憎水板具有弹性、高强度耐压的作用。
Hate water board has flexibility, high strength compression role.
电气强度测试仪(也称为耐压测试仪，电介质强度测试仪，闪点测试器，高压测试仪)是用来测量此类电流值的测试仪。
A dielectric Withstand tester (also called hipot tester, dielectric strength tester, flash tester, high voltage tester) is then used to measure this current.
新材料已经推动电力工业几十年，更好的耐热和耐压材料使得发电厂规模越来越大。
New materials have driven the power industry for decades, as better heat - and pressure-resistant materials allowed electrical plants to grow larger and larger.
在核反应堆中，铀棒排列成束，浸入一个巨大的耐压水箱中。
Inside a nuclear reactor, rods of uranium are arranged in bundles and immersed in a giant, pressurised water tank.
50KV采用计算机控制，通过人机对话方式，完成对绝缘介质的工频电压击穿，工频耐压试验。
ZJC-50KV controlled by computer, through the man-machine dialogue mode, the voltage breakdown insulation, power frequency withstand voltage test.
在存在水和氯化物的情况下及耐压强度和侵蚀的联合作用下发生的开裂。
Cracking due to the combination of tensile stress and corrosion in the presence of water and chlorides.
在有些应用中，例如测试电缆和印制板的绝缘电阻及耐压测试，可能需要切换高压信号。
Some applications, such as testing insulation resistance of cables and printed circuit boards and high-pot testing, may require switching high voltages.
采用计算机控制，过人机对话方式，完成对、绝缘介质的工频电压击穿，工频耐压试验。
Using computer control, man-machine dialogue mode, the completion of the power frequency voltage breakdown of insulation media, power frequency withstand voltage test.
潜水器的耐压壳体是保障人员，能够在海底生存的重要设备，所以潜水器的耐压壳体的研究具有重要的意义。
Pressure hull of deep-submarine is an important equipment, which make the survival at deep-sea access to people, so pressure hull's research is of great significance.
国内在这些专用集成电路的研制工作中所面临的主要困难，是高耐压高频结型场效应对管的工艺制作。
A big challenge to the development of this type of ASICs is the fabrication process for high-voltage, high-frequency pair JFETs.
过滤设备的耐压能力有限，压力不能太高。
The pressure filtration equipment ability is limited, the pressure does not too high.
硬质合金材料的出色之处来源于它们非常高的硬度和耐压强度。
The exceptional tool performance of sintered carbides results from their very high hardness and high compressive strength.
它具有滚压刚化表面，不仅断裂模数大、耐压强度高，而且具备良好的抗磨损和抗热气腐蚀能力。
It has a rolled, rigidized surface which gives it a high modulus of rupture and compressive strength as well as high abrasion and hot gas erosion resistance.
制得高强度耐火粘土砖的试验结果表明：浸渍处理后的试样，常温耐压强度均获得了不同程度的提高，体积密度增加，气孔率下降。
The result shows that the compressive strength at normal temperature of impregnated samples is raised in varying degree, their bulk density is increased and the porosity is decreased.
根据设计任务书中规定的总的下潜次数要求，最后给出了我国目前正在研制的7000米载人潜水器耐压球壳的疲劳载荷谱。
According to the requirement of the total diving number and the assumption of the distribution type, the fatigue load spectrum for the 7000m deep manned submersible is given.
本文在磁性流体密封理论的基础上计算了磁性流体密封的耐压能力，并进行了实验研究。
In this paper, computation and experimental study of the seal capacity for magnetic fluid seal were carried, on the basis of the theory of the magnetic fluid seals.
在选用时需考虑波纹管的耐压和温度影响。
Should be considered in the selection of bellows when the pressure and temperature.
主要探讨了不同的烧结温度对试样的耐压强度和体积密度的影响。
The effects of different temperatures on compressive strength and bulk density were studied.
以确保产品的耐压及安全性，最大程度满足客户要求。
To ensure that products and safety of pressure to maximize customer satisfaction.
耐压岩棉板：能承受巨大的高负载。适用于候机室、大型车间等房顶保温。
Compression-resistant rock wool board: used for roof heat preservation of airport lounge and large workshop as it could bear huge loads.
讨论了潜艇外部耐压液舱可能的结构型式。
Possible structural forms of outer pressure tank of submarine are discussed.
简述了门极换流晶闸管(GCT)的耐压结构及其特点。
The enduring voltage structure and features of Gate Commutated Thyristor (GCT) were analyzed briefly.
潜艇两种耐压结构的可靠性分析算例表明：该方法实用性强，操作性好，精度较高，对于有高度非线性失效面方程的可靠性计算问题有很强的适应性。
Examples for two types of submarine structures indicate that this method is practical and useful, and is especially suitable for reliability analysis with highly non-linear failure surfaces.
本文讨论了潜艇圆筒形耐压壳体结构的分析与优化。
In this article, structure optimization and analysis of a cylindrical pressure-resisting hull of submersible vessel are discussed.
冲压弯头的耐压性能最佳。
因而在工频耐压试验中使用虚拟仪器技术也是工频耐压测量的发展趋势。
The virtual instrument is also the trend of the measure technology for the power withstand test.
随着潜艇耐压船体的几何尺寸增大，耐压壳体的强度与稳定性分析仍然是一个具有重要实际意义的研究课题。
With the lager dimension of the submarine pressure hull, the strength and stability analysis of pressure hull is still an important subject in the submarine design.
随着潜艇耐压船体的几何尺寸增大，耐压壳体的强度与稳定性分析仍然是一个具有重要实际意义的研究课题。
With the lager dimension of the submarine pressure hull, the strength and stability analysis of pressure hull is still an important subject in the submarine design.
应用推荐