If the coefficient of engagement overlap decreases, the flow aggrandize, trapping volume and the flow pulsating ratio decreases.
随著齿轮啮合重合系数的减小，齿轮泵的流量增大，困油容积和流量脉动率减小。
Experimental results show that the material remove rate(MRR) increases with the increase of laminated depth and decreases with the increase of tool path overlap ratio.
研究结果表明工件的加工速度随着分层厚度的增加而增加，随着轨迹重叠率的增加而减小；
In addition to these, the influence of area ratio, negative overlap, compressive factor and load inertia on system behavior are also analysed.
此外还对面积比、负重叠量、压缩性因数、负载惯量等对系统的影响进行了分析。
应用推荐