...；滑动速度 [gap=1112]ection of material; sliding wear; AZ31 magnesium alloy; microarc oxidation film; sliding velocity ...
基于466个网页-相关网页
Lengthwise sliding velocity 纵向滑动速度
relative sliding velocity 相对滑动速度
seal tip sliding velocity 径向密封片尖端滑动速度
Apex seal sliding velocity 径向密封片滑动速度
Computing on sliding velocity 滑速计算
tooth profile relative sliding velocity 齿廓相对滑动速度
Sliding g velocity 滑动速度
velocity sliding 速度滑移
relative sliding linear velocity 相对滑动线速度
The relationship between ball rolling speed and screw rotational speed is developed based on the compatibility condition of sliding velocity vectors.
根据接触点处的位置矢量和滑动速度矢量之间的协调条件，确定了滚珠与滚道之间接触点的位置。 根据滚珠稳定状态时角加速度等于零，求解出了滚珠滚动速度与丝杠轴转速之间的关系。
参考来源 - 大导程滚珠丝杠副动力学性能及加工方法研究·2,447,543篇论文数据，部分数据来源于NoteExpress
In the design of crossed-helical gears, the minimum sliding velocity is obtained when the helix Angle are equal.
在横渡螺线齿轮设计，当节面角是相等的时，极小值滑的速度得到。
It is found that the friction coefficient increases with the increase of sliding velocity, and there is critical velocity.
试验发现，摩擦系数随滑动速度的增加而增加，存在临界滑动速度。
However, the friction coefficient between Ni and APS increased with sliding velocity increasing and reduced with load increasing.
而镍与APS间的摩擦系数随滑动速度的增大而增大，随载荷的增大而减小。
应用推荐