单轴压缩试验压缩方向平行于长轴。
The uniaxial compression tests are compressed parallel to their longitudinal axis.
单轴和三轴压缩试验。
用人工曲线、自然曲线以及实际地图分别进行压缩试验。
Curve compression experiments were made by a new method with artificial, natural curves and practical maps respectively.
在高围压条件下，对冻结兰州砂土进行了三轴压缩试验。
Triaxial compressive tests were conducted on frozen Lanzhou sand under condition of high confining pres-sure. The.
对正常固结饱和粘土的三轴不排水压缩试验结果进行了分析。
Analyses were carried out of the undrained triaxial compression test results of several normally consolidated saturated clays.
结果表明，文中方程可以用来确定压缩试验的应力应变关系。
The further investigation of the equation showed that it could be used to determine stress-strain relation in oedometer test.
采用MTS815岩石伺服试验系统进行了煤样三轴压缩试验。
On this basis, the triaxial compressive test of coal sample is done using MTS815 servo-controlled rock mechanical test system.
考虑了常规三轴试验和各向同性压缩试验对切线体积模量的影响。
The different influences on tangent bulk modulus of conventional triaxial test and isotropic compression test were considered.
介绍了基于W78E58B单片机的压缩试验仪的原理以及设计方法。
This paper introduces the principle and design of compression equipment based on single chip microcomputer W78E58B.
本文从结构性软土的压缩试验入手，探讨考虑结构性的砂墙地基固结性状。
In this dissertation, on the basis of the test of structured soft clay, the consolidation behavior of sand-wall ground considering the structure character of soft clay is studied.
采用等温恒应变速率压缩试验对超高强度铝合金的流动应力规律进行了研究。
Based on the isothermal constant strain-rate compression tests, the flow stress of a ultra high strength aluminum alloy was researched.
在工程建设中三轴压缩试验提供的土体抗剪强度参数得到越来越广泛的应用。
Parameters of shear strength from triaxial compression test are widely used in project construction.
采用等温恒应变速率压缩试验对7A60超高强度铝合金的流动应力进行了研究。
The flow stress of 7A60 ultra high strength aluminum alloy was studied by isothermal compress test at constant strain rate.
采用压缩试验方法，就合金元素对铸态锰钢的加工硬化性能的影响作了系统试验；
The effects of alloying elements on the work hardening ability of as cast manganese steels wre carried out by means of compressive tests.
有关试验表明，平面应变状态下采用三轴压缩试验获得的抗剪强度参数偏于保守。
Some correlative tests indicate that the result will be conservative while under plane strain state but still adopting shear strength under triaxial compression.
通过压缩试验，研究了供应态h 62黄铜棒材所表现出的超塑性变形的力学特性。
The mechanical behavior of commercial brass H62 bar under superplastic deformation was investigated by compression testing.
模型的计算参数共有9个，可以方便地通过原状土的有侧限和无侧限压缩试验测定。
This model contains 9 parameters which can be easily determined by conventional both confined and unconfined compression test.
以指数方程模拟压缩过程，根据万能试验机实测数据，计算出草砖的压缩试验系数。
According to the data from testing machine, the testing coefficients of straw bale were calculated, based on an exponent model.
通过对三峡花岗岩进行常规三轴压缩试验，得到不同围压下的应力—应变全过程曲线。
Based on the conventional triaxial compression tests of the Three Gorges granite, the complete stress-strain curves under different confining pressures have been attained.
采用等温热压缩试验对一种自行研制的高强度易切削锌基合金进行热变形行为的研究。
The hot deformation behavior of a self-developed zinc based alloy was investigated by isothermal compression test.
采用单道次压缩试验，研究了变形温度和变形速率对SS400钢热变形行为的影响。
Effects of SS400 steel's deformation temperature and strain rates on its deformation behavior was studied using single pass compressing test.
用花岗岩试件做了常规三轴压缩试验，对在不同围压作用下的岩石断裂表面进行了分形研究。
Conventional triaxial compression tests of granite were made and the fracture surfaces of samples tested under different confining pressures were studied by fractal analysis.
相同应力路径试验得到的有效应力路径形态一致，常规三轴压缩试验中有效应力路径呈S形。
The shape of effective stress path is similar under the same stress path testing, the S' shape of effective stress path was observed in conventional triaxial compression test.
根据纸浆模塑制品动态压缩试验的测试数据，提出了采用神经网络方法对试验数据进行处理。
It was put forward to apply neural network method to process the dynamic compression test data of molded pulp products.
在电子万能试验机上对铸态am 60镁合金进行室温压缩试验，研究了在变形量分别为3。
Deformation twinning of cast magnesium alloy AM60 was investigated by compression at room temperature with various deformation degrees from 3.
第五、通过单向压缩试验和三轴cu试验，得出了吹填土微结构特征参数随荷载变化的规律。
Fifthly, the discipline of micro-structure characteristic parameters change by the load has been received through compression test and triaxial CU test.
笔者以垫片的压缩试验数据为基础，用分析推理的方法，确定出了丁腈橡胶垫片的压缩弹性模量。
The compressive modulus of Elasticity of the butanone rubber gasket are given, based on the compressive test Value of this type gasket, with the analysis and inference method by the authors.
通过烧结铁圆柱试样单向压缩试验，验证了粉末冶金烧结材料广义塑性屈服条件的合理性和适用性。
Based on the single axial compression of sintered iron cylinder specimens, the rationality and applicability of generalized yield criterion are validated for sintered powder metallurgy materials.
目前加筋土的试验研究主要有四种方法：原型试验、模型试验、三轴压缩试验、直剪试验和拉拔试验。
At present, four methods are mainly used for reinforcement earth research: prototype test, model test, three-axial compression test, direct shear test and drawing test.
目前加筋土的试验研究主要有四种方法：原型试验、模型试验、三轴压缩试验、直剪试验和拉拔试验。
At present, four methods are mainly used for reinforcement earth research: prototype test, model test, three-axial compression test, direct shear test and drawing test.
应用推荐