应用信号调理芯片是现代常用的一种补偿方法。
Signal conditioning chip is in common used for compensation in recent years.
介绍了小电容量的电容传感器信号调理的一种新方法。
A new method of sensing signal conditioning for small capacitance transducer is introduced.
介绍一种基于USB总线技术的信号调理平台的硬件设计方案。
This paper mainly introduces a hardware design of signal conditioning platform based on USB bus technology.
用DAC芯片程控信号调理电路的放大倍数，提高了系统的测量范围。
By changing the amplification multiple through DAC signals, the measurement range of the system is improved.
接着，还重点介绍了信号调理单元、位置调节器的功能和硬件电路实现。
Meanwhile, the paper focuses on the function and the hardware implement of the signal modulation unit and the position regulator.
基于力矩电机的姿态传感器由倾角测量装置、信号调理板及封装外壳组成。
The gesture sensor based on moment motor consists of inclination measure equipment, signal regulation board and encapsulation shell.
重点研究了加速度计信号调理和信号处理方案，并设计一种新型引信算法。
The objective of this study was to contrive a scheme of accelerometer signal modulation and signal process, and to carry out a new fuze algorithm.
系统硬件包括压力传感器平板阵、信号调理电路、信号采集板以及计算机系统。
The hardware of this system includes pressure transducer board array, signal modulation circuit, signal capture board and PC.
在硬件电路设计中，信号调理电路和数据采集卡是整个系统测量精度的关键环节。
During the hardware circuit design, the signal conditioning circuit and the DAQ card is important to whole system's accuracy.
系统的硬件平台主要由数据采集卡和霍尔电压电流传感器构成的信号调理器组成。
The hardware is made up of Data Acquisition card (DAQ) and signal conditioning extension for instrumentation (SCXI) which is composed of Hall voltage current sensor.
用于现场电气试验的虚拟仪器系统，一般由信号调理装置、数据采集卡和计算机组成。
Virtual instrument system used for field electrical test generally consists of signal conditioning units (SCU), data acquisition devices and a computer.
基于USB技术，平台接口采用USB接口加实装信号调理设备的交互系统设计方法。
Based on the USB technology, the platform's interface was designed to use interactive system design method combined USB interface with actual signal coordinating equipment.
这种将传感器输出转换成电压信号，并与系统的其它电路相连接的过程，称为信号调理。
This process of converting the transducer output into a voltage signal which can be connected to the rest of the system is called signal conditioning.
本文首先介绍了涡街流量计的工作原理，之后详细说明了前端信号调理模块的硬件结构。
The paper introduces firstly the working principle of vortex street flowmeter, secondly the signal conditioning circuit.
该系统由水泵试验台、传感器、信号调理电路、数据采集卡、计算机处理几个部分组成。
This system consists of: pump test bed, sensors, signal processing circuit, data-collecting card, computer processing.
一种用于数据采集的程控信号调理方法，在单片机控制下实现程控增益、程控低通滤波。
A method of signal condition that achieves programmable gain and low pass filter in data acquisition.
重量传感器输出的信号经信号调理电路输入6024E的模拟通道，经计算机分析处理；
The signal output from the weight sensor is transmitted to one of the analog channels of PCI-6024E board by conditioning circuit.
所以利用这款芯片构成的系统进行信号调理，具有高精度、高集成度、高性价比等优点。
So when we choose this Single Chip Computer in the signal conditioning, the advantages can be in this conclusion: higher feathers, less price, higher precision, higher integration.
随后，本文还简要介绍了信号调理器、保护屏蔽接地与电源、计算机接口、信号处理等。
Then it came the signal debug device, protecting shield and power source, computer connection, signal process.
介绍了电动跑步机的测量原理与信号调理电路，给出了心率算法，并提出了软件设计思路。
This paper introduces the measuring principles and signal conditioning circuit of the electric runner, and puts forward the algorithm of heart rate some ideas on software design.
所设计的电路简单、新颖、实用。可广泛用于模拟电子电路，特别是传感器的信号调理电路中。
The designed circuit is simple and novel and practical, and it can be used (extensively) in (analogue) circuits, special in signal condition circuits of sensor.
经过系统软硬件开发，能够实现信号调理、数据采集与存储、USB通信、数据或曲线显示等功能。
After software exploitation, it can realize signal test, data collecting and memory, USB correspondence, data or curve displaying.
主要包括微型计算机、传感装置、信号调理装置、数据采集设备以及测试系统抗干扰的分析与设计。
It mainly includes choosing computer, sensor device, signal adjusting device and data acquisition device and also designing the anti-jamming means for test system.
设计出传感器输入输出信号调理电路和试验台架液压激振系统、磁流变阻尼器控制器的功率放大电路。
Design the signal adjust circuit for sensor, and the power amplification circuit for the hydraulic pressure system of test platform and the controller of magnetorheological dampers.
针对开放式通用ATS信号调理平台进行研究，提出了基于USB总线技术的信号调理平台设计方案。
A scheme of signal conditioning platform based on USB bus technology is put forward in the paper after studying the open general-purpose signal-conditioning platform for ATS.
介绍了本课题中采用的电子鼻硬件系统的三个组成部分――传感器阵列、信号调理电路和数据采集卡。
Then the three key parts of electronic nose: sensors array, signal amplification circuit and AD board are also introduced.
系统由8051单片机、16位模数转换器MAX1177、存储器、信号调理电路和串口电路等构成。
The system is composed of 8051MCU, 16bits A/D MAX1177, memory, signal condition circuit and serial interface.
该系统硬件平台由自主开发的信号源模块和信号调理模块以及NI公司的PCI- 6111板卡组成。
Hardware platform of the system is composed of the signal source module, the signal conditioner and PCI-6111 card supplied by NI.
本文以隔离的热电阻温度变送器信号调理电路为例给出了适用于其它传感器的隔离的变送器信号调理电路。
An isolated transducers signal conditioning circuit for other transducers is proposed taking isolated signal conditioning circuit for thermistor temperature transducers for example.
本文以隔离的热电阻温度变送器信号调理电路为例给出了适用于其它传感器的隔离的变送器信号调理电路。
An isolated transducers signal conditioning circuit for other transducers is proposed taking isolated signal conditioning circuit for thermistor temperature transducers for example.
应用推荐