同时分析得出，在恒压力进给条件下，随着线锯速度的增加，损伤层厚度略有减小。
It is shown that as feed force is a constant, the damage thickness decreases slightly with the increase of wire speed.
不同的压力和轴向进给速度可滚压出不同的粗糙度和硬度。
Variation of the pressure and the axial speed results in different roughness and hardening.
还单独论述了油缸进给压力对珩磨比能耗的影响。
The influence of cylinder feed pressure to the consumed energy of honing ratio also was discussed in the article singly.
介绍了一种环轧过程最优控制器的设计方法，该控制器可以使压力辊按要求的进给速率运动。
And also a rolling optimum controller, which keeps the mandrel feed in rate as requirement, is designed and relative formulas are given.
模型采用三层结构，输入变量有水射流压力、水喷嘴直径、磨料粒子粒度(直径)、磨料流量和切割头进给速度。
Three layers network topology is adopted. The input variables are water pressure, diameter of orifice, diameter of abrasive particles, flow rate of abrasive and feed rate of cutting head respectively.
GMM微进给装置结构设计的关键在于磁场结构设计、温控结构设计、预压力设计和传感器设计四个方面。
The key of device of the GMM structural design of micro-feeding was the design of magnetic field structure, temperature-controlled structural, pre-stress and sensor.
获得了成形角、减薄率、进给比等工艺参数对等效应力、旋压力及内筋成形高度的影响规律，为旋压工艺参数的选择和优化提供了依据。
The rules which various parameters influence spinning force and equivalent stress are obtained and its provide theoretical evidence for choosing the optimal parameters.
进给比小时，旋压力变化不明显。
The spinning force will not change obviously if the feed radio is small.
超磁致伸缩微位移致动器和步进电机相结合实现进给和压力施加， 完成。电热棒通电加热凹模，并由温控组件保持凹模的恒温。
The warm extruding apparatus includes a heating laser system, an extruding mold, a pressure applying mechanism, a feeding mechanism, a 3D precise worktable, a support and a control system.
计算一次进给不对称卷板的可行性，如进行最大变形量、最大压力、最大功率和不打滑的验算等等。
The paper also gives the feasibility analysis of asymmetric plate bending under one time feeding cond...
具有自动检测、补偿、报警功能，其砂轮进给速度、进给量、磨削压力和送料盘的转速都可以通过显示屏进行编程。
The feed speed and quantity of the grinding wheel, grinding pressure, rotating speed of the feeding plate all can be programmed on the computer screen.
具有自动检测、补偿、报警功能，其砂轮进给速度、进给量、磨削压力和送料盘的转速都可以通过显示屏进行编程。
The feed speed and quantity of the grinding wheel, grinding pressure, rotating speed of the feeding plate all can be programmed on the computer screen.
应用推荐