裂纹扩展速率随热循环的进行逐渐减小。
Thecrack propagating rate decreases when the thermal cycles increase.
该合金的疲劳裂纹扩展速率对退火温度不敏感。
The temperature of duplex annealing has little influence on fatigue crack propagation behavior.
熔合线和焊趾处疲劳裂纹扩展速率较其他部位大。
The fatigue crack propagation rate of the fusion line and weld toe are greater than that of the others.
随着金属陶瓷中金属相含量的增加，裂纹扩展速率降低。
The propagation rate of crack also decreases with increasing the binder content of cermets.
给出了840d车轮辐板孔平均裂纹扩展速率的计算公式。
The formula for calculating the average crack growth rate of 840d wheel web hole is presented.
依据分析给出化学短裂纹扩展速率与裂纹尺寸之间的关系。
Based on the analysis, the relation between the short crack propagation rate and crack size has been put forward.
随着裂纹的扩展，裂纹扩展速率由于裂纹面的滑移接触而减小。
The crack growth rate was decreased with crack extension because of the sliding contact of the crack faces.
同时分析了材料刚度衰减对疲劳裂纹扩展速率和扩展长度的影响。
The impact of the material constant and the degradation of elastic modulus are analyzed.
结果表明，该近似表达式适用于A型腐蚀疲劳裂纹扩展速率的计算。
The given calculating example shows that the expression has a better applicability for the crack propagation rate of type A.
指出声发射率主要受裂纹扩展速率控制，此结论亦得到了实验的证实。
A conclusion that the acoustic emission rate depends mainly on the crack propagation rate is also verified by experiments.
等轴组织具有较好的拉伸性能、低的断裂韧性和高的疲劳裂纹扩展速率；
The equiaxed structure has good tensile property, low fracture toughness and high fatigue crack propagation rate.
反之，易破碎的粒子则增加了裂纹尖端的扩展应力，提高了裂纹扩展速率。
On the contrary, the easily broken particles enhance the extension stress at the crack tip, and hence the propagation rate of the crack.
本文研究了SCT试样高应变区的疲劳裂纹闭合效应和疲劳裂纹扩展速率。
The fatigue crack closure and fatigue crack growth rate in the high strain region of SCT specimen are studied.
对多种碳素钢在拉伸压缩和旋转弯曲负载下的微小裂纹扩展速率进行了研究。
A study has been done over the small crack growth rate for kinds of carbon steels under push pull and rotating bending.
随循环温度和冷却速率的增加，裂纹形核的孕育期缩短，裂纹扩展速率增加。
The incubation period of crack nucleation decreases and the crack propagation rate increases with the increase of thermal cycling temperature and cooling rate in the cycle.
本文研究了淬火温度对4330M钢在蒸馏水中的应力腐蚀裂纹扩展速率的影响。
The effect of quenching temperatures on the rate of stress corrosion crack propagation of 4330M steel in distilled water has been investigated.
实验结果和模拟结果都表明，该试样厚度下，应力比对裂纹扩展速率几乎没有影响。
Both the numerical analysis and experimental data show that the fatigue crack propagation rate is insensitive to the stress ratio for plain stress thin specimens.
在此基础上，建立了腐蚀环境下疲劳裂纹扩展速率试验中裂纹长度的自动检测技术。
On the basis of this, an automatic measurement technique of fatigue crack length in fatigue crack growth rate test under corrosive circumstance is established.
试验结果表明，随着循环温度的增高，裂纹形核孕育期缩短， 裂纹扩展速率增大；
The results have shown that the incubation period of crack nucleation decreases and the propagation rate of crack increases with increasing the cyclic temperature.
结果表明，稀土能推迟裂纹萌生的时间，降低裂纹扩展速率，提高其冲击疲劳抗力。
The experimental results show that adding rare earth into cast semi steel can defer the time of forming fatigue crack, reduce the speed of crack propagating and increase the impact fatigue resistance.
实验结果表明，三种介质中，裂纹在煤油中扩展速率最低，水中裂纹扩展速率最大。
Experiment results show that. in the three medium, crack growth velocity is minimum in oil, crack growth velocity is maximum in water.
应用二维单侧容限系数公式，提出了一种测定金属材料疲劳裂纹扩展速率的小样本方法。
A small sample method for testing fatigue crack growth rate curve of steel was presented in this paper using a formula of two-dimensional one-side tolerance factor.
在实验中还发现逐次从小载荷循环增至大载荷循环的裂纹扩展速率比一次加载明显减慢。
It has been found that the crack propagation ratio obtained in the case of gradually increasing loading is smaller than that resulted from one-time loading.
主要研究侧槽试样与平板试样裂纹扩展速率之间的关系，并建立了两者关系的效学表达式。
The relationship of crack growth rate between lateral notch specimen and plane plate specimen was studied in this paper. A formula for the relationship was established.
等双轴应力较单轴应力状态下的裂纹扩展速率减慢，而纯剪切状态下的裂纹扩展速率加快。
In these areas, they were slower in equibiaxial case and faster in pure shear compared to crack growth rates in uniaxial loading.
结果表明，微量合金元素硼改变了裂纹扩展途径和扩展方式，从而降低了疲劳裂纹扩展速率。
Result show that the trace boron additive causes the changes in the mode of fatigue crack propagation and its route, so that crack growth rate of 40MnB is lowered.
结果表明，循环载荷下的裂纹扩展速率对试验频率、载荷比、温度及橡胶夹层厚度反映较敏感。
It was shown that crack growth rate increased as the temperature or limit load rate increased. It was also that crack growth rate decreased as rubber thickness and loading rate increased.
本文采用断裂力学方法来估算结构构件的疲劳寿命，这其中主要围绕裂纹扩展速率表达式展开研究。
Fracture mechanics is adopted to estimate the fatigue life of structural members, and among the rest, crack growth rate formula is studied.
本文采用断裂力学方法来估算结构构件的疲劳寿命，这其中主要围绕裂纹扩展速率表达式展开研究。
Fracture mechanics is adopted to estimate the fatigue life of structural members, and among the rest, crack growth rate formula is studied.
应用推荐