One reason that climbing is not the best method of strength training is because the ultimate goals of "training" versus "climbing" are very different.
说攀爬不是最佳的力量训练方法，原因之一是因为“训练”对比“攀岩”的最终目标是非常不一样的。
A simplified analysis method for the ultimate strength of ship's hull girder under cyclic bending was proposed.
给出了循环弯曲载荷下船体梁极限强度的简化分析方法。
Then, the compound method is used to assess the hull girder ultimate strength reliability of a bulk carrier subjected to extreme bending moments.
最后，基于极限强度，将该组合方法用于评估散货船在极值弯矩作用下的船体梁安全性。
Progressive collapse method is used to calculate ship ultimate hull girder strength and the combination of surface response method and traditional method is utilized to analyse reliability.
采用渐进崩溃法计算船体总纵极限强度，将响应面法与传统可靠性计算方法相结合来进行船体总纵极限强度可靠性分析。
This article proposed a new analytical method for the ultimate strength of unbonded prestressed concrete beams according to the principle of equivalent deformation.
本文根据交形等效的原理，提出了无粘结预应力梁极限强度的分析方法。
In this paper, finite element method was used to study the ultimate strength and fatigue life of dented riser.
本文采用有限元方法研究凹陷立管的极限强度和疲劳寿命。
Based on the method, a simple formula calculating, the ultimate strength of unbonded prestress tendons was deduced.
根据这种方法推导出简便的无粘结预应力筋极限应力计算公式。
The formula for calculating the ultimate stress of unbonded post tensioning tendons and the calculating method of ultimate flexural strength of UPPC beam Bridges are proposed.
在此基础上给出了无粘结预应力筋极限应力计算公式和UPPC梁正截面抗弯强度计算方法。
The method to determine ultimate lateral resistances based on soil strength parameters was established by analyzing the failure mode of liquefying saturated strata.
通过分析土层在液化过程中的破坏模式，提出了依据弱化土强度参数确定其水平极限抗力的方法。
This paper suggests a calculation formula for eccentrically loaded brickwork or column with biaxial bending in terms of ultimate strength design method.
本文按照极限状态的设计方法，提出了砌体（柱）在双向偏心压力作用下的计算公式。
The basic mechanics performance of solar cell was tested by small punch method, and elastic modulus and ultimate strength was obtained.
采用小型冲压实验方法对太阳电池片的基本力学性能进行测试，获得太阳电池片的弹性模量和断裂强度等参数；
The ultimate flexural strength of SRC beam calculated by using this method is averagely 26 percent smaller than that of test.
应用该方法计算所得梁的受弯承载力比试验值平均小26%。
The simplified analysis methods of ultimate strength are finally discussed and the method of limit equilibrium is recommended.
探讨了该类构件承载力的简化计算方法，并建议采用极限平衡法求解。
With the method, each mechanical stage of this kind of structure could be simulated and calculated including crack moment, ultimate strength, stresses and deflections of all stages more precisely.
利用该方法可以对结构的各受力阶段进行模拟计算，得出各阶段预弯钢梁、一期混凝土、二期混凝土的应力和结构变形，并能计算出预弯组合梁的开裂荷载和极限破坏荷载。
With the method, each mechanical stage of this kind of structure could be simulated and calculated including crack moment, ultimate strength, stresses and deflections of all stages more precisely.
利用该方法可以对结构的各受力阶段进行模拟计算，得出各阶段预弯钢梁、一期混凝土、二期混凝土的应力和结构变形，并能计算出预弯组合梁的开裂荷载和极限破坏荷载。
应用推荐