接下来，要配置默认路由器。
然后未能添加默认路由。
在给定的路由需求下实施并检验静态路由和默认路由的配置
Perform and verify routing configuration tasks for a static or default route given specific routing requirements
在路由操作方面可能发生的另一个问题是出现双重默认路由。
One other potential problem that can occur with route manipulation is getting duplicate default routes.
在路由器2创立一个进入OSPF的默认路由。
映射指定的URL路由并设置默认路由值。
IPRIP被配置为放弃默认路由，因此通过下一跃点%2到的路由已被放弃。
IPRIP is configured to discard default routes, so a route to with next-hop % 2 has been discarded.
删除默认路由器的IP地址：#routedeletetheipadress。
Delete your default router's IP address: # route delete theipadress.
当为这个新接口分配一个默认路由时，会生成一个default - route - up事件。
When a default route was assigned to the new interface, a default-route-up event would result.
本节比较HP - UX、Solaris和AIX上的连网配置并在这三种系统上配置默认路由器。
This section compares and contrasts the differences of configuring networking on HP-UX, Solaris, and AIX and configures a default router on all three systems.
最后一行设置默认路由方式，重定向10.0.0.0网络的所有流量通过新创建的虚拟接口。
The final line sets the default routing, redirecting all traffic for the 10.0.0.0 network through the newly created virtual interface.
本文就路由选择算法中的默认路由(含静态路由)和两种简单的动态路由算法作一简单分析。
In this article, the author analyses on the static state algorithm (including default route algorithm) and the basic dynamic route algorithm in the network layer.
在这个窗口中，必须填写一些信息，包括服务器的主机名、IP地址、网络掩码、名称服务器 IP 地址和域以及默认路由。
Within this window, you must fill in several pieces of information, including the server's hostname, the IP address, netmask, nameserver IP address and domain, and your default route.
如果您想要一个OSPF的启用路由器生成一个默认路由，即使它并没有一个默认路由本身，请使用此命令的默认信息，源于始终。
If you want an OSPF-enabled router to generate a default route even if it doesn't have a default route itself, use the command default-information originate always.
如果您想要一个OSPF的启用路由器生成一个默认路由，即使它并没有一个默认路由本身，请使用此命令的默认信息，源于始终。
If you want an OSPF-enabled router to generate a default route even if it doesn't have a default route itself, use the command default-information originate always.
应用推荐