研究表明，随着反应的进行，树脂含量和相对分子质量降低。
The researches show that the content of resin and the relative molecular mass of maltene decrease as the reaction progress.
减少树脂含量以便于车削和砂光加工。
研究了环氧树脂含量、转速和温度对共混体系的影响。
It studied the influencing effects of the content of epoxy resin, the rotating speed and temperature on the reaction of blends.
利用SEM分析了树脂含量对复合材料表面形貌的影响。
The effect of the amount of furan resin on the morphology of composites was studied with the help of SEM.
考察了树脂含量和成型工艺参数对双极板透气性能的影响。
The influences of the resin content and molding parameter on the air permeation of bipolar plates were researched.
本研究用脂肪酶对磨木浆进行处理，以降低浆料中树脂含量。
Treatment of ground pulp with lipase was investigated to reduce resin content of pulp.
该工艺具有对纤维损伤小、不污染环境和树脂含量容易控制等优点。
It has some virtues such as less damages to GF, non pollutant to environment and easy control of resin content.
讨论了制膜液中吸水树脂含量、粒度，以及添加剂与膜性能的关系。
The effect of ARW content, size and additives on the performance of membrane were discussed.
讨论了酚醛树脂含量、溶剂及橡胶的塑炼时间对胶粘剂性能的影响。
Influences of quantity of phenolic resin, the kind of the solvents and the time of mastication of the rubber on the properties of the adhesive were discussed.
随着高吸水树脂含量的增加，土壤液相组成比例增加，蓄水功能增强。
With the content of super water absorbent resin increasing, the composing proportion of soil liquid phase increases, and the function of water storage strengthens.
本文介绍了一种改进的环氧树脂预浸DMD可溶性树脂含量检测方法。
This paper introduces an improved test of soluble resin content in epoxy preimpregnated DMD material.
本文研究了织物编织类型及树脂含量对碳织物复合材料力学性能的影响。
The effect of resin content and weaving type of the fabrics on mechanical properties of carbon fabric reinforced composites was studied.
研究表明，只有当tp树脂含量不低于15%时，方可获得较明显的增韧效果。
The study shows that only when the content of TP resin is not blow 15%, can the relatively obvious toughening effect be found.
在油介质和无油条件下，纤维含量和树脂含量对压缩回弹性能影响规律基本相同。
The influence of the contents of fiber and resin on the compression-resilience property with and without oil conditions is the same.
由于这种酸性蒸煮液不能去除木材中的树脂类物质，所以浆料中树脂含量相对较高。
The pulp has a comparatively high resin content, since the acid cooking liquor dose not remove the resinous matter found in the wood.
采用溶剂分离法分离紫胶片得到的硬树脂含量为65.1%，软树脂含量为28.2%。
In the lac resin, the content of hard resin is 65.1%, the content of soft resin is 28.2%.
模压压力对接触电阻已有一定程度的影响，但其影响幅度不如接触压力和树脂含量那么大。
The compression pressure and temperature had a smaller influence on contact resistance compared with contacting pressure and PF content.
这个规定定义了所使用的树脂化合物，规定了最小树脂含量，溶液粘度，以及物理性能质量。
The specification identifies the resin compound to be used and stipulates minimum resin content, solution viscosities, and physical performance qualities.
本文介绍计算聚酯玻璃钢树脂含量和固化度的校正公式，该公式对实际工作有一定的指导意义。
The correlation formula for calculating the resin content and curing degree of UP FRP were introduced.
本文所涉及的预浸方法具有如下优点：适于不同体系的树脂，预浸料树脂含量均匀，生产效率高等。
The impregnating methods concerned in this paper have the advantages such as availability for different types of resin systems, prepreg with uniform resin content and higher producing efficiency, etc.
采用氧弹燃烧法配合氟离子电极对有机溶剂型和水溶性氟碳漆中氟碳树脂含量的分析方法进行了研究。
The analysis of fluorocarbon resin content in fluorocarbon lacquer by using oxygen bomb burning method with fluorin ion electrode are discussed in detail.
在脂肪酶最佳处理工艺条件下，磨木浆与原浆相比，树脂含量下降了52.58%，而强度均有不同程度的提高。
Compared with the original pulp, resin content of the treated ground pulp with lipase under optimum condition decreased by 52.58 % and strength of the treated pulp increased in varying degrees.
采用近红外漫反射光谱技术对高硅氧/酚醛预浸布的树脂含量、挥发分含量和预固化度等质量指标进行了在线测定。
The resin content, the volatile content and the pre-curing degree of the silica/phenolic resin prepreg cloth were on-line determined by near infrared diffuse reflection spectrum.
而树脂含量高的油漆，虽然气味大，但是环保安全，因此油漆气味大，并不意味着毒性大，关键要分清这是什么气味。
While high resin content of paint, although the smell, but the safety of environmental protection, so the paint smells great, doesn't mean high toxicity, the key to distinguish what is that smell.
结果表明：酚醛树脂含量是影响复合材料导电性能与力学性能的主要因素，酚醛树脂含量低于20%时，材料具有较高的导电性能；
The results show that PF resin content mainly influence composite properties. With PF resin content less than 20%, the composite had fairly good conducting property.
实验发现当EA树脂含量高于85%时，随着反应的进行体系会逐渐变浑浊，而EA树脂的含量低于85%时，体系始终是均一透明的。
It was found that when EA content is higher than 85%, the so-gel system becomes turbid while EA content is lower than 85%, the system is transparent and homogeneous.
研究不同类型及不同含量的环氧树脂对水性聚氨酯的改性。
Study of different types and different content of water-borne polyurethane resin modified.
生产应用结果表明，该树脂粘结剂中甲醛含量可控制在1.8%以下，力学性能完全可以满足生产要求。
Practice results indicated that the content of formaldehyde in resin binder can be controlled less than1.8%and the mechanical properties completely satisfied the requirement of production.
生产应用结果表明，该树脂粘结剂中甲醛含量可控制在1.8%以下，力学性能完全可以满足生产要求。
Practice results indicated that the content of formaldehyde in resin binder can be controlled less than1.8%and the mechanical properties completely satisfied the requirement of production.
应用推荐