Replaceable Stainless Steel Seat and Valve Disc.
可更换不锈钢阀座和阀门阀瓣。
To replace the relief valve disc, hold the upper guide fin and unscrew the diaphragm pressure plate.
要更换安全阀阀瓣，握住上部引导翼，旋下隔膜压力板上的螺丝。
Tighten the inner hexagon bolt whose function is to prevent valve disc from rotating and breaking the springs.
拧紧防止阀板转动的内六角螺栓，其作用是防止阀板转动拧断弹簧。
There is limit block on the valve disc to ensure the open-close position , which is controlled by the stroke switch.
阀门的启闭位置由行程开关控制，且阀板上设有限位挡块以保证阀板的启闭位置。
Slamming of check valves is the result of failure of the valve disc to reach its closed position before the fluid flow reversal.
止回阀的撞击现象，是由于在流体倒流之前，阀门的阀瓣没有到达关闭位置造成的。
The utility model is mainly composed of electromagnet, a valve core, a valve disc, a chassis, a connecting pipe and a guide frame.
它主要由电磁铁、阀芯、阀盘、底盘、连接管和导架组成。
CCD electric ultra-high vacuum gate valve USES electric device to drive the stem, moving valve disc up down to make the valve opened closed.
CC D型电动超高真空插板阀是通过电动装置驱动阀杆带动阀板作上下运动，达到阀门的开启或关闭。
CCD electric ultra-high vacuum gate valve USES electric device to drive the stem, moving valve disc updown to make the valve opened or closed.
CCD电动超高真空插板阀是通过电动装置驱动阀杆带动阀板作上下运动，达到阀门的开启或关闭。
GDC-JQelectro high vacuum butterfly valve USES electromagnetic force to directly drive valve disc working. thus to make valve opened ro closed.
GDC - J型电磁高真空挡板阀是以电磁力为动力直接带动阀板动作，使阀门开启或关闭。
CCD electric ultra-high vacuum gate valve USES electric device to drive the stem, moving valve disc up and down to make the valve opened or closed.
真空插板阀是通过电动装置驱动阀杆带动阀板作上下运动，达到阀门的开启或关闭。
CCD electric ultra-high vacuum gate valve USES electric device to drive the stem, moving valve disc up and down to make the valve opened or closed.
CC D型电动超高真空插板阀是通过电动装置驱动阀杆带动阀板作上下运动，达到阀门的开启或关闭。
To Clean: Inspect or replace worn valve disc, disconnect control pipe and unscrew bonnet from valve body using blunt tool and hammer on bonnet lugs.
清洗：检查或更换磨损的阀瓣，断开控制管道的连接，采用钝工具和锤子敲击阀帽上的接片，然后旋松阀帽螺纹。
To CLEAN: Inspect or replace worn valve disc, disconnect control pipe and unscrew bonnet from valve body using blunt tool and hammer on bonnet lugs.
清洗：检查或更换磨损的阀门阀瓣，断开控制管线，采用钝工具和锤打阀盖凸耳从阀体上旋下阀盖。
Flow vibration in turbine control valve is the major consequences of valve stem rupture, valve disc damage as well as the resonance of valve and its pipings.
调节阀的流体振动会造成阀杆疲劳断裂与阀碟的损坏，以及整个阀门及管道系统的共振。
The valve consists of a guard cage, spring, valve disc, retaining ring and seat. It can be combined with pipe fittings such as reducing couplings, drain elbows, etc.
阀由警戒装置、弹簧、阀碟、扣环和阀座组成，可以和许多管件连接，如缩径管接头、排水弯头等。
The research on comparing the performance parameters of flexible disc and rigid disc is of great significance for the reconstruction and design of safety valve disc.
通过柔性阀瓣与刚性阀瓣各项性能参数的对比研究，对安全阀阀瓣的改造和设计具有重要的意义。
When opening the valve, the valve disc is parallel with the flow direction. The flow resistance is little, the flow section is large and the core will not be eroded.
蝶阀在开启时蝶板与流体流向平行，流阻小，流通截面大，阀芯不易被冲刷；
Disc multi-way valve, the use of rotary multi-way valve, stable and reliable running.
盘式多路阀，采用旋转式多路阀，运行稳定可靠。
The disc and associated moving parts may be in a constant state of movement if the velocity pressure is not sufficient to hold the valve in a wide open and stable position.
如果流体流速压力无法将阀门支撑在一个较大的开启度并保持在稳定的开启位置，则阀瓣和相关的运动部件可能会处于一种持续振动的状态。
The Fig. 1710 Balancing valve is a non-rising stem design incorporating a parabolic (plug) shaped disc.
型号1710平衡阀为暗杆结构，配置抛物线（塞）形阀瓣。
The valve inlet and body are one integral casting assuring proper alignment of disc, seat and spindle for smooth action.
这种阀门的进口和阀体为一件式铸件，确保了阀瓣，阀座和芯轴的对齐和平稳运动。
The disc assembly maintains contact with the guides through the full valve stroke.
这个阀瓣总成在阀门全行程中保持与导向装置的接触。
The swing check valve can also be mounted to the vertical position, provided the disc should not reach the valve position.
旋转式止回阀也可以安装在垂直位置，此时阀瓣应该无法达到阀门的位置。
It features a primary check valve utilizing a rubber disc seating against a mating rubber part to ensure tight closing.
其特点在于第一止回阀采用一个橡胶阀瓣密合在相配的橡胶部件上，确保紧密的关闭。
The valve is mainly made up of body, disc, axle, rocker and heavy hammer etc. It realizes discharging and air locking using trimming moment.
重锤锁气翻板卸灰阀主要由阀体、阀板、阀轴、摇杆、重锤等零件组成，利用力矩平衡的方法实现锁气卸灰。
On abroad, impact valves incorporated in air impact molding machine are mainly disc valve and grid valve. Each of these has its own characteristic.
国外的空气冲击造型机所使用的冲击阀，主要有圆盘阀及栅格阀两种，其各有特点。
The device mainly consists of connection flange, brake disc, braking caliper, bracing frame, force-multiplier pump, hydropneumatic pipeline and proportional control valve.
该装置主要由连接法兰、刹车盘、刹车钳、支撑架、加力泵、液气管线和比例控制阀等组成。
Therefore each line or line section shall have an expansion chamber a pressure relief valve or rupture disc discharging to a receiver.
各管路或管段应配备膨胀室，减压阀或将压力释放到储气罐的爆破隔膜。
Therefore each line or line section shall have an expansion chamber a pressure relief valve or rupture disc discharging to a receiver.
各管路或管段应配备膨胀室，减压阀或将压力释放到储气罐的爆破隔膜。
应用推荐