X ray diffraction analysis showed that the layer is an amorphous structure.
射线衍射分析结果显示出镀层为一种非晶态结构。
The carbon tubes prepared were in short range order with amorphous structure.
制备的碳纳米管的原子排列是一种短程有序排列，是非晶态结构。
The glass has an amorphous structure and exists at the composite phase interface and ceramic grain boundary.
玻璃料以无定形态存在于复合材料中的相界与陶瓷晶界上。
The matrix of composite coatings is turned into amorphous structure again after some technologic factors are adjusted.
通过镀覆工艺参数的调节，控制复合镀层基体结构，促使其逐渐向非晶态过渡。
The results show that the films with dense and amorphous structure and lower grain boundary resistance were deposited at room temperature.
研究结果表明，室温下沉积的薄膜为颗粒致密的非晶相结构，晶界电阻较小。
The more Ni powder introduced, the more advantageous for the formation of amorphous structure, and the larger discharge capacity obtained.
加入的镍粉越多，越利于非晶结构的形成，其放电容量就越大。
Highfrequency plasma and laser supported combustion wave induced by it are the main reasons for amorphous structure of ultrafine co powder.
高频等离子弧及其诱发的激光支持燃烧波对于获得非晶结构起关键性的作用。
Silicon in an anode active substance layer provided in an anode current collector has an amorphous structure with a low degree of a local order.
设置在负极集电体上的负极活性物质层中的硅具有局部有序性的程度低的非晶结构。
The XRD analysis showed that the structure of the deposits changed from amorphous structure to microcrystalline as the metal ion concentration ratio increased.
XRD分析结果表明，随金属离子浓度比的增加，镀层呈现由非晶结构向微晶结构转变的趋势。
It showed that good anticorrosion is attributed to homogeneous amorphous structure of Ni-Mo-P alloy and protective passive film formed on the surface of alloy.
结果表明，合金结构的非晶态性和合金表面易生成耐蚀性优异的钝化膜，是分别使不同成分合金镀层耐蚀性优异的重要原因。
Particle size of ore powder can not be refined infinitely by milling, but its microcosmic crystallines can be refined gradually until amorphous structure is formed.
对于特定的一种球磨机，铁矿粉的粒度细化程度是有限度的，但其微观晶粒可以逐步细化直至晶粒完全无定形化。
The XRD, EXAFS, DSC, SEM and XPS methods for determining and characterizing amorphous structure, surface morphology and active center of the catalysts were introduced.
介绍了对非晶态合金催化剂的非晶结构、表面形态、活性中心等进行表征和定性的XRD、EX AFS、DSC、SEM和XPS等方法。
The influence of bath concentrations on deposition rate, composition, surface appearance, formation range of the amorphous structure and corrosion resistance for the deposits was studied.
研究了镀液浓度对镀层沉积速率、成分、表面形貌、非晶态结构形成区域和耐蚀性的影响，得出了最佳镀液浓度及施镀条件。
The X-ray diffraction (XRD), high-resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) results indicate that the sputtered film has an amorphous structure.
射线衍射(XRD)、高分辨率透射电镜(HRTEM)和选区电子衍射(SAED)分析表明，该薄膜为非晶态。
The X-ray diffraction (XRD), high-resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) results indicate that the sputtered film has an amorphous structure.
射线衍射(XRD)、高分辨率透射电镜(HRTEM)和选区电子衍射(SAED)分析表明，该薄膜为非晶态。
应用推荐