该装置由控制系统；光电触发电路；
The detection device comprises a photoelectric trigger circuit;
可控硅触发电路的改进。
详细阐述了控制的数据采集和可控硅触发电路。
The circuit of controlling data acquisition and the trigger circuit of SCR are described in detail.
本文介绍混合式接触器的结构、触发电路及其保护器。
Present paper introduces the structure of hybrid contactor, triggering circuit and its protector.
介绍了变速恒频波浪能发电系统的晶闸管触发电路设计。
This paper presents the design of thyristor triggering circuit for a variable speed constant frequency (VSCF) wave energy electricity generating system.
该相控触发电路是晶闸管整流弧焊电源的理想触发电路。
It is perfect phase trigger circuit for arc welding power source of SCR.
实验表明：三相无源逆变器采用数字触发电路后效果良好。
The experiment has proved that the digital trigger used in the 3-phase passive inverter produces a fine result.
触发电路、供电电路、时钟电路、复位电路是主板上最主要的电路。
Trigger circuit, power supply circuit, clocking circuit and reset circuit are the main circuits on the main board.
论述了集成芯片触发电路在切焊设备中的应用是可行的，并且效果良好。
This article proves that the integrated chip trigger circuit could be used in cutting and welding equipment and has good effects as well.
摘要：触发电路、供电电路、时钟电路、复位电路是主板上最主要的电路。
Abstract: Trigger circuit, power supply circuit, clocking circuit and reset circuit are the main circuits on the main board.
设计了一种由两级升压触发电路及变频式直流电源电路构成的氙灯安定器。
A kind of xenon lamps stabilizer is designed which is made up of the tripper-circuit with two-leveled rising voltage and the direct current power circuit with frequency conversion mode.
硬件设计包括测试电源、测试控制电路、数据采集部分、过零触发电路等。
The hardware design includes electrical source design, measuring controlled circuit design, data acquisition section design, checking-at-zero circuit design and so on.
该装置包括分压器、同轴电缆、触发电路、信号处理、数据采集、控制和分析软件。
Divider, coaxial line, trigger, signal processing, data acquisition, acquisition control and waveform analysis software is included in the device.
应用CD4098单稳态触发器组成了三相过零触发电路，达到了较为理想的调功效果。
The three-phase zero-detection trigger made up of CD4098 single side stale trigger can produce ideal effect.
而且还具有多种组合，可适合两路、三路或六路触发电路的需要，并对电源无相序要求。
The trigger circuit has multifunction, which will satisfy trigger circuit needs and suit two or three and six cannula trigger circuit, but doesn't require phase-sequence.
针对全数字交交变频矢量系统设计了一种基于CPLD的新型高性能全控桥数字触发电路。
A new high-performance digital trigger circuit of full-control-bridge based on CPLD is designed to the control system of the digital AC-AC variable-frequency.
该电路在特殊触发电路的作用下，其输出端可产生全波可控整流电压和全控桥式整流电压。
Full wave controlled rectification voltage or controlled bridge rectification voltage can be generated under the controlling of a special trigger circuit.
它们包括信号采样电路、人机接口电路、主控芯片接口电路、过零触发电路及通讯电路等。
They include signal sampling circuit, man-machine interface circuit and control circuit, main chip interface circuit, zero-crossing triggering circuit, and communication circuit, etc.
锁相环路是完成两个电信号相位同步的反馈控制系统，适宜于变流装置的同步触发电路之中。
The phase lock loop is a feedback control system that makes two telecommunication signals' phase synchronization, suitable to the synchronous trigger circuit of the convertor device.
使用单稳态触发电路作“延时”或“定时”用，由于受到元件和器件的影响，其精度不会太高。
The accuracy of delay or timing is not sensitive with monostable trigger circuit since electrical elements have influence on it.
该系统以可控硅三相桥式全控整流电路构成系统的主电路，采用同步信号为锯齿波的触发电路。
The thyristor triphase-bridge full controllable rectification circuit is taken as main circuit of the system and the trigger circuit with saw-tooth synchronism signal is adopted.
氢闸流管的导通速度与触发信号有关，常用触发电路中使用快速晶闸管，触发信号并不是很理想。
The switch rate of thyratron is related to the triggering signal. The fast thyristor is usually used in the trigger circuit, but the triggering signal is not ideal.
包括焊接主回路、采样电路、触发电路、同步电路、电磁气阀启动电路、显示界面以及看门狗等电路。
The circuit including the main welding circuit, shows the interface, watch dog circuit, sampling circuit, trigger, synchronous circuit and electromagnetism gas valve etc.
介绍了稳弧电路、同步移相电路、触发电路及外特性控制电路的设计特点，对各单元电路进行了具体的分析。
This article introduces the characteristics of stabilized arc circuit, sync shift-phase circuit, trigger circuit and control circuit, also illuminates each unit circuit.
数据采集系统触发电路、随机采样短时间产生电路、存储器地址计数器电路等相关控制电路的设计、仿真和调试；
The circuits revelent to data acquisition system such as trigger circuit, the circuit of short time generator in random sampling etc, are designed, simulated and adjusted.
在此背景下，本次设计将CPLD引入到V-M系统中，开发出与以往脉冲产生方式相区别的数字式移相触发电路。
In this background, with the application of CPLD in V-M System, a digital SCR trigger circuit with phase shifting is developed which is absolutely different from the former ones.
应用MCS - 51(96)单片机作触发电路，可省去同步变压器和复杂的接法变换等，操作简单、准确可靠。
Using MCS-51 (96) single chip microcomputer as trigger circuit can save the synchronous transformer and complicated conn...
DSO通道与触发电路是数字存储示波器最重要的组成部分之一，其性能的好坏直接决定了示波器测量的精度和范围。
The DSO channel and the triggering circuit are one of DSO most important constituents. Its performance's quality had decided directly the oscilloscope surveys precision and scope.
提出了一种由集成电路组成的双向晶闸管移相触发器的设计方案，给出了适合于感性负载的交流调压电源的触发电路。
A scheme of bidirectional thyristor phasing trigger composed by ICs is presented, and the trigger circuit fit for AC voltage regulator of inductive load is given.
提出了一种由集成电路组成的双向晶闸管移相触发器的设计方案，给出了适合于感性负载的交流调压电源的触发电路。
A scheme of bidirectional thyristor phasing trigger composed by ICs is presented, and the trigger circuit fit for AC voltage regulator of inductive load is given.
应用推荐