There is no shear force in a straight column exposed to an axial compression.
一个轴心受压的直柱是没有剪力的。
Trial method of shaped steel axial compression members is analyzed in this paper.
分析了型钢轴压构件在试算法中的运用。
The thesis aims at studying stability of aluminum alloy axial compression members.
本文旨在研究铝合金轴心受压构件的稳定性能。
It is mainly studied the testing methods of stability of axial compression steel members.
对轴心受压钢构件进行了稳定性检测方法研究。
Results The maximal axial compression force and embalmed time-length was negatively correlated.
结果最大抗压力与福尔·马林浸泡时间呈负相关。
The definitions of parameters of axial compression ratio and shear span ratio of split columns were given.
给出了分体柱轴压比、剪跨比等概念参数的定义。
This fracture usually results from the joint effects of axial compression, and rotating or shearing stress.
这种骨折通常是轴向压缩应力与旋转或剪式应力综合作用的结果。
Then, the calculational method on the bearing capacity of split columns under axial compression is brought up.
最后提出了分体柱轴心受压承载力的简易计算方法。
Then, the classical stability theory for brail composite cylindrical shells under axial compression is discussed.
然后，讨论了编织复合材料圆柱壳的经典稳定性理论。
This paper makes simple force and its deformation analyses for the thin walled cylinder under axial compression at first.
本文首先对轴压薄壁圆筒作出简单的力及其变形分析。
Firstly, the experimental studies of axial compression and local bearing of fired module perforated brick shale are done.
本文首先进行了烧结页岩模数多孔砖砌体的轴心抗压试验研究和局部均匀受压的试验研究。
A finite element analysis is presented for predicting local buckling stresses in stiffened plates under axial compression.
本文给出了轴压加筋板局部屈曲应力的有限元分析。
This chapter indicates buckling modes, critical load and equilibrium path of plate under axial compression and shear load.
介绍板在单向压缩和剪切载荷作用下的屈曲模态、临界载荷和平衡路径。
Based on experimental results, a dilation model of CFRP tubes confining concrete columns under axial compression is set up.
在实验基础上，建立了CF R P管混凝土柱的轴向压缩膨胀模型。
The elastic constitutive equations, the composite elastic modulus and the composite axial compression stiffness of CFST are derived.
导出了钢管混凝土柱弹性本构方程、组合轴压弹性模量和组合轴压刚度的理论计算公式。
In the experimental of perforated brick of shale, we get three phases of axial compression failure and state of cracking and failure.
通过页岩模数多孔砖轴心受压试验，我们得到页岩模数砖轴心受压破坏的三个阶段以及开裂和破坏的情况。
The reasonable axial compression, load angle and the ratio of stirrup of special-shaped columns are gained from the contrastive analysis.
通过对比分析，得出了异形柱比较合理的轴压比和加载角度。
Under the same axial compression load, the dislocation of the pedicle screw in AFC group was apparently less than that in fixation group.
在相同轴向压缩载荷作用下，AFC组椎弓根钉受力移位较内固定组明显减小。
Based on the tests and theoretic derivation, skeleton curve of restoring force model of frame column with high axial compression ratio is got.
在试验研究和理论推导的基础上，给出了高轴压比下框架柱恢复力模型的骨架曲线，与试验骨架曲线吻合较好。
The calculated results show that the limit values of axial compression ratio of SRC columns are generally (25-50) % higher than those of RC columns.
计算表明，钢骨混凝土柱的轴压比限值一般比钢筋混凝土柱的高(25 ~ 50)%。
According to project examples, it introduced in detail that the original axial compression method is used for detection of the strength of a brick masonry.
结合工程实例详细介绍原位轴压法在砌体强度检测中的试验步骤、数据分析、强度评定等过程。
Under axial compression, influence of interface is considered using jointed material model, and gap of interface is considered by removal of some elements.
轴压情况下，采用节理模型考虑界面影响，界面之间随机挖去一定比例单元，模拟空隙率影响。
Based on its stress characteristics, the author introduces points for attention in design such as control of axial compression ratio and structural measure.
根据异形柱的受力特点，论述了在设计时应注意轴压比控制和构造措施等方面的要求。
The state space equations for vibration and stability of composite laminated beams under axial compression have been derived for arbitrary boundary conditions.
建立了组合梁在任意边界条件下振动与稳定性的状态空间控制方程和振动频率与轴压载荷之间的相互关系式。
Results show that the compression resistance, axial compression resistance and cleavage strength of CHTHSC are higher than those of the other two kinds of concrete.
结果表明：全高钛重矿渣混凝土的抗压强度、轴心抗压强度、劈裂强度较后两种混凝土高。
Numerical methods are adopted in this thesis to investigate the stability behavior of thin cylindrical shells with rectangular openings subject to axial compression.
本文利用数值方法系统研究了开有矩形孔的薄壁圆柱壳在轴压作用下的稳定性能。
The elastic plastic buckling analysis is completed on bucking load and buckling mode of thin wall cylindrical shells fully filled with liquid under axial compression.
对充满液体的薄壁圆柱壳经受轴向压缩时的屈曲载荷和屈曲模态进行了弹塑性屈曲分析。
At present, four methods are mainly used for reinforcement earth research: prototype test, model test, three-axial compression test, direct shear test and drawing test.
目前加筋土的试验研究主要有四种方法：原型试验、模型试验、三轴压缩试验、直剪试验和拉拔试验。
Secondly, the influence of typical axisymmetrical initial geometrical imperfections on the stability of composite cylindrical shells under axial compression is discussed.
其次，讨论了典型的轴对称形式的初始几何缺陷对复合材料圆柱壳轴压稳定性的影响。
The study aims to find out the proper limited values of axial compression ratio of the steel tube-steel concrete composite column under the condition of ductility damage.
目的研究使钢管-钢骨混凝土组合柱发生延性破坏时所需要确定的轴压比限值。
应用推荐