollers of the cylindrical roller thrust bearing is an injection moulded glass fibre reinforced polyamide 6, 6 cage (FIG 6).
保持圆柱滚子推力轴承圆柱滚子的保持架，是注射成型的玻璃纤维增强聚酰胺6.6保持架(图6)。
The alternate roller bearing in FAG bearing, can bear at the same time come from each direction loading like axial, thrust or momentum loading.
FAG轴承中的交叉滚子轴承，能同时承受来自各方向荷重（如轴向、推力或动量荷重等）。
The tapered roller bearing replaces axial thrust ball bearing.
采用圆锥滚子轴承取代现有的轴向推力球轴承。
Also, the calculation formula of the contact stress, the fatigue strength and the static strength for the small thrust bearing which are attached at the end face of roller are derived.
同时又对滚子端面的小型推力球轴承推导出接触应力、疲劳强度和静载强度的计算公式。
Roller type thrust bearing can give simple design structure and easy to maintain and lower requirement of it's lubrication condition, but give shorter using life comparatively.
球面辊子推力轴承结构简单，对环境要求相对比较低，但寿命较短。
Combined needle roller bearings consist of a radial needle roller bearing combined with a thrust bearing and are consequently able to take up both radial and axial loads.
组合式滚针轴承是由一个向心滚针轴承和一个推力轴承相结合，因此能够承受径向和轴向负荷。
Thrust needle roller bearing is a bearing.
推力滚针轴承是轴承的一种。
It comprises a double-direction cylindrical roller thrust bearing with two rows of rollers and a single-row full-complement radial cylindrical roller bearing (Figure 1.57).
它包括一个具有两列滚子的双向推力圆柱滚子轴承和单列径向滚子轴承。
When thrust must Be accepted, the tapered roller Bearing of the type sketched in Fig. 9. 3 (B) is employed.
当必须承受轴向力时，则用图9.3 (b)所示的圆锥滚于轴承。
When thrust must Be accepted, the tapered roller Bearing of the type sketched in Fig. 9. 3 (B) is employed.
当必须承受轴向力时，则用图9.3 (b)所示的圆锥滚于轴承。
应用推荐