The studies in this paper provide a practical way to design a continuous steel crane beam. It has some theoretical and practical values.
本文的研究为连续钢吊车梁的设计提供了切实可行的方法,具有一定的理论意义和工程实用价值。
And it can be used for designing composite i-beam and i-typed crane beam.
这对工程上组合梁及吊车梁的设计具有实际意义。
The rock wall crane beam is a type of new technique and till now, there is no code yet to be followed.
岩壁吊车梁是一项新技术,目前尚无规范可循,需要在实践中不断总结、优化。
This subject applies AET to safety assessment of crane beam first, so extend the application area of AET.
本课题首次将声发射监测技术应用于起重机梁的安全评价,从而扩展了声发射技术的应用领域。
Some crane beam for 700t cranes was detected having installation error of rail eccentricity exceeding code limit.
某700吨吊车梁的吊车轨道偏心超过规范允许偏差。
DDA is used to analyze the destabilizing pattern of rock-anchored crane beam under the crane wheel pressing action.
目前,岩壁吊车梁设计所采用的刚体极限平衡设计方法还不能确切反映岩锚吊车梁的实际受力状态。
Cantilever crane beam flange web in bending due to board edge are mutually embedded, a restriction on the cross section deformation.
悬臂吊梁的翼缘板和腹板在弯曲时因板边互相嵌固,对截面变形有约束作用。
The paper introduces the measure for controlling the weld distortion of huge crane beam and the procedure for assembling and welding of the beam.
介绍了焊接超大型吊车梁时控制焊接变形的措施以及为此而制定的装焊工艺。
At present, the rigid-body limit equilibrium method adopted in the design of crane beam on rock wall can not reflect the actual mechanical behavior of crane.
目前,岩壁吊车梁设计所采用的刚体极限平衡设计方法还不能确切反映岩锚吊车梁的实际受力状态。
The aim of this subject is to discover the feasibility of crane beam AET NDT and the characteristic of AE signal, which has never been reported in literature until today.
本课题的目是探讨起重机梁声发射技术无损检测的可行性及声发射信号的特征。
In this article, the author points out some important questions about routine management of the crane beam through the assessment on a large-scale factory building's crane beams.
通过对某大型厂房吊车梁的鉴定分析,指出了该类吊车梁在日常管理中应注意的几个问题。
This program can complete the designing and checking of a two-span continuous steel crane beam, and it can also draw of internal force envelopes and output the calculation files.
此程序可完成两等跨连续钢吊车梁的设计校核工作,并具有自动绘制内力包络图、输出计算书功能。
This paper gives a general equation for the ideal curve of crane beam with joint support, then further discusses the effect of elastic support on the curve, and gives the complement equation.
用能量法推导了刚性铰支大梁上拱和上翘曲线的一般方程。进一步探讨了弹性支座对上拱和上翘曲线的影响,并得出了相应的关系式。
The main achievement has been quoted by Design Criterion of Crane Beam on Rock Wall for Underground Powerhouse(draft) and explanation items.
主要研究成果已被《地下厂房岩壁吊车梁设计规范》(送审稿)及条文说明所采用。
The main achievement has been quoted by Design Criterion of Crane Beam on Rock Wall for Underground Powerhouse(draft) and explanation items.
主要研究成果已被《地下厂房岩壁吊车梁设计规范》(送审稿)及条文说明所采用。
应用推荐