Crystallization temperature of the as-quenched alloys were measured by DSC.
用DSC法测定了制备态合金的晶化温度。
The results show that supercritical CO2 depresses the crystallization temperature of BAPC.
结果表明，超临界CO2显著降低BAPC的结晶温度；
The results show that the crystallization temperature decreases with the increase of cold pressure rate.
结果表明，随冷轧压加率的提高，再结晶温度降低。
It was further indicated that the apparent volume of CTCBE was decided by the crystallization temperature.
进一步表明CTCBE在自然缓冷固化的表观体积根本上由其结晶温度决定。
The results showed that optimized flux has higher crystallization temperature, lower viscosity and melting point.
结果表明：优化的保护渣具有较高结晶温度、较低的粘度和熔点；
The crystallization temperature and dielectric properties of PLZT thin films with PLT seeding layers were investigated.
研究了有晶种层的PLZT薄膜的结晶温度及介电性能。
It has been found that as the heating time increases, the crystallization temperature of the amorphous alloy will decrease.
该非晶合金出现晶化的温度随热处理时间的增长而降低。
The DSC results showed both the melting temperature and crystallization temperature of the grafting products were decreased.
DSC研究表明辐照接枝产物的熔融温度和结晶温度均降低。
With the steel line and the solid phase of the high and low liquidus temperature and crystallization temperature of the size of interval.
它们与钢的固相线和液相线温度的高低及结晶温度区间的大小有关。
The powder for higher crystallization temperature has stronger crystallization capability in annealing and lower devitrified temperature;
高结晶温度的保护渣具有较强的脱玻化能力，且脱玻化温度较低；
The influence of melting temperature, melting time, crystallization temperature and cooling mode on form and size of nylon 66 was studied.
研究了熔融温度、熔融时间、冷却方式及结晶温度对尼龙66球晶形态和大小的影响。
Solidus and liquidus temperatures of the rocks and relationship between crystallinity and crystallization temperature have been determined.
确定了岩石固相线与液相线的温度，岩石结晶程度与温度的关系。
As accelerator for PET, PBT could decrease the cooling crystallization temperature and increase the melt crystallization temperature of recycled PET.
PBT作为PET结晶促进剂，降低回收PET的冷结晶温度，提高热结晶温度。
Parameters effecting on dry fractionation of lard are crystallization temperature, cooling rate, crystal growing time, agitation rate, separating manner.
影响猪油干法分提参数有：结晶温度、冷却速率、养晶时间、搅拌速率及分离方式。
But compared to as-quenched samples, the glass transition temperature, crystallization temperature and crystallization peak temperature have same changes.
但与淬态试样相比，玻璃转变温度、晶化温度及晶化峰值温度存在一定的变化。
Based on crystallization mechanism, effective pour depressant should meet the requirements of carbon chain matching and crystallization temperature matching.
根据共晶机理，好的降凝剂应满足碳数相匹配、结晶温度相匹配要求。
The blending composition, temperature and time have a dramatic effect on the cold crystallization temperature (Tc) increases and the melting Tmperature (t m).
冷结晶温度和熔融温度与共混比例、共混时间、温度等因素密切有关。
The former is characterized by lower viscosity , lower crystallization temperature, lower softening and melting temperature, proper basicity and higher melting rate.
薄板坯连铸保护渣应具有较低的粘度，较低的结晶、软化及熔融温度，合适的碱度以及较快的熔化速度。
The results show that compared with the common semi-dull PET chip, the super bright PET has higher crystallization temperature, lower crystal enthalpy and crystallinity.
结果表明，和常规半消光PET切片相比，超有光聚酯切片冷结晶温度较高，结晶热焓较低，结晶度较小；
The Si—OH bond, impurity and phase interface are the important factors for the crystallization temperature of the quartz fiber to be lower than that of the quartz glass.
OH键、杂质以及界面等因素是石英纤维析晶温度低于石英玻璃的主要原因。
The regular variation of crystallization temperature, magnetic ordering temperature and average hyperfine magnetic field of the amorphous alloys with Nb content were observed.
观察到非晶合金的晶化温度，磁有序温度和平均磁超精细场有规律性的变化。
The thermal analysis was used to determine the crystallization temperature, the glass transformation temperature and low temperature relaxation temperature of the amorphous samples.
通过对非晶态样品的热分析，确定了它的晶化温度、玻璃转变温度和低温弛豫温度。
Te-free memory material with adjustable crystallization temperature, melting point and crystallization activation energy can be obtained by changing the ratio of the two compositions.
通过调整这种材料中两种元素的组份，可以得到具有不同结晶温度、熔点和结晶激活能的存储材料。
The results show that the carbon nanofiber can heighten the crystallization temperature of polypropylene and lower its crystallization rate and degree of crystallization in small extent.
结果表明：纳米碳纤维可提高PP的结晶温度，但略降低其结晶速率和结晶度。
The method overcomes the shortcoming of grain growing above the initial crystallization temperature in annealing method, successfully preparing nano-crystalline material of very small grain .
该方法避免了传统的退火法在晶化温度以上晶粒长大这一缺点，成功制备出晶粒极细小的纳米材料。
The best peak firing temperature was existed, which was between the softening temperature and the peak crystallization temperature, and near the incipient crystallization temperature of the glass.
电阻浆料存在最佳峰值烧成温度。理论分析表明，最佳峰值烧成温度应在软化点与峰值析晶温度之间，靠近起始析晶温度。
The study indicates that synthetic conditions such as crystallization temperature and time, the type and composition of organic templates, could effect on SAPO-11 molecular sieves synthesis greatly.
研究表明，合成条件，如晶化温度和时间、有机模板剂的类型和组成等，都对SAPO - 11分子筛的合成有很大影响。
With increasing melting temperature, the cold crystallization peak temperature increases, the crystallization peak strength of PEEK weakens and the peak width increases.
熔融温度升高时，聚醚醚酮的结晶峰强度减弱，峰宽增加；而冷结晶峰温度提高。
On the other hand, both the glass temperature and cold crystallization peak temperature of PEEK increases and melting peak strength decreases while the melting time becomes longer.
熔融时间延长时，聚醚醚酮的玻璃化转变温度和冷结晶峰温度均提高，熔融峰强度减弱。
On the other hand, both the glass temperature and cold crystallization peak temperature of PEEK increases and melting peak strength decreases while the melting time becomes longer.
熔融时间延长时，聚醚醚酮的玻璃化转变温度和冷结晶峰温度均提高，熔融峰强度减弱。
应用推荐