The effects of the cooling water and freezing water inlet temperature are also predicted. The results are reasonable.
对地下水源热泵机组的性能随着冷却水、冷冻水入口水温的变化情况做了预测，结果合理。
This paper calculates the temperature of inlet air, and analyzes precedence of gas turbine inlet air-cooling by water spray evaporative cooling in Xinjiang area.
对进气空气的温度进行分析计算，并通过计算的结果分析在我国新疆地区燃气轮机采用喷雾蒸发冷却方式冷却进气空气的优越性。
The control strategy for surface temperature of the core rod is investigated and the scheme of introducing advanced compensation on the quantity of inlet water by gradient function is stated.
对芯棒表面温度的控制策略进行初步探讨，提出引入梯度函数对进水量提前补偿修正的方案。
The two operational modes were analyzed by the model controlled the steam inlet valve and the drain water valve based on the return water temperature.
对通过调节蒸汽进汽阀门来控制供水温度的现有运行方式和通过调节疏水阀门控制供水温度的新运行方式进行了仿真分析。
The results indicated that the shape of steam plume was influenced by the inlet steam pressure and subcooled water temperature.
结果表明入口蒸汽压力和过冷水温度是影响汽羽形状的主要因素。
Reducing the inlet temperature of cooling water and increasing its mass flow are favorable to increase refrigerant performance coefficient, and can decrease optimal pressure at high pressure side.
降低冷却水进口温度和提高其质量流量不仅有利于提高制冷性能系数，而且能降低最佳高压侧压力。
Increasing overall flow velocity and depressing the inlet temperature of cooling water has little effect on improving temperature distribution.
提高冷却水的总流速和降低进口温度对电池内温度分布的改善作用不好。
Dip Tube Carries cold inlet water deep into the tank to minimize temperature dilution of hot water.
将进入的冷水引入内胆底部，将热水温度混合稀释作用降到最小程度。
The system is comprised of water tank, recycling water pump, radiator, water inlet and discharging pipes, and water level and temperature controller.
该装置由冷却水罐、循环水泵、散热器、进回水管线及水位和水温控制冷却装置组成。
Analyses the effect of U-tube diameter, tube quantity in each hole, and the design inlet water temperature of a heat pump unit on the heat exchange capability.
分析了U形管管径、单孔内u形管数量及热泵机组设计进水温度对换热器换热效果的影响。
In practical application, inlet water temperature should be higher than critical inlet water temperature and be lower than dew-point temperature of indoor air.
在实际应用中，干式盘管的实际进水温度应高于临界进水温度，但低于室内空气的露点温度。
An effective method for maintaining the vacuum in condenser is to change the flow rate of circulating water according to its different inlet temperature.
在不同循环水进口温度条件下，合理改变循环水流量是维持凝汽器真空的有效办法。
A flow path of hot water can be provided with a water inlet control valve, a temperature sensor, a water return pump and a cold-hot valve.
热水流程可以按装进水控制阀，温度传感器、回水泵、冷热阀门。
Cooling towers' influence on the inlet temperature of circulating water was also considered to determine optimum running mode of circulating water pumps.
同时考虑闭式循环水系统中冷却塔对循环水入口温度的影响，确定出循环水泵最优运行方式。
The exterior of the tank body is provided with an interlayer water jacket provided with a constant temperature heating device and a water inlet and a water outlet valves.
在罐体外部装有夹层水套，水套中装有恒温加热装置，水套上设有进、出水阀。
Through the use of an experimental method the influence of inlet water temperature on the shock wave pressure rise characteristics of steam water two phase flows has been investigated.
采用实验方法研究了进水温度对汽液两相流激波升压特性的影响。
Through the use of an experimental method the influence of inlet water temperature on the shock wave pressure rise characteristics of steam water two phase flows has been investigated.
采用实验方法研究了进水温度对汽液两相流激波升压特性的影响。
应用推荐