改进后侧向位移计算结果的精度比原方法有很大提高。
The calculated results of lateral movement of the improved method are checked more fairly well with field measurements than those of the unimproved ones.
对于弹性抗滑桩，计算结果的精度优于传统的查表手算法。
For elastic stabilizing piles, the precision of calculation results is better than that of traditional method by means of tables.
利用测量得到的栅电阻，计算结果的精度可以进一步提高。
Provided that the value of gate resistance is acquired from measurement, the precision of the solution can be improved further.
对计算结果的精度进行了分析，给出了计算结果的最大误差。
The accuracy of calculation result was analyzed, and the maximum error was given.
连接密网格与疏网格的过渡单元对有限元计算结果的精度有较大的影响。
In the mesh generation of the finite element computation, the transition elements connecting the dense and sparse meshes have great effect on the precision of the computational results.
采用物质平衡方程计算时，常常由于PVT参数的误差而影响最终计算结果的精度。
When calculating with material balance equation, the accuracy of the calculation result is often affected by the error of PVT parameters.
边界元法应用于计算辐射声场时，由于奇异积分的存在，会影响到计算结果的精度。
The singular integration will affect the precision of the result while the Boundary Element Method (BEM) is used in calculating sound radiation.
在区域法中，系统被分为表面区和气体区，其数目与计算结果的精度要求和计算时间有关。
In the zone method, the system is divided into surface zones and gas zones, the number being dependent on the desired accuracy of the result and calculation time.
作者提出的实用空间分析法，简单实用又便于配筋，计算结果的精度能满足工程设计的要求。
The practical space method is simple and convenient for locating steel bar and the accuracy of computation can satisfy the design requirement.
应用边界点元可以更客观地反映角点处边界量的实际状况，从而大大改善了计算结果的精度。
Using boundary point elements can simulate the actual situation of boundary quantities more objectively and improve the accurate of results greatly.
ANN计算和决策模块具有关于新输入数据的自学能力，该自学能力可以提高FEM元素的计算结果的精度。
The ANN calculation and decision module has self-learning ability with new input data which can increase the accuracy of the calculated results for the FEM elements.
对于切削过程的有限元模拟分析，正确的简化模型不仅可以提高计算结果的精度，并且可以大大的减少计算的时间。
In finite element simulation of cutting course, correct predigested model not only may improve precision of calculated result, but also can smartly reduce calculating time.
本文所采用的基于输入-输出系统论的谱方法在计算结果的精度上与最小二乘配置方法相当，却很容易用于异性场的计算。
In this paper, the spectral methods based on the input output system theory (IOST) were used to compute quantities related to the gravity field.
在上海，海潮负荷引起的应变效应在数值上与起潮力直接引起的应变效应相当，经海潮改正后，计算结果的精度有显著提高。
In Shanghai the strain effect of ocean tide loads approached the direct effect of tide-generating force, and after correction of ocean tide loads the accuracy of calculation was distinctly improved.
实测数据计算结果表明，选优后的误差修正模型可有效提高目标定位精度。
Computation results with flight experiment data indicate that the error correction models effectively increase rocket positioning accuracy after optimization.
模拟结果同时证实，除非水均衡误差也相当小，否则水头变化收敛指标较小时收敛的计算也不能保证计算结果有可靠的精度。
Verified by simulation results reliable accuracy of calculated results can not be guaranteed for small head change convergence index unless the error of water balance is small too.
计算结果表明，在铺层分界面上有十分明显的应力峰，并发现，即使沿铺层厚度使用16个二次元素，这些值仍没有达到令人满意的精度。
The results show quite distinct stress peaks at layer interfaces, and it was found that even with 16 quadratic elements over the layer thickness these values have not reached an acceptable accuracy.
岩土力学参数的概率分布类型直接影响岩土工程可靠性分析的计算结果和精度。
The probabilistic model of rock and soil mechanics parameters affects the results and precision of reliability analysis and design.
计算结果表明该方法在动力问题的分析中有较高的精度。
Numerical examples show that this method has high accuracy in the vibration analysis.
研究表明，利用有限差分数值方法进行复杂地电模型的正演计算，计算速度快，计算结果精度较高。
The study shows that limited difference forward method has higher precision and computing speed in Geo-electrical forward modeling.
计算结果表明，预测精度均有不同程度的提高。
The calculation results show that some improvements of the predicting precision have deen achieved.
计算结果表明：推算精度是令人满意的，因而方法是可行的，有一定的实际意义。
The results show that the precision is satisfactory, thus the method is feasible and has certain practical significance.
研究了束传播算法(BPM)中简单透明边界条件(STBC)和完全透明边界条件(CTBC)两种边界处理算法对计算结果精度的影响。
It studied simple transparent boundary condition (STBC) and complete transparent boundary condition (CTBC) used in beam propagation method (BPM) and their effects on calculation accuracy.
数值计算结果表明这样做可以改善元素的精度。
The improvement in the element behavior is demonstrated by numerical results.
计算结果与起重机设计寿命基本相符，表明计算结果满足工程上精度要求，该寿命模型是实用和可行的。
The results accords with the designed life of the crane by and large, showing that calculation results meet required precision for engineering, and that life fatigue model is practicable.
近似方法与直接积分方法的比较表明近似方法的计算工作量大幅减少，可以给出足够精度的计算结果。
It is shown that the approximation method with sufficient accuracy costs less computation time than the direct integration method.
它可以应用一般平面杆系的电算程序计算，其精度已被空间有限元电算程序的计算结果所验证。
It may be calculated by the plan element computer program, and its precision is proved by the results of space computer program.
计算结果表明，该方法的精度优于传统方法。
The numerical result demonstrates that the precision of nonlinear fitting method is better than that of traditional method.
管理模型的计算结果说明该方法精度较高，工作量少，是地下水资源管理模型建立及求解的有效方法。
Solving results of management model show the high precision, simplified solving process and efficiency for foundation and solution of groundwater resources management model of this method.
管理模型的计算结果说明该方法精度较高，工作量少，是地下水资源管理模型建立及求解的有效方法。
Solving results of management model show the high precision, simplified solving process and efficiency for foundation and solution of groundwater resources management model of this method.
应用推荐