如何决定什么地址总线使用？
这是不可能的了冯诺伊曼单地址总线架构。
This is not possible with a Von Neumann single-address bus architecture.
总线由数据总线、地址总线和控制总线组成。
The bus by the data bus, the address bus and control bus composition.
地址总线为数据传输指明内存位置(地址)。
The address bus specifies the memory locations (addresses) for the data transfers.
地址总线被处理器用来选择在特定外设中的存储器地址或寄存器。
The address bus is used by the processor to select aspecific memory location or register within a particular peripheral.
当访问内存位置或寄存器时，在地址总线上的真实的地址。
The actual address that is placed on the address bus when accessing a memory location or register.
当访问内存位置或寄存器时，在地址总线上的真实的地址。
Thee actual address that is placed on the address bus when accessing a memory location or register.
地址总线被处理器用来选择在特定外设中的存储器地址或寄存器。
The address bus is used by the processor to select a specific memory location or register within a particular peripheral.
BOOTP服务器必须在下次冷启动分配一个新的IP地址总线耦合器。
The BootP server must assign a new IP address to the Bus Coupler at the next cold start.
总线是连接计算机各部件的一簇公共信号线，由地址总线、数据总线和控制总线组成。
The bus is the computer parts connected by a bunch of public signal, address bus, data bus and control bus composition.
物理地址：真实的地址，其值必须被置于系统地址总线中用于选择物理存储位置或者设备。
A "real" address the value that must be placed on the system address bus to select a physical memory bank or device.
一个存储器地址是由输出到适宜的总线上的二进制数据所组成。这个总线我们称为地址总线。
A memory address consists of binary data being output on an appropriate bus which we call the address bus.
一旦你开始调整GTL ref电压(单独针对每个核心数据和地址总线)你将会发现不同的总线频率需要不同的电压组合。
Once you begin adjusting GTLREF voltages (for each core data and address bus) you will find that different bus frequencies respond differently to variations in the voltage.
提出了一种新的低功耗非冗余排序总线编码方法，通过对改进的偏移地址线的动态重排以降低具有高负载的地址总线的功耗。
The irredundant sorting bus encoding method reduces the power dissipation of highly capacitive memory address bus based on the dynamic reordering of the modified offset address bus lines.
由于采用的TMS320F 2808不具备数据总线与地址总线，两个DSP之间采用SPI串行通讯的方式实现数据交换。
Due to lack of data and address parallel bus on TMS320F2808, the two DSPexchange data by means of communication through SPI interface.
由于采用的TMS320F 2808不具备数据总线与地址总线，两个DSP之间采用SPI串行通讯的方式实现数据交换。
Due to lack of data and address parallel bus on TMS320F2808, the two DSPexchange data by means of communication through SPI interface.
应用推荐