内置继电器关掉设备的待机电流消耗。
In-built relay for switching off devices that consume standby current.
低85mA电流消耗有助于降低驱动器成本。
Low current consumption of 85 mA contributes to lowering the drive cost.
其功能包括快速响应，低驱动电压和低电流消耗。
Features include fast response, low driving voltage and low current consumption.
起动机变得很热，显示一次大的电流消耗使引擎发热。
The starter gets excessively hot, indicating a large current draw to turn the engine over.
否则，这些浮空的输入脚可能会造成非预料的大的电流消耗。
Otherwise non-expected high current consumption may occur due to the floating inputs.
低噪声指数、高增益以及低电流消耗特性使其适用于关键的低功耗GPS应用或者低电量情形。
The low noise figure and high gain, coupled with low current consumption make it suitable for use in critical low-power GPS applications or during low-battery situations.
结果表明，实验条件下脉冲电流阴极保护与直流阴极保护相比，二者的保护度相当，而脉冲电流阴极保护有更小的平均电流消耗和更高的保护效率。
The results show that compared with DC, SWPC can achieve the same protective property with less average current consumption, and has much higher protective efficiency.
所有接入的、消耗的、产生的以及过往的电流在地区配电中心的屏幕上都能看得一清二楚。
All incoming, consumed, produced and passing electricity is clearly visible on the panel (a large block display) of the regional dispatch center.
而从此图中可以看出，到手机使用6.5小时的时候，电流的确升高了，这并不能解释系统记录中3分钟内消耗了6%的电量。
While the current draw does increase at this point (since the phone is being used), it still cannot account for the reported 6% depletion in 3 minutes.
闪光灯用焊片式缩体产品漏电流小可减少电池消耗。
For photoflash lug type miniaturized low leakage current reduces battery consumption.
本着节约材料和减少能源消耗的目的，对新型方波交流TIG焊电源电流的调节电路进行了详细的分析与设计。
For the purpose of economizing on raw materials and reducing consumption, the detailed analysis and design of the regulating circuit of TIG electric welder have been presented in this article.
在同一时间，多在5倍，是减少泄漏电流，从源头上向外流，即是减少了能源消耗的晶体管。
At the same time more than in 5 times is reduced current leak from the source to the drain, ie is reduced the energy consumption of transistor.
气体的产生消耗电流引致泳透力下降，则不可能使隐蔽表面涂上漆。
Throwpower drops off as current is consumed in the production of gas and is not available to permit the covering of recessed areas.
采用压力温度法测量氢气消耗量，对蓄电池电压、电流进行连续测量和积分运算得到电能量消耗。
Pressure and temperature method is assumed to measure hydrogen consumption, Battery voltage and current is continuously measured and integrated to calculate electric energy consumption.
铝电解槽的电能消耗率同平均电压和电流效率两个因素有关。
The energy consumption rate of aluminum electrolytic bath is related with the average voltages and current efficiency.
基于所述电子设备的消耗电流计算所述电子设备的第一剩余可用时间。
A first remaining usable time of the electronic apparatus is calculated based on a consumed current of the electronic apparatus.
阻抗、电流、电压、及功率消耗之关联。
Correlations of Random Impedances, Current, Voltages, and Power Consumptions in a Circuit.
对铝电解槽进行优化控制的主要目的，是提高电流效率，降低电能消耗。
In Aluminum electrolyte pot control system, the main target is to get high current efficiency and low energy consumption.
如果在这种情况下放置过夜，按esc要求的看家电流会消耗电池低于其安全放电电压…让你有一个无法弥补的电池。
If left overnight in this condition, housekeeping current demanded by the ESC could drain the battery below its safe discharge voltage... leaving you with an irreparable battery.
使用完毕以后仍然使电池留在设备里，电池将继续小电流放电，如经数天，电池电力将消耗过度。
If the battery is continue left on the equipment after using it, the battery will discharge as little current. If continue several days, the energy of the battery will over run.
随着供应公正八点五毫安，并能够从单电源电压从5V至12 V运行电流，这些放大器提供了非常高的小功率消耗。
With a supply current of just 8.5ma and the ability to run from a single supply voltage from 5v to 12v, these amplifiers offer very high performance for little power consumption.
本发明的电化学电池优选作为消耗燃料、产生电流的燃料电池 运行。
The electrochemical cell of the invention is preferably operated as a fuel cell, consuming fuel and producing electrical current.
研究结果得出，预焙阳极的炭阳极消耗随阳极电流密度的增加而趋向于理论消耗110%左右。石墨阳极消耗随电流密度增加而略有提高，其范围在135 ~ 150%之间。
The measured results indicated that the carbon consumption of a prebaked anode decreased slightly with increasing anode current density towards a value of about 110% of the theoretical consumption.
当高电流密度引起电极上气体析出失控时，便会发生击穿。 气体的产生消耗电流引致泳透力下降，则不可能使隐蔽表面涂上漆。
Throwpower drops off as current is consumed in the production of gas and is not available to permit the covering of recessed areas.
电荷泵和放大器可放置在掉电模式下，消耗电流小于1ma的。
The charge pump and amplifiers can be placed in a power down mode, consuming less than 1ma of current.
LTC 4365在正常工作时仅消耗125ua电流，并有一个停机引脚用来启动和禁止外部MOSFET，以及用来提供一种10ua的小电流停机状态。
The LTC4365 consumes only 125ua in normal operation, and has a shutdown pin for enabling and disabling the external MOSFETs, and for providing a low current shutdown state of 10ua.
采用电化学方法和阳极消耗率评价法研究了高硅铸铁阳极在方波脉冲电流作用下的电化学性能。
The electrochemical performance of High Silicon-Iron Anodes Exerted by Square Wave Pulsed Currents (SWPCs) was studied by electrochemical.
飞行控制板和四个无刷电调本身消耗的电流是大约200mA。
The supply current for the Flight-Ctrl board plus the four BL ESCs is about 200 mA.
飞行控制板和四个无刷电调本身消耗的电流是大约200mA。
The supply current for the Flight-Ctrl board plus the four BL ESCs is about 200 mA.
应用推荐