The volumetric heat transfer capacity of plate cooler is 1.5 times as that of fin-tube cooler and 15 times as that of tube cooler.
板式空冷器单位体积换热量约是翅片管式空冷器的1.5倍，是光管式的15倍；
A ferroalloy electric furnace smoke remaining heat recycling hot tube cooler, is comprised of inner cylinder, outer cylinder and hot tube.
一种铁合金电炉烟气余热回收用热管降温器，由内筒体、外筒体和热管组成；
Regenerator is one of the key components of pulse tube cooler, and its efficiency can greatly influence the performance of pulse tube cooler.
回热器是脉管制冷机的关键部件之一，其效率对脉管制冷机性能有很大影响。
A lowest no-load temperature of 13.8 K has been obtained for the first stage without thermal connector, which is a new record for the single-stage pulse tube cooler.
在没有热桥连接的情况下，单独测试第一级最低制冷温度达到13.8K，这是单级脉管制冷机获得的最低制冷温度新纪录。
Use single stage version to reach the temperature of 20 K is a difficulty for high frequency pulse tube cooler (PTC). Multi-stage version is a popular method to reach the low temperature.
单级高频脉冲管制冷机直接降低到20K以下温区存在很大困难，采用多级方案是高频脉冲管制冷机获得更低温度的主要方法。
It establishes the basis for the design, optimization and application of tube type indirect evaporative cooler.
为管式间接蒸发冷却器的设计、优化和推广应用奠定了基础。
Aimed at the leaking and tube blasting of melt salt cooler, analyzes various reasons for the corrosion, and presents relative countermeasures, obtaining good results.
针对熔盐冷却器发生泄漏及产生爆管的现象，分析可导致腐蚀的各种原因，并提出了相应的对策措施，取得了良好效果。
The bimetallic rolled finned tube high pressure air cooler is applied in first time on diesel hydrogenated unit of Jinan refinery.
双金属轧制翅片管高压空冷器首次用于济南炼油厂柴油加氢装置。
After presenting the initial design of a heat pipe oil cooler which is used to renew the shell-and-tube oil cooler the paper describes its reasonableness and economy.
并且就电厂换热设备之一的管壳式冷油器更新为热管式冷油器的初步设计论述了其合理性和经济性。
Lots of experimental research has been done on the new double-flow lubricating-oil cooler which has mixed tube bundles, and it is found that such cooler has very strong heat transfer ability.
通过对新型混合管束式双流程滑油冷却器的大量实验研究，发现其具有很强的换热能力。
The air cooler is designed of nullity fin oval stainless steel bellows tube bank replacing conventional fin tube bank. It is a technological innovation designing and manufacturing of The air cooler.
空气冷却器采用无翅片椭圆不锈钢波纹管管束替代传统的翅片管管束，是空气冷却器设计制造的技术革新。
A temperature induced tube made from new material is used on self regulating cooler, instead of the former stainless steel temperature induced tube.
使用了一种新型材料制成的感温管，代替了微型节流制冷器原来自调机构的不锈钢感温管。
Against the existing problem on the spraying system of cross tube primary gas cooler, the respective modification measure has been taken, the cooling effect and safe delivery of gas were ensured.
针对横管初冷器喷洒系统存在的问题，采取了相应的改造措施，确保了煤气的冷却效果和安全输送。
Air cooler and oil cooler shall be made of red copper, albata seamless tube or other corrosion prevention tubing.
3空气冷却器和油冷却器应采用紫铜、铜镍合金的无缝管或其他防锈蚀的管材。
The elliptical fin-tube is the cooling element of direct air cooler tubing.
椭圆翅片管是直接空冷器管束上的冷却元件。
The cooling mechanism of the turbulent flow cooler is studied. The choosing range of the input Angle and output Angle of turbulent tube, the diameter of the throat mouth and water gap are discussed.
研究湍流管式冷却器的冷却机理和设计问题，讨论了湍流管入口角、出口角、喉口直径和水缝的选择范围。
The corrosion causes on the Cross-tube gas final cooler were analyzed in the pa per and the anti-corrosion measures were proposed.
本文分析了煤气横管终冷器的腐蚀原因，并提出了相应的防腐措施。
Test, fabrication and measurement of the explosive method used in the expansion of tube with tube sheet in a water cooler are discussed.
介绍用爆炸法胀接水冷器管子和管板的试验、制造和测试数据。
Shell & Tube oil cooler is mainly used on cooling the diesel engine oil of the medium- and heavy-duty trucks, co…
管壳式油冷器主要用于卡车、工程机械、船舶等中大马力柴 油发动机的机 油冷 却。
Shell & Tube oil cooler is mainly used on cooling the diesel engine oil of the medium- and heavy-duty trucks, co…
管壳式油冷器主要用于卡车、工程机械、船舶等中大马力柴 油发动机的机 油冷 却。
应用推荐