An improperly designed hot roller can cause fabric edge in excess of rolling pressure due to the increased roller diameter near the journal ends.
不适当的热轧辊设计会导致织物边缘过度轧压，这是因为热轧辊端部附近直径增大引起的。
The designed parameters of mechanical capabilities of the roll caster should be raised when rolling pressure increase with roller diameter increase.
随着铸轧辊径增大， 轧制压力增大，因此铸轧机力能设计参数也要相应增大。
Methods The influence of roller pressure, roller speed, and water content of extract powder on yield and friability of particle diameter was investigated.
方法考察压轮压力、压轮转速和浸膏粉含水量对颗粒得率和颗粒脆碎度的影响。
应用推荐