In the electroforming process, the anode electrode shape and position determine the current density distribution on the cathode and so the distribution and properties of the deposited metal.
电铸阳极的形状和位置决定了阴极表面电流密度的分布，并最终影响金属沉积层分布的均匀性及其材料性能。
Vacuum micro-electronics devices, which are based on field emission theory, are more and more widely applied, because of their low power consumption, high current density and high frequency.
以场致发射理论为基础的真空微电子器件，因其具有功耗低、电流密度大、频率高等诸多优点而倍受人们关注。
During the electroforming, the current density distribution on the cathode surface is decided by the anode profile and its position, which will influence the uniformity of the deposit finally.
在电铸过程中，电铸阳极的轮廓和位置决定了阴极表面电流密度的分布，并最终影响电铸层的均匀性。
降低电流密度。
Operating current density is too high.
操作电流密度过高。
The samples were annealed under different electrical current density.
样品在不同电流密度下进行了处理。
The overvoltage varies inversely with the current density to some extent.
超电压在某种程度上随电流密度成反比地变化。
Tunneling process is important in the low to moderate current density range.
在中等电流密度下，隧道穿透过程是重要的。
The employed current density has great effect on the leveling power of HITD.
使用电流密度对其整平能力有很大影响。
Analyzing the effects of current density and additives on tool-electrode wear.
对比分析了电流密度、添加剂对工具电极损耗的影响。
But it provides too small emission current density and gives a large gate current.
但不足之处是发射电流密度太小和有较大的栅极电流。
Modification with conductive materials to increase specific capacity at high current density.
导电性物质的修饰以提高其在大电流密度下的比容量。
The aggressiveness ofaerated solution accreted by increasing the limit diffusion current density of oxygen.
介质充气后氧的极限扩散电流密度增大，对材料的侵蚀性增强。
A superconductor's transition temperature and critical current density are two commonly measured parameters.
超导体的转变温度和临界电流密度是两个经常要测量的参数。
The relationships of current density with deposition rate, crystal size and hardness of deposit were studied.
研究了电流密度与沉积速度、晶粒尺寸及镀层硬度的关系。
Results show that the proportion of inward to outward growth varies with intensifying time and current density.
结果表明，微弧氧化陶瓷层向内与向外的生长比例受强化时间和电流密度综合控制。
The effects of pulse peak current density on the texture and hardness of electrodeposited Ni were investigated.
考察了脉冲峰值电流密度对纳米晶镍镀层织构和硬度的影响。
The damage size increases with increase of charging current density, but not so apparent at higher current density.
随电流密度增加，氢损伤尺寸增大，但当电流密度较大时，这种增大不明显。
Comparing and analyzing the effects of current density and additives on surface morphology of the electroforming deposit.
对比分析了电流密度和添加剂对电铸层表面形貌的影响。
Cathode production surpassed this design by 1997 through innovative process optimization and increasing the current density.
到1997年，通过工艺的革新优化，并提高电流密度，使阴极铜的产量超过了该设计能力。
The principle of gold imitated coloring, effects of electric current density and properties of coloring film were discussed.
探讨了该工艺的着色原理、电流密度的影响及所得着色膜层的性能。
The effects of electrode activation condition, current density, electrolyte temperature on electrolytic reduction are discussed.
讨论了电极活化条件、电流密度、电解液温度等因素对电解还原反应的影响。
To meet the needs of high electron current density photocathodes, the processes for preparing cesium antimonide have been studied.
为满足大电流密度电子发射的需要，对锑铯光电阴极的制备工艺进行了研究。
According to the principle of relativistic covariance, this paper presents the relativistic covariant equation of current density.
从相对论协变性原理出发，得到了电流密度方程满足相对论协变性的自洽展开式。
The influence of anode current density, polishing temperature, polishing time and stirring modes on polishing quality was discussed.
探讨了阳极电流密度、抛光温度、抛光时间和搅拌方式对抛光质量的影响。
A theoretical model used in calculating the reverse current density is proposed by considering several current transport mechanisms.
通过对反向电流各种输运机制的分析，提出了一种计算反向电流密度的理论模型。
This paper describes a mathematical model for the distribution of potential and current density on the plates of lead-acid batteries.
本文以起动型铅酸蓄电池为例，建立了电极表面电位、电流分布的数学模型。
This paper describes a mathematical model for the distribution of potential and current density on the plates of lead-acid batteries.
本文以起动型铅酸蓄电池为例，建立了电极表面电位、电流分布的数学模型。
应用推荐