It can't thrive at a human's core temperature, which is why it only attacks our cooler extremities.
人类中心温度无法适应它们繁殖，即使袭击人类时通常也是在较冷的四肢。
At that point, the fuel at the core of the reactors would have dropped in temperature and no longer be capable of boiling the surrounding water.
到那时，反应堆堆芯的燃料温度会下降，且也不会导致周围水温升高。
Researchers warmed up one group of mice to body temperatures of about 103 degrees Fahrenheit. They left another group at normal core temperature-about the same as ours.
研究人员将一组老鼠的体温升高到103华氏度，另外一组保持正常体温- - -大约是人体温度。
They note that pressure and the temperature inside the reactor core remain at levels far lower than what would further melt the core.
他们指出，该反应堆堆芯现在保持的压力与温度并不高，远远低于会导致堆芯进一步融化的水平。
Most experts believe that it is, as the core temperature of the at-risk reactors has been reduced to below 2, 200c, the melting point of the fuel rods.
大部分专家认为是的，当有危险的反应堆的中心温度降至2,200摄氏度以下，即燃料棒的熔点。
On the other hand, more massive stars have higher temperature at the stellar core.
另一方面，一颗比太阳更重的恒星的中心温度更高。
Most experts believe that it is, as the core temperature of the at-risk reactors has been reduced to below 2,200c, the melting point of the fuel rods.
大部分专家认为是的，当有危险的反应堆的中心温度降至2,200摄氏度以下，即燃料棒的熔点。
The outer core is believed to be composed mostly of iron and nickel in a molten state at a very high temperature.
有人认为外地核主要是由在高温下处于熔态的铁和镍构成的。
Humidifying treatment in mat surface could shorten a half time when the temperature of core layer reached to water vaporizing temperature at most.
板坯表面增湿处理，能使其中心层到达水分汽化温度的时间最多缩短约一半。
In the light of no integrated surging and burn-in test system at high temperature for slice capacitor, a smart test system based on 89c52 core is developed.
针对目前片式电容器生产厂无大容量高温浪涌与老化试验同时进行的设备现状，设计并实现了以89c52单片机为核心的智能化高温浪涌测试与老化试验系统。
The results showed that after rolling at high and low temperature, skin-core structures also existed in the PP/LCP composite.
结果发现，PP/LCP复合材料经过高温、室温压延后仍存在皮芯结构；
Compared with core glass, the effect of optical processing quality of cladding glass on interface defects was more evident when its viscosity at drawing temperature was higher tha.
研究表明良好的预制棒加工质量可有效改善光纤纤芯与包层的界面状态，并且相对于纤芯玻璃来说，粘度较高的包层玻璃其加工质量对界面缺陷的影响更为显著。
At the same time, temperature rise calculations in single-segment iron core and in half-of -axial-length region(25 segments) were done and compared.
同时本文还做了单段铁心与半轴向长（ 2 5段铁心）的温升对比计算。
Continuous foaming at normal temperature, no glue compound technology, high-strength core material.
常温连续发泡，无胶水复合技术，高强度芯材。
Continuous foaming at normal temperature, no glue compound technology, high-strength core material.
常温连续发泡，无胶水复合技术，高强度芯材。
应用推荐