At the same time, research has been done on the prediction of shrinkage cavity and porosity of SG iron based on the micro-modeling.
同时,从微观模拟的角度研究了球铁件缩孔缩松预测。
参考来源 - 铸件凝固过程微观组织及缩孔缩松形成的数值模拟研究The result showed that the shrinkage cavity formed during foundry and the disfigurement of graphite were the main cause of the driving wheel cracking.
结果表明,产生裂纹的主要原因是驱动轮在铸造中形成的缩松孔隙和石墨形态缺陷所致。
参考来源 - 摩托车驱动轮废品原因分析·2,447,543篇论文数据，部分数据来源于NoteExpress
Shrinkage cavity predication is main purpose of casting simulation.
预测缩孔缺陷产生是铸件凝固模拟的主要目的。
The main deformity of the center housing cast in the automobile turbocharger is shrinkage cavity.
在汽车涡轮增压器中心架铸件生产中主要产生缩孔缺陷。
It is discussed that adiabatic material, as well as ratio of height and width effected solidification, shrinkage cavity and shrinkage porosity.
讨论了锭模的高宽比、绝热板材质对凝固位置及缩孔疏松的影响。
应用推荐