The results show that the apparent viscosity of A356 alloy slurry in steady-state decreases with the shear rate increasing under isothermal shearing condition.
结果表明：等温剪切时，浆料稳态表观粘度随着剪切速率的增大而下降，半固态a 356铝合金具有明显的触变性。
The analysis of microstructure can also reflect the regulation of the effect on the apparent viscosity of factors, such as shear rate, temperature and cooling rate.
显微结构分析也可以反映出剪切速率、温度和冷却速度对表观粘度的影响规律。
The shear rate of modified CPVC was higher than CPVC and the melt apparent viscosity was lower at the same shear stress.
相同剪切应力下改性CPVC的表观剪切速率大于CPVC，熔体表观粘度小于CPVC。
The apparent viscosity at the point decreases distinctly with shear rate increasing.
随着剪切速率的增加，转相点的视粘度明显下降。
The apparent viscosity at the point decreases distinctly with the increment of shear rate.
随着剪切速率的增加，转相点的视粘度明显下降。
It has been found that the apparent viscosity of PBR is sensitive to shear rate, shear stress, and to temperature at lower shear rate levels as well.
表观粘度对切变速率和切应力较敏感，并且，在低切变速率下对温度也较敏感。
Moreover, the low molecular weight and higher temperature are favorable to reduce the melt viscosity, to increase the critical shear rate and to improve the apparent quality of extrudates.
较低的分子量和较高的温度有利于提高临界剪切速率，改善挤出物外观质量和降低熔体粘度。
As the shear rate increased, the apparent viscosity of the solution gradually decreased.
随着剪切速率的增大，溶液的表观粘度逐步下降。
The results show that the coatings with good application properties have larger apparent viscosity , higher yield stress , lower plastic viscosity and proper thixotropy at lower shear rate.
实验结果表明，使用性能良好的锭模耐火涂料在低剪切条件下，应具有较大的表现粘度与屈服应力，以及较小的塑性粘度和适当的触变性。
The results show that the coatings with good application properties have larger apparent viscosity , higher yield stress , lower plastic viscosity and proper thixotropy at lower shear rate.
实验结果表明，使用性能良好的锭模耐火涂料在低剪切条件下，应具有较大的表现粘度与屈服应力，以及较小的塑性粘度和适当的触变性。
应用推荐