...的作用力便会使探针在垂直方向移动，而此微调距离即模拟待测 物表面的起伏形态，而扫描出 样品的表面图形 ( surface topography )。 非接触式，乃是探针与材料表面总维持著一定的距离，避免待 探针刮伤。
基于16个网页-相关网页
milled surface topography 加工表面形貌
surface topography parameters 表面形貌参数的
three-dimensional surface topography 表面形貌 ; 三维表面形貌
surface topography in engineering [地理] 工程表面地形学
3D surface topography 三维表面形貌
Fractal geometry is applied to the characterization of rough surfaces. The variation law of surface topography during running-in period is studied with scale-independent fractal parameters.
把分形几何用于粗糙表面的表征，用具有尺度独立性的分形参数研究了磨合过程中表面形貌的变化规律。
参考来源 - 基于分形理论的磨合磨损预测模型In this dsssertation, the friction-induced noise phenomena and surface topography related to sine waveforms of reciprocating sliding displacement are compared with those corresponding to triangle waveforms. The noise and topography formed by using different flat specimen materials are alsoinvestigated.
论文中还对比了正弦波和三角波滑动规律下的摩擦噪声现象及相应的磨痕形貌；分析了使用不同闸瓦材料时的摩擦噪声现象和磨痕形貌。
参考来源 - 金属往复滑动条件下摩擦噪声与磨痕形貌关系的探讨Therefore, 2-D evaluation of traditional surface topography is not suitable for composite any more.
传统的表面形貌二维评定方法对复合材料切削表面已不再适用。
参考来源 - C/C复合材料切削表面粗糙度的评定方法研究Many investigations of earthquake damages manifest that surface topography has significant amplification or reduction effects on ground motion, and therefore, it can influence the distribution of earthquake damages directly.
大量的震害表明,地表地形对地面运动有很强的放大和缩小作用,因而直接影响到震害的分布。
参考来源 - 特殊场地条件下的地震响应研究Surface topography was observed by reflex light microscope and SEM.
反射光显微镜、扫描电镜观测钛板表面形态。
参考来源 - 烟草浸提液对人牙龈成纤维细胞在钛板上附着的影响In this research, the influences of crystalline structure, surface topography and electron structure on the cell adhesion and proliferation property were studied. Titanium dioxide (TiO_2) films with the different crystalline structure were prepared via sol-gel dip-coating method.
本文分别研究了生物材料表面特性中晶体结构、表面微形貌、电子结构这三个因素对内皮细胞附着和增殖性能的影响。
参考来源 - 材料表面特性对内皮细胞附着和增殖性能的影响研究Objective: The main purpose of this study was to investigate the changes in mechanical properties , surface frictional forces and surface topography of various orthodontic SS arch wires used in the anteriorteeth-retraction or canine-distalization period .
目的:主要研究口腔环境中采用滑动机制内收前牙及远移尖牙阶段正畸不锈钢弓丝机械性能、表面摩擦力及表面形构的变化。
参考来源 - 口腔环境中不锈钢弓丝机械性能及表面摩擦力变化的初步研究·2,447,543篇论文数据，部分数据来源于NoteExpress
Profilometer - a tool that is used for measuring surface topography.
表面形貌剂-一种用来测量晶圆片表面形貌的工具。
Finally, the problem of characterization of surface topography is analysed.
本文最后分析了表面形貌的表征问题。
Focus detection method is one of the primary non-contact measurement methods of surface topography.
聚焦探测法是表面形貌非接触测量中的主要方法之一。
应用推荐