There is a protective circuit inside the battery to prevent contingency.
电池中装有保护电路以避免各种意外情况发生。
A protective circuit is serially connected between a controlled current source and a power operation processing circuit.
所述的受控电流源与功率运算处理电路之间串接保护电路。
In this paper, a protective circuit for power supply of lasers without the use of low-voltage transformer and relay is presented.
本文介绍了一种不用低压变压器和继电器激光电源保护电路。
A filtering net and a protective circuit of input are added in the front of input net, and a practical protective circ uit of output is also added.
在输入端加入了滤波网络和输入保护电路，并加入了实用的输出保护电路。
In a protective circuit for switching off a hazardous installation the aforementioned signaling devices are connected in series to a safety control device.
在用于关闭危险设备的安全电路中，这样的信号装置互相串联地连接到安全控制器。
A protective circuit of the control system normally monitors data inputs from a data bus 148 that may indicate conditions that are not favorable for clutch brake actuation.
控制系统的保护电路通常监视数据总线(148)的数据输入，该数据输入可表示不利于离合器制动器启动的情况。
A voltage measuring transformer decreases voltage from 330 kV to 100 kV for protective circuit.
电压测量变压器将电压从300千伏降低到100千伏以保护电路。
This paper introduces a short circuit protective method of the output terminal of the low voltage rectifying cabinet. Analyzes in detail the operational principle of the protective circuit then.
介绍了低压整流柜输出端短路保护的方法，并详细分析了保护电路的工作原理。
The theoretical circuit of a kind of super speed protective device is devoted in this paper.
本文介绍一种超速保护器的原理电路。
A single lithium-ion battery protective circuit is designed.
设计了一种单节锂离子电池保护电路。
The paper discussed the working principle, hardware circuit design and software design of a protective device, which was composed of 8031 single chip computer.
论述了以8031单片机为核心而构成的防跑车保护装置的工作原理、硬件电路设计及软件设计。
WJJL1 intelligence over current relay is a typical electronic apparatus which has over current, short circuit, over voltage, under curent, phase faults and starting failure protective functions.
WJJL1智能过流继电器是典型的电子、电器技术相结合的产品。具有过电流、短路、缺相、过欠压、欠电流、相失衡及启动故障等保护功能。
A reconfigurable Hardware Platform Based on SOC Design for Digital Protective Relay is presented. It combines the FPGA and the Flash MCU and related interface circuit.
文中提出了基于SOC的可配置微机保护硬件平台的设计方法和具体实现，该平台由FPGA和微处理器以及相关接口构成。
Shown from test of operation parameters on buried compound sacrificial anodes, pipeline protective potential is -1.4V and anode opened-circuit is over 1. 5V. It is a much ideal mag…
通过对复合式牺牲阳极埋地运行参数的测试表明，管道保护电位达—1.4V，阳极开路电位在—1.5 V以上，是非常理想的镁阳极电位，其应用效果优于镁锌混合式方法，具有广阔的应用前景。
Shown from test of operation parameters on buried compound sacrificial anodes, pipeline protective potential is -1.4V and anode opened-circuit is over 1. 5V. It is a much ideal mag…
通过对复合式牺牲阳极埋地运行参数的测试表明，管道保护电位达—1.4V，阳极开路电位在—1.5 V以上，是非常理想的镁阳极电位，其应用效果优于镁锌混合式方法，具有广阔的应用前景。
应用推荐