我们已经提到扬声器不是纯粹的电阻性的。
大部分人都知道，扬声器不是纯粹的电阻性负载。
As most of us are aware, speakers are not pure resistive loads.
首先是磁曲率对等离子体电阻性不稳定性的影响。
The first is that the effects of the magnetic curvature on the resistive interchange mode in tokamak plasmas.
通常的脉冲发生器只是在电阻性负载时才能得到陡的上升沿。
General pulsers can obtain sharp risetime only when it is used for a resistive load.
实际结果表明，电路对电阻性或电感性负载均具有较好的控制性能。
Practical application demonstrates that the circuit has good performance with resistive or inductive load.
发现直流电阻性本质安全电路在断开过程中低能电弧放电有三种情况。
It was found that there are three types of low-energy arc discharge during the breaking process of resistive intrinsically safe circuits.
即使对于电阻性负载，屏蔽电缆的电容也可能会导致继电器触点焊接。
Even with resistive loads, the capacitance of a shielded connecting cable may cause relay welding.
斜槽电机的电阻性负载和阻感性负载时的实验波形，并对实验结果进行了分析。
The relative analysis of both the pure resistor load and resistor-inductance load are given also.
在网络方程同伦的概念的基础上，给出了一种求解非线性电阻性网络的有效算法。
Based on the homotopy idea of network equation, an efficient algorithm for solving nonlinear resistive network is given in the paper.
他发现有些材料在受到磁场作用时会改变其电阻性，这种效应也可被应用于回读被记录的数据。
Thomson found that the electrical resistance of some materials changes when a magnetic field is applied to them. This effect can be used to read back what has been recorded.
利用数字显示时间继电器、交流接触器、断路器以及电阻性负载设计了一个简易的触头材料实验电路。
The simple experimental circuit contact material is designed using time relays with digital display, contactors, switchgear and resistive load.
采用这种方法可将非线性时变RLCM网络的瞬态分析简化为若干次线性时不变电阻性网络的直流分析。
With this method, the transient analysis of nonlinear time-varying RLCM network can be reduced to a series of the DC analyses of linear time-invariant resistive network.
如果介电常数的虚部不等于零，则存在能量损失(不管实部为多少)，因而，可以认为该元件具备电阻性。
Finally, if the imaginary part of the permittivity is not equal to zero and so energy is lost (whatever the real part is), then the element can be thought of as having resistance.
应用自行设计的实验模型，在室温条件下，并在电阻性电路和电感性电路中，测量了金合金触点的电弧电压和电弧电流波形；
The experimental model designed was used to measure arc voltage and current waveforms of alloyed contact in resistive load circuit and inductive load circuit on the condition of room temperature;
研究结果表明，电炉、电镀和电解等纯电阻性或近似电阻性负荷以恒定阻抗模型表示，潮流计算结果更加符合电力系统实际运行情况。
The calculation result on a 5 bus system shows that the new power flow algorithm based on constant load impedance can get more reasonable solution.
一高质量电阻器在信号道路和使用瑞士与黄金接触适合低接触电阻和长期的耐久性一起使精密衰减器内只。
Only one high-quality resistor in the signal path and using the Swiss made precision attenuator with gold contacts for low contact resistance and longtime durability.
玻璃和陶瓷也具有很高的体电阻率，但是在高湿度下表面电阻率性质较差，并且其压电性常常也较差。
Glass and ceramics also have high volume resistivity, but poor surface properties at high humidity and often-poor piezoelectric properties.
因此谨慎的做法是定期地用静电计欧姆计来测量测试夹具和电缆的绝缘电阻，以保证其完整性。
Therefore, it's prudent to measure the insulation resistance of the test fixtures and cables periodically with an electrometer ohmmeter to ensure their integrity.
测试电气和电子设备和组件的连续性，电流，电压和电阻。
Test electrical and electronic equipment and components for continuity, current, voltage and resistance.
整流二极管不可直接并联使用，因为二极管的热电阻有差异，会使可靠性降低，最好用一组电流大的二极管。
Rectifier diodes cannot be used directly in parallel, because the diode heat resistance have differences, will reduce the reliability, it is better to a set of current of diode.
分析了采用小电阻接地系统的必要性及该系统的故障特性。
The necessity of low resistance ground system and its fault characteristic were analyzed.
在可靠性、安全性和经济性等方面，高电阻接地有较明显的优势。高电阻接地还可以在较大范围推广应用。
The high resistance ground has obvious advantages in reliability, safety and economy, which is worth to be popularized in a wider scope.
在设置通断性测试时，工程师必须规定电阻最大为多少时可认为装置是可用的。
When setting up a continuity test, the engineer must specify the maximum resistance at which the device is considered to be valid.
行波测距法具有较高的可靠性和精度，抗干扰能力强，且不受故障电阻及系统运行方式的影响。
The traveling wave fault location has high reliability accuracy and anti-disturbance capability , and it also immunes from the fault resistance and the neutral grounding modes.
在与硬度法的对比试验中，进一步验证了电阻法的可行性。
The feasibility of this method is confirmed by comparison with microhardness method.
介绍了将测量性实验“伏安法测电阻”改变为设计性实验的思想和步骤。
The paper introduces ideas and procedures of changing "resistance measurement with voltammetry" from measuring to design experimentation.
对加速性应力试验，所选的负载电阻要能够吸收比电源额定值较高的电流。
For accelerated stress testing, the load resistance may be selected to draw a level of current higher than the rated current of the power supply.
主要是随着衬底尺寸的增长，外延层的厚度、电阻率均匀性无法满足要求。
With large size wafer, the uniformity of thickness & Resistivity was out of control line.
主要是随着衬底尺寸的增长，外延层的厚度、电阻率均匀性无法满足要求。
With large size wafer, the uniformity of thickness & Resistivity was out of control line.
应用推荐