The test results showed that the wear resistance of tire tread improved and the compound cost reduced by changing the rubber type, filler system and curing system.
试验结果表明，通过调整生胶品种、补强体系和硫化体系等，可以改善胎面胶的耐磨性能，降低胶料成本。
The vulcanizing properties of CB filled IIR with sulfur curing system were researched.
研究了炭黑填充丁基橡胶硫黄硫化体系的硫化特性。
This article was about the application of uniform design method to study of CM peroxide curing system.
研究了均匀实验设计法在CM过氧化物硫化体系研究中的应用。
Experimental results showed formaldehyde emission values of the same UF resin in different curing system were various.
试验结果表明：固化体系不同，脲醛树脂的甲醛释放量有很大差别。
Free radical-cationic hybrid UV curing system is a important one in the hybrid polymerization system.
混杂光固化体系中比较重要的是自由基-阳离子混杂光固化体系。
The new formulation was constituted by comparing major material, testing of various curing system and anti-aging system.
通过主体材料的选择、硫化体系的配合试验及防老体系的优化确定了氯丁橡胶胶料配方。
The effect of the blowing agent and curing system on the curingblowing behavior and physical properties of NR/SBR foam was investigated.
探讨发泡剂和硫黄硫化体系对NR/SBR并用海绵胶硫化发泡特性和物理性能的影响。
As an important component of UV-curing system, the photoinitiators have significant effect on curing rate and film function of UV-curing.
光引发剂是紫外光固化涂料的关键组分，它对光固化涂料的光固化速度和固化膜的性能起主要作用。
UV curable powder paints, UV curable waterborne paints, hybrid UV curable paints, dual curing system, UV equipments and et al are described.
介绍了光固化粉末涂料、水性光固化涂料、混杂光固化体系、双重固化体系、光固化设备等。
The curing system of a middle-low temperature curable epoxy film adhesive SY-70 was determined by the choices of proper accelerator and its content.
通过选择合适的促进剂及其用量，确定了中低温固化环氧胶膜sy- 70的固化体系。
This article gives an integral introduction of intelligent steam curing system, and analyses in details its features and maintenance during operation.
本文通过对智能蒸养系统工艺的整体介绍，详细地分析了智能蒸养系统的特点及在工作中的维护。
As an important component of free radical UV-curing system, the types and consumptions of photoinitiators have significant effect on UV-curing behavior.
光引发剂是自由基型紫外光光固化反应体系的重要组成部分，光引发剂的种类和用量对体系的光固化行为有很大的影响。
The choice of this paper is the epoxy resin and polyethylene polyamine curing system, and glass fiber reinforced epoxy resin system as the damping materials.
本文选择的是环氧树脂和多乙烯多胺固化体系，以及玻璃纤维增强环氧树脂体系作为阻尼层材料。
The effects of factors such as curing system, blending ratio, the kinds and content of fillers on the mechanical properties of CR/CM vulcanizates were also studied.
实验结果表明：与噻二唑类硫化体系相比，硫脲类硫化体系硫化的橡胶具有较大的拉伸强度、撕裂强度和断裂伸长率。
The influence of processing oil, antioxidant, curing system, processing aids and coupling agent on the rolling resistance of rubber compound is also briefly described.
简要论述了操作油、防老化体系、硫化体系、操作助剂和偶联剂等的选择对胶料滚动阻力的影响。
Low viscosity resilient casting resin. Recommended for pre-filled silica formulations with low caking tendency used with amine curing system for low voltage cable joints.
低粘度弹力浇铸树脂，建议与先加入的硅微粉和胺类固化剂合用，用于低压电缆的连接。
The effects of blend ratio, curing system, reinforcement agents, soften agents and silane coupling agents on dynamic mechanical properties of IIR/CIIR blends were researched.
研究了共混比、硫化体系、增强剂、软化剂和硅烷偶联剂对IIR/CIIR共混胶动态力学性能的影响。
Two methods for determining the cure system and its proportion for pultrusion process were introduced in this paper. Meanwhile, a satisfied curing system and process were achieved.
介绍了两种确定拉挤成型固化体系及其比例的方法，并得出了优化的拉挤成型的固化系统方案。
The results showed that the effectiveness of conventional curing system or semi efficient curing system was much higher than that of efficient curing system or non sulfur curing system.
结果表明，采用普通硫化体系、半有效硫化体系的效果明显优于有效硫化体系及无硫黄硫化体系。
There is great difference in the performance among the different epoxy curing system, the kinds and the contents of the modified components have influence on the performance of the adhesive.
不同的环氧固化体系的性能存在较大差异，改性材料的种类和用量对结构胶的性能也存在不同程度的影响。
The vulcanization course of NR with traditional sulfur curing system was tracked in situ by FTIR and the effect of the new anti-reversion agent Z-500 on the vulcanization of NR was investigated.
利用傅立叶转换红外光谱法原位跟踪NR传统硫黄硫化体系的硫化过程，研究新型抗硫化返原剂z- 500对NR胶料硫化过程的影响。
The influences of surface treatments, the pressures during bonding process and the thickness of adhesive layer on shearing strength were investigated with epoxy resin-DDS curing system as adhesive.
采用环氧树脂-DDS固化体系作为胶接剂，探讨了各种金属表面处理方法、胶接时对胶接面施加的压力、胶层厚度等因素对胶接剪切强度的影响。
The effects of the accelerator NA-22 curing system and triazine-mercaptan(including curatives AF and TCY) curing system on the properties of epichlorohydrin binary copolymer(CHC) were investigated.
探讨促进剂NA 22硫化体系和三嗪硫醇（包括硫化剂AF和TCY）硫化体系对二元共聚氯醚橡胶（CHC）性能的影响。
The effects of the accelerator NA-22 curing system and triazine-mercaptan(including curatives AF and TCY) curing system on the properties of epichlorohydrin binary copolymer(CHC) were investigated.
探讨促进剂NA 22硫化体系和三嗪硫醇（包括硫化剂AF和TCY）硫化体系对二元共聚氯醚橡胶（CHC）性能的影响。
应用推荐