Confirm that all ports are enabled, and verify that the CD-ROM Device is listed BEFORE the Hard-Disk Drive in the Boot Sequence list.
确认所有的端口被激活，并且证实了光盘装置：硬盘驱动器的上市前的顺序列出。
VDM modifies the hardware Settings of the cloned VM based on the configurations defined in VM deployment task file; it will create a CD-ROM device to mount the ISO file created in step 3.
VDM将根据VM部署任务文件中定义的配置修改已复制VM的硬件设置；它将创建一个CD - ROM设备以装入在第3步中创建的ISO文件。
The Linux IDE device interface for CD/DVD ROM does not support hot swapping.
用于CD/DVDROM的LinuxIDE设备接口并不支持热交换。
In fact, when you want to access a particular block device (such as a disks, partition, CD-ROM drive, etc) you'll actually have several different special files to which you can refer.
实际上，如果您想访问一个特定的块设备(如磁盘、分区、光盘驱动器等等)，事实上有几个不同的特殊文件可以引用。
An initiator can represent a SCSI device in a host computer, and a SCSI target can be a disk drive, CD-ROM, tape drive, or special device such as an enclosure service.
发起者可以是托管计算机中的一个SCSI设备，而SCSI目标则可以是一个磁盘、光盘和磁带设备或特殊设备(比如箱体设备)。
An operating system such as MS-DOS can load additional device drivers, such as CD-ROM drivers, but needs all of the hardware drivers already loaded at startup.
诸如MS - DOS之类的操作系统可以加载其他设备驱动程序，例如CD - ROM驱动器，但是需要所有硬件驱动程序在启动时就已经加载上来了。
Well, what really happens is that each block device, such as a hard drive partition, CD-ROM, or floppy disk, actually has a filesystem on it.
实际上，每一个区块设备(如硬盘驱动器分区、CD - ROM或者软盘)上都有一个文件系统。
A boot device can be a floppy disk, a CD-ROM, a partition on a hard disk, a device on the network, or even a USB flash memory stick.
引导设备可以是软盘、CD - ROM、硬盘上的某个分区、网络上的某个设备，甚至是usb闪存。
One thing about the virt-clone script should be noted: If the original guest has an unconnected device, such as a CD-ROM, the script will fail.
有关virt -clone脚本需要注意的一点是：如果原始客户机有一个未被连接的设备，比如CD - ROM，那么脚本将失败。
To boot using the IBM Installation Toolkit Live DVD, make sure your system has the CD/DVD-ROM drive or the Network Adaptor as its first boot device as follows
要使用IBMInstallationToolkitLiveDVD引导机器，请确保您的系统使用 CD/DVD-ROM驱动器或网络适配器作为其第一引导设备，方法如下
At some point, every Linux or UNIX systems administrator needs to unmount a partition in response to some emergency or simply to remove a device such as a mounted CD-ROM or DVD.
有时候，为了应对一些紧急情况或者删除挂载的CD - ROM或DVD等设备，Linux或UNIX系统管理员需要卸载分区。
To find the SCSI device name for the CD/DVD ROM drive, use the lsscsi command to list all SCSI devices, and use grep to find cd/dvd
要查找CD/DVDROM驱动器的SCSI名字，可以使用lsscsi命令显示所有的 SCSI设备，并使用grep来查找 cd/dvd
A hot swap is the replacement of a hard drive, CD-ROM drive, power supply, or other device with a similar device while the computer system using it remains in operation.
热插拔就是在计算机系统在使用时用一个类似的设备来代替一个硬件驱动、CD - ROM驱动、电源或者其他设备。
SYS and AUTOEXEC. BAT files for running the device communication software, and how to solve some problems while using CD ROM retriveal systems (for HITACHI drives).
SYS和批处理文件有关运行通讯软件语句及参数的设置，并介绍了常见几种类型CD驱动器CONFIG。
SYS and AUTOEXEC. BAT files for running the device communication software, and how to solve some problems while using CD ROM retriveal systems (for HITACHI drives).
SYS和批处理文件有关运行通讯软件语句及参数的设置，并介绍了常见几种类型CD驱动器CONFIG。
应用推荐